IBHC0358
Page 1 of 6
PART NO. IBHC0358
Chip Material InGaN Emitted Color Blue
Lens Color Water Clear
* Specifications subject to change without notice. Dimensions are in mm ±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph: 714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0901a
IBHC0358
Page 2 of 6
Absolute Maximum Ratings at Ta = 25 ˚C Parameter Forward Current Reverse Voltage Operating Temperature Storage Temperature Electrostatic Discharge Power Dissipation Peak Forward Current (Duty 1/10 @ 1KHz) Soldering Temperature Symbol IF VR Topr Tstg ESD Pd IFP Tsol Rating 25 5 -40 to +85 -40 to +90 150 110 100 Units mA V ˚C ˚C V mW mA
Reflow Soldering: 260°C for 10 sec. Hand Soldering: 350°C for 3 sec.
Electronic Optical Characteristics (Ta = 25 ˚C) Parameter Luminous Intensity Viewing Angle Peak Wavelength Dominant Wavelength Spectrum Radiation Bandwidth Forward Voltage Reverse Current Symbol IV 2θ1/2 λp λd Δλ VF IR Min. 45 — — 470 — 2.60 — Typ. — 60 468 — 25 — — Max. 90 — — 475 — 3.00 50 Units mcd deg nm nm nm V μA VR = 5 V IF = 5 mA Condition
Notes: 1. Tolerance of Luminous Intensity: ±11% 2. Tolerance of Dominant Wavelength: ±1 nm 3. Tolerance of Forward Voltage: ±0.05 V
* Specifications subject to change without notice. Dimensions are in mm ±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph: 714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0901a
IBHC0358
Page 3 of 6
Bin Range of Dominant Wavelength
Bin Min Max Unit Condition
Y
470
475
nm
IF = 5 mA
Bin Range of Luminous Intensity
Bin Min Max Unit Condition
P1 P2 Q1
45 57 72
57 72 90 mcd IF = 5 mA
Bin Range of Forward Voltage
Group Min Max Unit Condition
2.60 2.70 T 2.80 2.90
2.70 2.80 2.90 3.00 V IF = 5 mA
Notes: 1. Tolerance of Luminous Intensity: ±11% 2. Tolerance of Dominant Wavelength: ±1 nm 3. Tolerance of Forward Voltage: ±0.05 V
* Specifications subject to change without notice. Dimensions are in mm ±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph: 714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0901a
IBHC0358
Page 4 of 6
Typical Electro-Optical Characteristics Curves:
* Specifications subject to change without notice. Dimensions are in mm ±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph: 714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0901a
IBHC0358
Page 5 of 6
Reel Dimensions:
Carrier Tape Dimensions:
* Specifications subject to change without notice. Dimensions are in mm ±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph: 714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0901a
IBHC0358
Page 6 of 6
Precautions for Use 1. Over-current prevention: A series resistor must be used for protection against over-current. Since slight voltage shifts can cause large current changes and possibly damage the LED. 2. Storage: 2.1. Store the LEDs in the sealed moisture proof bag until ready to use. 2.2. The storage conditions should be below 30°C and 90% RH or less. 2.3. Unused portions of LEDs may be stored in moisture proof packages for up to 1 year if kept under 30°C and at no more than 60% RH. 2.4. If there is evidence of moisture absorption or if the LEDs have been stored for a long time, bake the LEDs at 60°C ± 5°C for 24 hours prior to using. 3. Reflow Soldering Conditions: 3.1. Pb-free solder temperature profile (see figure):
3.2. Reflow solder no more than two times and must include time interval for the board to cool. 3.3. When soldering, do not put stress on the LEDs during heating. 3.4. After soldering, do not warp the circuit board. 4. Hand Soldering: Use a low wattage soldering iron (below 25 watts) with a tip temperature no more than 350°C for 3 sec or less on one terminal. Wait at least two seconds before soldering the next terminal to avoid overheating the LED and damaging it. 5. Avoid reworking a soldered LED. It is best to simply replace it with a new part.
* Specifications subject to change without notice. Dimensions are in mm ±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph: 714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0901a
很抱歉,暂时无法提供与“IBHC0358”相匹配的价格&库存,您可以联系我们找货
免费人工找货