CD4066

CD4066BMS December 1992 CMOS Quad Bilateral Switch Description CD4066BMS is a quad bilateral switch intended for the transmission or multiplexing of analog or digital signals. It is pin for pin compatible with CD4016B, but exhibits a much lower on state resistance. In addition, the on-state resistance is relatively constant over the full input signal range. The CD4066BMS consists of four independent bilateral switches. A single control signal is required per switch. Both the p and the n device in a given switch are biased on or off simultaneously by the control signal. As shown in Figure 1, the well of the n channel device on each switch is either tied to the input when the switch is on or to VSS when the switch is off. This configuration eliminates the variation of the switch transistor threshold voltage with input signal, and thus keeps the on-state resistance low over the full operating signal range. The advantages over single channel switches include peak input signal voltage swings equal to the full supply voltage, and more constant on-state impedance over the input signal range. For sample and hold applications, however, the CD4016B is recommended. The CD4066BMS is supplied in these 14-lead outline packages: Braze Seal DIP H4Q Frit Seal DIP H1B Ceramic Flatpack H3W Features • For Transmission or Multiplexing of Analog or Digital Signals • High Voltage Types (20V Rating) • 15V Digital or ±7.5V Peak-to-Peak Switching • 125Ω Typical On-State Resistance for 15V Operation • Switch On-State Resistance Matched to Within 5Ω Over 15V Signal Input Range • On-State Resistance Flat Over Full Peak-to-Peak Signal Range • High On/Off Output Voltage Ratio - 80dB Typ. at FIS = 10kHz, RL = 1kΩ • High Degree of Linearity: VOL < VDD/2 VDD/2 Switch Threshold RL = 100k to VDD N Threshold Voltage P Threshold Voltage SWTHRH5 VDD = 5V, VC = 1.5V, VIS = GND SWTHRH15 VDD = 15V, VC = 2V, VIS = GND VNTH VPTH VDD = 10V, ISS = -10µA VSS = 0V, IDD = 10µA 4.1 14.1 -2.8 0.7 -0.7 2.8 V V V V 7-967 Specifications CD4066BMS TABLE 1. DC ELECTRICAL PERFORMANCE CHARACTERISTICS GROUP A SUBGROUPS 1, 2, 3 1, 2, 3 LIMITS TEMPERATURE +25oC, +125oC, -55oC +25oC, +125oC, -55oC MIN MAX 1 2 UNITS V V PARAMETER Control Input Low Voltage (Note 2) |IIS| < 10µa, VIS = VSS, VOS = VDD and VIS = VDD, VOS = VSS Control Input High Voltage (Note 2, Figure 2) VIS = VSS and VIS = VDD SYMBOL VILC5 VILC15 CONDITIONS (NOTE 1) VDD = 5V VDD = 15V VIHC VDD = 5V, |IIS| = .51mA, 4.6V < VOS < 0.4V VDD = 5V, |IIS| = .36mA, 4.6V < VOS < 0.4V VDD = 5V, |IIS| = .64mA, 4.6V < VOS < 0.4V 1 2 3 1 2 3 +25oC +125oC -55oC +25oC +125oC -55oC 3.5 3.5 3.5 11 11 11 - V V V V V V VIHC VDD = 15V, |IIS| = 3.4mA, 13.5V < VOS