CHP2-100-1001-J-7-LF

Metal Glaze™ Cylindrical Surface Mount Power Resistors CHP Series • • • • • Up to 2 watts Up to 1000 volts 0.2 ohm to 2.2 megohm range RoHS-compliant version available 150°C maximum operating temperature Solder over nickel barrier Metal Glaze™ thick film element fired at 1000°C to solid ceramic substrate High temperature dielectric coating Electrical Data IRC Type Industry Footprint Size Code1 Maximum Power Rating Working Voltage² Maximum Voltage Resistance Range (ohms)³ 0.1 to 0.99 CHP 1/8 1206 B&C 1/4W @ 70°C 200 400 1.0 to 1.0 M 20 to 348K CHP 1/2 2010 D&E 1/2W @ 70°C 300 600 0.1 to 0.99 1.0 to 348K 0.1 to 0.99 CHP 1 2512 F 1W @ 70°C 350 700 1.0 to 2.21M 20 to 348K CHP 2 3610 H 2W @ 25°C 1.33W @ 70°C 0.2 to 0.99 500 1000 1.0 to 2.21M ²Not to exceed √P x R Product Category Low Range Standard Tight Tolerance Low Range Standard Low Range Standard Tight Tolerance Low Range Standard Tolerance (±%)³ 1, 2, 5 1, 2, 5 0.25, 0.5 1, 2, 5 1, 2, 5 1, 2, 5 1, 2, 5 0.25, 0.5 1, 2, 5 1, 2, 5 TCR (ppm/°C)³ 100 50, 100 50, 100 100 50, 100 100 50, 100 50, 100 100 50, 100 ¹See page 8 for product dimensions, recommended solder pads, and standard packaging. ³Consult factory for tighter TCR, tolerance, or resistance values. Environmental Data Characteristics Temperature Coefficient Thermal Shock Low Temperature Operation Short Time Overload High Temperature Exposure Resistance to Bonding Exposure Solderability Moisture Resistance Life Test Terminal Adhesion Strength Maximum Change As specified ±0.5% + 0.01 ohm ±0.25% + 0.01 ohm ±0.5% + 0.01 ohm ±1% for R>100K ohm ±0.5% + 0.01 ohm ±0.25% + 0.01 ohm 95% minimum coverage ±0.5% + 0.01 ohm ±0.5% + 0.01 ohm ±1% + 0.01 ohm no mechanical damage ±1% + 0.01 ohm no mechanical damage General Note IRC reserves the right to make changes in product specification without notice or liability. All information is subject to IRC’s own data and is considered accurate at time of going to print. A subsidiary of TT electronics plc CHP Series Issue July 2009 Sheet 1 of 3 Test Method MIL-R-55342E Par 4.7.9 (-55°C + 125°C) MIL-R-55342E Par 4.7.3 (-65°C + 150°C, 5 cycles) MIL-R-55342E Par 4.7.4 (-65°C @ working voltage) MIL-R-55342E Par 4.7.5 2.5 x √ for 5 seconds MIL-R-55342E Par 4.7.6 (-150°C for 100 hours) MIL-R-55342E Par 4.7.7 (Reflow soldered to board at 260°C for 10 seconds) MIL-STD-202, Method 208 (245°C for 5 seconds) MIL-R-55342E Par 4.7.8 (10 cycles, total 240 hours) MIL-R-55342E Par 4.7.10 (2000 hours at 70°C intermittent) 1200 gram push from underside of mounted cchip for 60 seconds Chip mounted in center of 90mm long board, deflected 1mm so as to exert pull on chip contacts for 5 seconds © IRC Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com Metal Glaze™ Cylindrical Surface Mount Power Resistors Physical Data L C W IRC Type CHP 1/8 MRC 1/2 CHP 1/2 MRC 1 CHP 1 CHP 2 Size Code B C D E F H Industry Footprint 1206 1206 2010 2010 2512 3610 Dimensions (Inches and (mm)) Actual Size L 0.128 ± 0.007 (3.25 ± 0.18) 0.128 ± 0.007 (3.25 ± 0.18) 0.200 ± 0.010 (5.08 ± 0.25) 0.200 ± 0.010 (5.08 ± 0.25) 0.251 ± 0.010 (6.38 ± 0.25) 0.367 ± 0.010 (9.32 ± 0.25) W 0.057 ± 0.006 (1.45 ± 0.15) 0.063 ± 0.010 (1.60 ± 0.25) 0.079 ± 0.006 (2.01 ± 0.15) 0.105 ± 0.006 (2.67 ± 0.15) 0.079 ± 0.006 (2.01 ± 0.15) 0.105 ± 0.006 (2.67 ± 0.15) C 0.020 ± 0.010 (0.51 ± 0.25) 0.020 ± 0.010 (0.51 ± 0.25) 0.030 ± 0.010 (0.761 ± 0.25) 0.040 ± 0.015 (1.02 ± 0.38) 0.040 ± 0.010 (1.02 ± 0.25) 0.050 ± 0.010 (1.27 ± 0.25) Recommended Solder Pad Dimensions (Reflow): F A C A B E D Size Code B&C D E F H Industry Footprint 1206 2010 2010 2512 3610 Dimensions (Inches and mm)) A 0.076 (1.93) 0.111 (2.82) 0.170 (4.32) 0.121 (3.07) 0.170 (4.32) B 0.093 (2.36) 0.126 (3.20) 0.160 (4.06) 0.126 (3.20) 0.160 (4.06) C 0.058 (1.47) 0.096 (2.44) 0.072 (1.83) 0.127 (3.23) 0.213 (5.41) D 0.098 (2.49) 0.152 (3.86) 0.132 (3.35) 0.183 (4.65) 0.273 (6.93) E 0.032 (0.81) 0.040 (1.02) 0.044 (1.12) 0.040 (1.02) 0.044 (1.12) F 0.211 (5.36) 0.318 (8.08) 0.412 (10.46) 0.369 (9.37) 0.553 (14.05) © IRC Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com CHP Series Issue July 2009 Sheet 2 of 3 Metal Glaze™ Cylindrical Surface Mount Power Resistors Standard Reel Packaging per EIA-481: IRC Type CHP 1/8 MRC 1/2 CHP 1/2 MRC 1 CHP 1 CHP 2 Size Code B C D E F H Industry Footprint 1206 2010 Reel Diameter* 7″ 13″ 7″ 13″ 7″ 2512 3610 13″ 13″ Quantity Per Reel 2,500 max. 10,000 max. 1,500 max. 5,000 max. 1,500 max. 12mm 5,000 max. 1,500 max. 24mm 4mm 4mm Carrier Tape Width 8mm 12mm Component Pitch 4mm 4mm *The 13″ reel is considered standard and will be supplied unless otherwise specified. Power Derating Curve 100 CHP 1/8, 1/2, 1 Repetitive Surge Curve 1000 CHP 2 CHP 1 100 % of Rated Power 80 60 CHP 2 40 20 0 Peak Power (watts) CHP 1/8 10 30 40 50 60 70 80 90 100 110 120 130 140 150 1 0.0001 .1msec Ambient Temperature (°C) 0.0010 1msec 0.0100 10msec 0.1000 100msec 1.0000 10000msec Surge or Pulse Duration (seconds) Note: Use for repetitive pulses where the average power dissipation is not to exceed the component rating at 70°C. Surge handling capacity for low-repetitive surges may be significantly greater than shown above. Contact factory for recommendations. Ordering Data Sample Part No. IRC Type (CHP 1/8, CHP 1/2, CHP 1, or CHP 2) CHP 1 - 100 2203 F 13 LF Temperature Coefficient (50 ppm, 100 ppm) Resistance Value (100 ohms and greater - First 3 significant digits plus 4th digit multiplier) Example: 100 ohms = 1000, 1000 ohms = 1001, 150,000 ohms = 1503 (Less than 100 ohms - "R" is used to designate decimal) Example: 51 ohms = 51R0, 1 ohm = 1R00, 0.25 ohms = R250 Tolerance (C = 0.25%, D = 0.5%, F = 1.0%; G = 2.0%; J = 5.0%) Packaging Code* (BLK = Bulk, 7 = 7" Reel, 13 = 13" Reel) Lead Free Construction © IRC Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com CHP Series Issue July 2009 Sheet 3 of 3