PSAW12I-10-B1

POWER PARTNERS: PSAW12I Features:  Interchangeable plugs for worldwide use  Class II configura on  Energy Efficiency Level VI  No load power consump on ≤100mW  Short circuit/over‐voltage/over‐current  No load opera on *Safety approvals may be model dependent. Consult TT Electronics for specifics or for additional safety approvals required. Descrip on: The PSAW12I series of AC/DC wall mount switching power supplies provide 7.5 ‐ 12 wa s of con nuous power. They are Class II input devices with interchangeable AC blades for worldwide use. All models meet FCC PART 15, EN55032, EN61000, and CISPR32 Class B emissions limits and comply with 62368, 61558, 60335, and 61347 standards. Load  Line  Regula on  Regula on  Ripple  & Noise  (P‐P)  Model  Voltage  Current  Total  Power  PSAW12I‐10‐B1 5VDC 1.50A 7.5W ±5% ±1% 200mV PSAW12I‐10A‐B1 5VDC 2.00A 10W ±5% ±1% 200mV PSAW12I‐11‐B1 9VDC 1.00A 10.8W ±5% ±1% 200mV PSAW12I‐12‐B1 12VDC 1.00A 12W ±5% ±1% 200mV PSAW12I‐13‐B1 15VDC 0.80A 12W ±5% ±1% 200mV PSAW12I‐14‐B1 24VDC 0.50A 12W ±5% ±1% 200mV Notes:   1. Ripple & Noise is measured by using a 20MHz bandwidth limited oscilloscope and terminated with a 0.1µF ceramic capacitor in parallel with a 47µF aluminum electroly c capacitor at full load and nominal line. 2. Line regula on is defined by changing input voltage ±10% from nominal line at rated load. 3. Shipped with USA AC Blades; others ordered separately. General Note All data sheets are subject to change without no ce. © TT Electronics plc TT Electronics h p://www. electronics.com/power‐supplies Rev 0 10 December 2021 Page: 1 POWER PARTNERS: PSAW12I Specifica ons: Input  Input Voltage 90 ‐ 264VAC Input Frequency 47 ‐ 63Hz Input Current ≤0.3A at 230VAC Inrush Current (Typical) ≤40A at 230VAC, cold start No Load Power Consump on ≤100mW; meets DOE Level VI requirements Safety Isola on 3000VAC input to output Output  Total Output Power See Table Output Voltage See Table Hold Up Time (Typical) ≥10mS at 115VAC/60Hz, full load ≥20mS at 230VAC/50Hz, full load Turn on Delay ≤3S Turn on Rise Time ≤20mS Minimum Load No minimum load requirement Line Regula on See Table Load Regula on See Table Average Efficiency ≥82.96% at nominal input Protec on Features  Over‐voltage (Typical) 150%. Latching mode. Cycle power to reset. Over‐current 120 ‐ 200%. Auto‐recovery. Short Circuit Hiccup mode. Auto‐recovery. Environmental  Opera ng Temperature 0° ‐ +60°C (See Dera ng Curve) Storage Temperature ‐ Opera ng Humidity 10 ‐ 90% non‐condensing Al tude 50,000 hours per MIL‐HDBK‐217F at full load and 25°C ambient AC Input Connector Interchangeable plugs for worldwide use DC Output Connector Barrel Type Safety  IEC62368 CE, UL, CB, KC, SAA, GS, PSB, EAC, UKCA IEC61558 CE, GS, PSE, SAA, CB, CCC, EAC IEC60335 CE, GS, SAA IEC61347 CE, SAA, CCC Approvals* *Safety approvals may be model dependent. Consult TT Electronics for specifics or for additional safety approvals required. EMC  Conducted Emission Radiated Emission Harmonic Currents Voltage Flicker EN55032:2015 + AC:2016, FCC PART 15, Class B EN55032:2015 + AC:2016, FCC PART 15, Class B EN61000‐3‐2 EN61000‐3‐3:2013 Electrosta c Discharge Radiated Immunity EFT/Burst Surge Immunity Conducted Immunity Power Frequency Magne c Field Immunity Dips/Interrup ons IEC61000‐4‐2:2008 (±8kV air, ±4kV contact) IEC61000‐4‐3:2006+A1:2007+A2:2010 (3V/m) IEC61000‐4‐4:2012 (±1kV) IEC61000‐4‐5:2014/AMD1:2017 (1kV diff) IEC61000‐4‐6:2013 (3Vrms) IEC61000‐4‐8:2009 IEC61000‐4‐11:2004 General Note All data sheets are subject to change without no ce. © TT Electronics plc TT Electronics h p://www. electronics.com/power‐supplies Rev 0 10 December 2021 Page: 3 POWER PARTNERS: PSAW12I Mechanical Outline: Dera ng Curves: General Note All data sheets are subject to change without no ce. © TT Electronics plc TT Electronics h p://www. electronics.com/power‐supplies Rev 0 10 December 2021 Page: 4