925693-1

108-16001 Product Specification 11 Mar 11 Rev A Crimping Extruded Ring Terminals 1. SCOPE This specification covers the crimp requirements for extruded ring terminals. 2. CRIMP REQUIREMENTS 2.1. Figure 1 illustrates the various features defined in the following paragraphs. Figure 1 2.2. Tab on back end of terminals shall be .020 maximum. 2.3. Bellmouth at back of wire barrel shall be .005 to .030. 2.4. Wire shall lay flat and must extend through wire barrel with no more than 3/64 inch maximum overhang. 2.5. Crimp heights and crimp width of the wire barrel and crimp width of the insulation barrel are shown in the following table: Insulation Barrel Wire Barrel TE PN Wire Size 18 20 40894 Crimp Height ± .002 .056 .053 Crimp Width Crimp Width .110 “F” .140 “F” Table 1 ©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved TE logo is a trademark. | Indicates Change *Trademark For latest revision, visit out website at www.te.com/documents For Regional Customer service, visit our website at www.te.com Other products, logos, and company names might be trademarks of their respective owners. 1 of 1 LOC B