BGA715L7

Data Sheet, Rev.2.1, October 2009 BGA715L7 Silicon Germanium GPS Low Noise Amplifier Small Signal Discretes Edition 2009-10-9 Published by Infineon Technologies AG 81726 München, Germany © Infineon Technologies AG 2009. All Rights Reserved. Legal Disclaimer The information given in this document shall in no event be regarded as a guarantee of conditions or characteristics (“Beschaffenheitsgarantie”). With respect to any examples or hints given herein, any typical values stated herein and/or any information regarding the application of the device, Infineon Technologies hereby disclaims any and all warranties and liabilities of any kind, including without limitation warranties of non-infringement of intellectual property rights of any third party. Information For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies Office (www.infineon.com). Warnings Due to technical requirements components may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies Office. Infineon Technologies Components may only be used in life-support devices or systems with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered. BGA715L7 BGA715L7 Revision History: 2009-10-9, Rev.2.1 Previous Version: 2008-09-12, Rev.2.0 Page 5 Subjects (major changes since last revision) Ambient temperature range is extended down to -40°C Data Sheet 3 Rev.2.1, 2009-10-9 BGA715L7 Silicon Germanium GPS Low Noise Amplifier 1 Silicon Germanium GPS Low Noise Amplifier Features • High gain: 20 dB • Low Noise Figure: 0.7 dB • Low current consumption: 3.3 mA • Supply voltage: 1.5 V to 3.3 V • High input compression point -15.5 dBm at 1.8 V supply • High input 3rd intercept point -7 dBm at 1.8 V supply • B7HFM Silicon Germanium technology • RF output internally matched to 50 Ω • Low external part count • 2kV HBM ESD protection (including AI-pin) • Tiny TSLP-7-1 leadless package • Moisture sensitivity level: MSL 1 • Pb-free (RoHS compliant) package 6 5 4 7 1 2 3 TSLP-7-1 Application • 1575 MHz GPS, Galileo, GPS phone VCC PON BIAS AI BIAS AO ESD VSS GND Figure 1 Blockdiagram 2 Description The BGA715L7 is a front-end low noise amplifier for Global Positioning System (GPS) applications. The LNA provides 20 dB gain, 0.7 dB noise figure and high linearity performance in the application configuration described in Chapter 4. Current consumption is as low as 3.3 mA. The BGA715L7 is based upon Infineon Technologies‘ B7HFM Silicon Germanium technology. It operates over a 1.5 V to 3.3 V supply range. If an ultra low noise figure of 0.6 dB is required, please refer to Infineon BGA715L7 Application Note AN161. Data Sheet 4 Rev.2.1, 2009-10-9 BGA715L7 Description Type BGA715L7 Pin Definition and Function Table 1 Pin No. 1 2 3 4 5 6 7 Maximum Ratings Table 2 Parameter 1) Package TSLP-7-1 Marking UG Pin Definition and Function Symbol AI BIAS GND PON VCC AO VSS Function LNA input DC bias RF ground Power on control DC supply LNA output DC ground Maximum Ratings Symbol Value -0.3 ... 3.6 -0.3 ... 0.9 -0.3 ... 0.9 -0.3 ... VCC+ 0.3 -0.3 ... VCC+ 0.3 -0.3 ... 0.3 10 10 36 150 -40 ... 85 -65 ... 150 2000 100 Unit V V V V V V mA dBm mW °C °C °C V V VCC Voltage at pin AI VAI Voltage at pin BIAS VBIAS Voltage at pin AO VAO Voltage at pin PON VPON Voltage at pin GND VGND Current into pin VCC ICC RF input power PIN Total power dissipation Ptot Junction temperature TJ Ambient temperature range TA Storage temperature range TSTG 2) Human Body Model ESD capability, all pin to all pin VESD_HBM 3) Machine Model ESD capability, all pin to all pin VESD_MM Voltage at pin VCC 1) All voltages refer to VSS-Node. 2) According to JEDS22A-114 3) According to JEDS22A-115 Thermal resistance Table 3 Parameter 1) Thermal resistance Symbol Value Unit K/W Junction - soldering point RthJS 159 1) For calculation of RthJA please refer to Application Note Thermal Resistance Data Sheet 5 Rev.2.1, 2009-10-9 BGA715L7 Electrical Characteristics 3 Electrical Characteristics Electrical Characteristics1): TA = 25 °C, VCC = 1.8 V, VPON,ON = 1.8 V, VPON,OFF = 0 V, f = 1575 MHz Symbol Min. Values Typ. 1.8 3.3 0.2 5 1 20 0.7 14 13 43 5 5 -15.5 -7 >1 Max. 3.6 3 Vcc 0.4 V mA µA V V µA µA dB dB dB dB dB µs µs dBm dBm OFF- to ON-mode ON- to OFF-mode ON-mode OFF-mode ON-mode OFF-mode ON-mode OFF-mode High-gain Mode 1.5 1.0 0 2 Table 4 Parameter Unit Note / Test Condition Supply voltage Supply current Gain switch control voltage Gain switch control current Power gain Noise figure 2) VCC ICC Vpon Ipon |S21| - Input return loss Output return loss Reverse isolation Power gain settling time 3) NF RLin RLout 1/|S12|2 tS ZS = 50 Ω Inband input 1dB compression IP1dB point Inband input 3rd order intercept IIP3 point4) Stability k f1 = 1575 MHz f2 = f1 +/-1 MHz f = 20 MHz ... 20 GHz 1) Measured on BGA715L7 application board according to application schematic on page 7, including PCB losses (unless noted otherwise) 2) PCB tranmission line- and connector losses of 0.05dB are subtracted 3) To be within 1 dB of the final gain OFF- to ON-mode; to be within 3 dB of the final gain ON- to OFF-mode 4) Input Power = -30 dBm for each tone Data Sheet 6 Rev.2.1, 2009-10-9 BGA715L7 Application Information 4 Application Information Figure 2 Application Schematic BGA715L7 BGA715 L7_appboard .vsd Figure 3 Table 5 Name C1 C2 C4 L1 N1 Application Board Drawing BGA715L7 Bill of Materials Value 1.8 pF 1 µF 15 pF 4.7 nH LQW15A series BGA715L7 Package 0402 0402 0402 0402 TSLP-7-1 Manufacturer Various Various Various Murata Infineon Function DC blocking and input matching RF block RF block Bias feed and input matching SiGe LNA A list of all application notes is available at http://goto.infineon.com/smallsignaldiscretes-appnotes. Data Sheet 7 Rev.2.1, 2009-10-9 BGA715L7 Package Information 5 Package Information Top view 0.4 0.05 MAX. +0.1 Bottom view 1.3 ±0.05 1 ±0.05 4 5 6 1.7 ±0.05 6 x 0.2 ±0.035 1) 7 3 Pin 1 marking 2 1 6 x 0.2 ±0.035 1) TSLP-7-1-PO V04 1) Dimension applies to plated terminal Figure 4 Package Dimensions for TSLP-7-1 NSMD 0.2 0.2 0.2 SMD 1.4 1.4 1.4 0.2 0.2 1.9 0.25 1.4 0.2 0.25 2 ±0.05 1.2 ±0.035 1) 1.1 ±0.035 1) 0.2 1.9 1.9 0.2 0.25 1.9 0.2 0.2 0.2 0.2 0.3 0.3 Copper 0.3 0.25 Stencil apertures R0.1 0.3 0.3 Copper 0.3 0.2 0.25 0.25 0.25 Stencil apertures R0.1 Solder mask Solder mask TSLP-7-1-FP V01 Figure 5 Footprint TSLP-7-1 4 0.5 2.18 Pin 1 marking 1.45 TSLP-7-1-TP V03 Figure 6 Tape & Reel Dimensions (Ø reel 180, pieces/reel 7500) Data Sheet 8 8 Rev.2.1, 2009-10-9 0.2 0.25