CJ7763-000

SPECIFICATION CONTROL DRAWING TITLE 55PCL6021 Date ONE CONDUCTOR CABLE, FLAT BRAID SHIELDED, THIN WALL JACKETED, 600 VOLT Revision 06-23-04 This specification sheet forms a part of the latest issue of Raychem Specification 55PC. COMPONENT WIRES - 55PC7000 SHIELD - SILVER-COATED HIGH STRENGTH COPPER ALLOY JACKET - RADIATION-CROSSLINKED, MODIFIED ETFE CONSTRUCTION DETAILS PART NUMBER 1/ 55PCL6021-22-* 55PCL6021-20-* 55PCL6021-18-* 55PCL6021-16-* JACKET THICKNESS (in.) SHIELD CONDUCTOR STRAND SIZE THICKNESS LOWER SPEC (AWG) (± .0004 in.) LIMIT 22 20 18 16 .0015 .0015 .0015 .0015 .0035 .0035 .0035 .0035 TARGET WALL .0045 .0045 .0045 .0045 WEIGHT ( lbs/1000 ft.) DIAMETER ( in.) LOWER SPEC LIMIT .053 .063 .071 .080 TARGET VALUE UPPER SPEC LIMIT TARGET VALUE UPPER SPEC LIMIT .057 .066 .075 .083 .061 .069 .079 .086 4.28 5.96 8.43 10.43 4.59 6.32 8.92 10.95 CABLE RATINGS AND ADDITIONAL REQUIREMENTS TEMPERATURE RATING: 150°C SHIELD COVERAGE: 85% (minimum) Maximum continuous conductor temperature VOLTAGE WITHSTAND TEST (Post Environmental): VOLTAGE RATING: 600 volts (rms) at sea level 1000 volts (rms), 60 Hz, 1 minute CROSSLINK VERIFICATION: 300 ± 3°C for 1 hour DIELECTRIC WITHSTAND: 1500 volts (rms), 60 Hz JACKET COLOR: White preferred PART NUMBER: JACKET ELONGATION AND TENSILE STRENGTH: The "*" in the part numbers above shall be replaced by a color code Elongation, 50% (minimum) designator with a dash separating the component wire color from the Tensile Strength, 5000 lbf/in² (minimum) jacket color. JACKET FLAWS: 1/ Example: AWG 22, white component wire; white jacket: Spark Test, 1000 volts (rms) 55PCL6021-22-9-9 Impulse Dielectric Test, 6.0 kV (peak) Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: “901/902...” MAY BE REPLACED BY “Axxx”.) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER, AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. DIMENSIONS ARE IN INCHES AND, UNLESS OTHERWISE DESIGNATED, ARE NOMINAL Page 1 of 1 THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. R Wire & Cable 501 Oakside Avenue Redwood City, CA 94063-3800 Phone: 1-800-227-8816 Fax: 1-650-361-6297