B-501-01

SPECIFICATION CONTROL DRAWING MATERIAL 1. INSULATION SLEEVE: Heat-shrinkable, radiation cross-linked modified polyvinylidene fluoride. Transparent blue. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Sn63 per ANSI J-STD-006. FLUX: TYPE ROL1 per ANSI J-STD-004. 3. TERMINATOR BODY: Tin plated copper alloy. APPLICATION 1. This controlled soldering device is designed to facilitate the strain relieved termination of a shielded twisted pair to a printed circuit board with 1mm diameter holes. It will terminate a tin or silver plated single or double braided cable having an insulation rated for at least +125°C. 2. Temperature range: -55°C to +150°C. 3. For installation procedure and application equipment consult RPIP-698-00. For best results, prepare the cable and the printed circuit board as shown: *A trademark of Raychem Corporation. THERMOFIT DEVICES Raychem Corporation 300 Constitution Drive Menlo Park, CA 94025 USA UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS. TOLERANCES: 0.00 N/A 0.0 N/A 0 N/A DRAWN BY: Raychem reserves the right to amend this drawing at any time. Users should evaluate the suitability of the product for ROUGHNESS IN their application. MICRON DATE: REV.: ANGLES: N/A A R. MAPALO 09/17/98 If this document is printed it becomes uncontrolled. Check with the web for latest revision. TITLE: KIT PINPAK* DEVICE DOCUMENT NO.: B-501-01 DCR NUMBER: REPLACES: D981684 DOC ISSUE: 1 SCALE: NONE B50101 SIZE: A SHEET: 1 of 1