RTE24024F

General Purpose Relays PCB Relays Potter & Brumfield Power PCB Relay RT2 n 2 pole 8A, 2 form C (CO) or 2 form A (NO) contacts coil 400mW n 5kV/10mm coil-contact, reinforced insulation n Ambient temperature 85°C n Sensitive Typical applications Boiler control, timers, garage door control, POS automation, interface modules VZb Approvals Coil Data VDE Cert. No. 40007571, UL E214025, cCSAus 1142018, CQC 18002197247 Technical data of approved types on request Contact Data Contact arrangement 2 form C (CO) or 2 form A (NO) Rated voltage 250VAC Max. switching voltage 400VAC Rated current 8A, UL: 10A Limiting continuous current 8A, UL: 10A Limiting making current, max. 4s, duty factor 10% 15A Breaking capacity max. 2000VA Contact material AgNi 90/10 Frequency of operation, with/without load 360/72000h-1 Operate/release time max., DC coil 8/6ms Bounce time max., DC coil, form A/form B 4/10ms Coil voltage range Operative range, IEC 61810 Coil insulation system according UL Coil versions, DC coil Coil Rated Operate code voltage voltage VDC VDC 005 5 3.5 006 6 4.2 009 9 6.3 012 12 8.4 024 24 16.8 048 48 33.6 5 to 110VDC 2 class F Release voltage VDC 0.5 0.6 0.9 1.2 2.4 4.8 Coil resistance Ω±10% 62 90 200 360 1440 5520 Rated coil power mW 403 400 400 400 400 417 All figures are given for coil without pre-energization, at ambient temperature +23°C. Other coil voltages on request. Contact ratings Type Contact Load Cycles IEC 61810 RT424 DC coil C (CO) 8A, 250VAC, cosφ=1, 85°C 10x103 RT444 AC coil A (NO) 8A, 250VAC, cosφ=1, 70°C 50x103 RT424 AC coil C (CO) 8A, 250VAC, cosφ=1, 70°C 30x103 UL 61810-1 (former UL 508) RT424 DC coil A/B (NO/NC) 10A, 250VAC, gen. purpose, 85°C 20x103 RT424 DC coil A/B (NO/NC) 1/2hp, 240VAC, 85°C 1x103 RT424 DC coil A/B (NO/NC) Pilot duty, B300, R300, 85°C 6x103 EN60947-5-1 RTE24 DC coil A/B (NO/NC) AC15, 250VAC, 3A 6.050 RTE24 DC coil A/B (NO/NC) DC13, 24VDC, 2A 6.050 RTE24 DC coil A/B (NO/NC) DC13, 250VDC, 0.2A 6.050 EN60730-1 RT424 DC coil A/B (NO/NC) 6(2)A, 250VAC, 85°C 100x103 Mechanical endurance 03-2022, Rev. 0322 www.te.com © 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. company >30x106 operations Datasheets and product specification according to IEC 61810-1 and to be used only together with the ‘Definitions’ section. Insulation Data Initial dielectric strength between open contacts between contact and coil between adjacent contacts Clearance/creepage between contact and coil between adjacent contacts Material group of insulation parts Tracking index of relay base Datasheets and product data is subject to the terms of the disclaimer and all chapters of the ‘Definitions’ section, available at http://relays.te.com/definitions 1000Vrms 5000Vrms 2500Vrms ≥10/10mm ≥ 3/4mm IIIa PTI 250V Datasheets, product data, ‘Definitions’ section, application notes and all specifications are subject to change. 1 General Purpose Relays PCB Relays Potter & Brumfield Power PCB Relay RT2 (Continued) Other Data Material compliance: EU RoHS/ELV, China RoHS, REACH, Halogen content refer to the Product Compliance Support Center at www.te.com/customersupport/rohssupportcenter Ambient temperature -40 to 85°C Category of environmental protection IEC 61810 RTII - flux proof, RTIII - wash tight Vibration resistance (functional), form A/form B contact, 30 to 300Hz 20g/5g Shock resistance (destructive) 100g Terminal type PCB-THT, plug-in Weight 13g Resistance to soldering heat THT, IEC 60068-2-20 RTII 270°C/10s RTIII 260°C/5s Packaging/unit tube/20pcs., box/500pcs. Accessories For details see datasheet Accessories Industrial Power Relay RT NOTE: indicated contact ratings and electrical endurance data for direct wiring of relays (according IEC 61810-1); for relays mounted on sockets deratings may apply. Dimensions PCB layout / terminal assignment Bottom view on solder pins S0418-CA S0272-BA *) With the recommended PCB hole sizes a grid pattern from 2.5​mm to 2.54​mm can be used. 2 form C (CO) contacts S0163-BJ 2 form A (NO) contacts S0163-BK 2 03-2022, Rev. 0322 www.te.com © 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. company Datasheets and product specification according to IEC 61810-1 and to be used only together with the ‘Definitions’ section. Datasheets and product data is subject to the terms of the disclaimer and all chapters of the ‘Definitions’ section, available at http://relays.te.com/definitions Datasheets, product data, ‘Definitions’ section, application notes and all specifications are subject to change. General Purpose Relays PCB Relays Potter & Brumfield Power PCB Relay RT2 (Continued) Product code structure Typical product code Type RT 4 2 4 024 F RT Power PCB Relay RT2 Version 4 8A, pinning 5mm, flux proof E 8A, pinning 5mm, wash tight Contact arrangement 2 2 form C (CO) contacts 4 2 form A (NO) contacts Contact material 4 AgNi 90/10 Coil Coil code: please refer to coil versions table Version F Standard version Product code Version Contacts Contact material RT424005F 8A, 2 form C (CO) AgNi 90/10 RT424012F pinning 5mm, contacts RT424024F flux proof RT444012F 2 form A (NO) RT444024F contacts RTE24005F 8A, 2 form C (CO) RTE24006F pinning 5mm, contacts RTE24009F wash tight RTE24012F RTE24024F RTE24048F RTE44012F 2 form A (NO) RTE44024F contacts This list represents the most common types and does not show all variants covered by this datasheet. Other types on request 03-2022, Rev. 0322 www.te.com © 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. company Datasheets and product specification according to IEC 61810-1 and to be used only together with the ‘Definitions’ section. Coil 5VDC 12VDC 24VDC 12VDC 24VDC 5VDC 6VDC 9VDC 12VDC 24VDC 48VDC 12VDC 24VDC Datasheets and product data is subject to the terms of the disclaimer and all chapters of the ‘Definitions’ section, available at http://relays.te.com/definitions Part number 1-1419108-6 2-1393237-8 1-1419108-7 1-1419108-9 2-1419108-0 4-1419108-0 6-1393227-5 3-1393237-0 3-1393237-1 3-1393237-3 3-1393237-4 4-1419108-2 3-1393237-5 Datasheets, product data, ‘Definitions’ section, application notes and all specifications are subject to change. 3