8TQ100S

Bulletin PD-21041 rev. B 06/06 8TQ...SPbF SCHOTTKY RECTIFIER 8 Amp IF(AV) = 8 Amp VR = 80 - 100V Major Ratings and Characteristics Characteristics IF(AV) Rectangular waveform VRRM range IFSM @ tp = 5 μs sine VF TJ @ 8 Apk, TJ = 125°C range Description/ Features Units A V A V °C The 8TQ .. Schottky rectifier series has been optimized for low reverse leakage at high temperature. The proprietary barrier technology allows for reliable operation up to 175° C junction temperature. Typical applications are in switching power supplies, converters, free-wheeling diodes, and reverse battery protection. High purity, high temperature epoxy encapsulation for enhanced mechanical strength and moisture resistance Low forward voltage drop High frequency operation Guard ring for enhanced ruggedness and long term reliability Lead-Free ("PbF" suffix) 175° C TJ operation Values 8 80 - 100 850 0.58 - 55 to 175 Case Styles Base Cathode 2 1 3 N/C Anode D2PAK www.irf.com 1 8TQ...SPbF Series Bulletin PD-21041 rev. B 06/06 Voltage Ratings Part number VR Max. DC Reverse Voltage (V) 80 100 VRWM Max. Working Peak Reverse Voltage (V) 8TQ080SPbF 8TQ100SPbF Absolute Maximum Ratings Parameters IF(AV) Max. Average Forward Current * See Fig. 5 IFSM EAS IAR Max. Peak One Cycle Non-Repetitive Surge Current * See Fig. 7 Non-Repetitive Avalanche Energy Repetitive Avalanche Current 8TQ 8 850 230 7.50 0.50 Units A Conditions 50% duty cycle @ TC = 157° C, rectangular wave form 5μs Sine or 3μs Rect. pulse Following any rated load condition and 10ms Sine or 6ms Rect. pulse with rated V RRM applied A mJ A TJ = 25 °C, IAS = 0.50 Amps, L = 60 mH Current decaying linearly to zero in 1 μsec Frequency limited by TJ max. VA = 1.5 x VR typical Electrical Specifications Parameters VFM Max. Forward Voltage Drop * See Fig. 1 (1) 8TQ 0.72 0.88 0.58 0.69 Units V V V V mA mA pF nH V/ μs @ 8A @ 16A @ 8A @ 16A TJ = 25 °C TJ = 125 °C Conditions TJ = 25 °C TJ = 125 °C VR = rated V R IRM CT LS Max. Reverse Leakage Current (1) * See Fig. 2 Max. Junction Capacitance Typical Series Inductance 0.55 7 500 8 10000 VR = 5VDC (test signal range 100Khz to 1Mhz) 25 °C Measured lead to lead 5mm from package body dv/dt Max. Voltage Rate of Change (Rated VR) (1) Pulse Width < 300μs, Duty Cycle < 2% Thermal-Mechanical Specifications Parameters TJ Tstg Max. Junction Temperature Range Max. Storage Temperature Range 8TQ -55 to 175 -55 to 175 2.0 0.50 2 (0.07) Min. Max. 6 (5) 12 (10) Units °C °C °C/W °C/W g (oz.) Kg-cm (Ibf-in) DC operation Conditions RthJC Max. Thermal Resistance Junction to Case RthCS Typical Thermal Resistance, Case to Heatsink wt T Approximate Weight Mounting Torque Marking Device * See Fig. 4 Mounting surface , smooth and greased 8TQ...S Case style D2Pak 2 www.irf.com 8TQ...SPbF Series Bulletin PD-21041 rev. B 06/06 1000 100 10 1 0.1 0.01 0.001 0.0001 T = 175°C J 150°C 125°C 100°C 75°C 50°C 25°C 100 Ins tantaneousForward Current - I F (A) R everse Current - I R (mA) 0 20 40 60 80 100 10 TJ= 175°C TJ= 125°C TJ= 25°C Revers Voltage - VR (V) e Fig. 2 - Typical Values of Reverse Current Vs. Reverse Voltage 1000 Junction Capacitance - C T (pF) 1 T = 25°C J 0.1 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2 2.2 100 0 10 20 30 40 50 60 70 80 90 100110 Reverse Volta ge - VR (V) Forward Voltage Drop - VFM (V) Fig. 1 - Maximum Forward Voltage Drop Characteristics Fig. 3 - Typical Junction Capacitance Vs. Reverse Voltage 10 Thermal Impedance Z thJC (°C/W) D = 0.75 D = 0.50 D = 0.33 1 D = 0.25 D = 0.20 Single Pulse (Thermal Resistance) 0.1 1E-04 1E-03 1E-02 1E-01 1E+00 t1 , Rectangular Pulse Duration (Seconds) Fig. 4 - Maximum Thermal Impedance ZthJC Characteristics www.irf.com 3 8TQ...SPbF Series Bulletin PD-21041 rev. B 06/06 180 Allowable Case Temperature - (°C) 7 Average Power Loss - (Watts) 6 5 4 RMSLimit 3 2 1 0 DC D = 0.20 D = 0.25 D = 0.33 D = 0.50 D = 0.75 175 170 165 160 155 150 145 see note (2) DC S quare wave (D = 0.50) 80% Rated V R applied 140 0 2 4 6 8 10 12 0 2 4 6 8 10 12 (A) Average Forward Current - I F(AV) (A) Average Forward Current - I F(AV) Fig. 5 - Maximum Allowable Case Temperature Vs. Average Forward Current 1000 Non-Repetitive Surge Current - I FS (A) M Fig. 6 - Forward Power Loss Characteristics At Any R ated Load Condition And With R ated V RR Applied M Following S urge 100 10 100 1000 10000 S quare Wave Pulse Duration - t p (microsec) Fig. 7 - Maximum Non-Repetitive Surge Current L HIGH-S PEED S CH WIT F REE-WHEEL DIODE 40HF 40S L 02 + DUT IR P460 F R = 25 ohm g Vd = 25 Volt CURRENT MONIT OR Fig. 8 - Unclamped Inductive Test Circuit (2) Formula used: TC = TJ - (Pd + PdREV) x RthJC ; Pd = Forward Power Loss = IF(AV) x VFM @ (IF(AV) / D) (see Fig. 6); Pd REV = Inverse Power Loss = VR1 x I R (1 - D); IR @ VR1 = 80% rated VR 4 www.irf.com 8TQ...SPbF Series Bulletin PD-21041 rev. B 06/06 Outline Table Conform to JEDEC outline D2Pak (SMD-220) Dimensions in millimeters and (inches) Part Marking Information THIS IS A 8TQ100S LOT CODE 8024 ASSEMBLED ON WW 02, 2000 INTERNATIONAL RECTIFIER LOGO ASSEMBLY LOT CODE PART NUMBER 8TQ100S DATE CODE YEAR 0 = 2000 WEEK 02 P = LEAD-FREE www.irf.com 5 8TQ...SPbF Series Bulletin PD-21041 rev. B 06/06 Tape & Reel Information Dimensions in millimeters and (inches) Ordering Information Table Device Code 8 1 T 2 Q 100 3 4 S 5 TRL PbF 6 7 1 2 3 3 4 5 6 - Current Rating (8A) Circuit Configuration T = TO-220 Schottky "Q" Series Voltage Ratings S = D2Pak none = Tube (50 pieces) TRL = Tape & Reel (Left Oriented) TRR = Tape & Reel (Right Oriented) 080 = 80V 100 = 100V 7 - none = Standard Production PbF = Lead-Free 6 www.irf.com 8TQ...SPbF Series Bulletin PD-21041 rev. B 06/06 8TQ100 ******************************************** * This model has been developed by * * Wizard SPICE MODEL GENERATOR (1999) * * (International Rectifier Corporation) * * Contain Proprietary Information * ******************************************** * SPICE Model Diode is composed by a * * simple diode plus paralled VCG2T * ******************************************** .SUBCKT 8TQ100 ANO CAT D1 ANO 1 DMOD (0.07089) *Define diode model .MODEL DMOD D(IS=1.15938021883115E-03A,N=1.95244918720315,BV=120V, + IBV=5.37891460505463A,RS= 0.00127602,CJO=9.9895753025115E-09, + VJ=2.30070034831946,XTI=2, EG=0.758916909331649) ******************************************** *Implementation of VCG2T VX 1 2 DC 0V R1 2 CAT TRES 1E-6 .MODEL TRES RES(R=1,TC1=-90.2420977904848) GP1 ANO CAT VALUE={-ABS(I(VX))*(EXP((((1.635248E-02/-90.2421)*((V(2,CAT)*1E6)/(I(VX)+1E-6)1))+1)*4.011038E-03*ABS(V(ANO,CAT)))-1)} ******************************************** .ENDS 8TQ100 Thermal Model Subcircuit .SUBCKT 8TQ100 5 1 CTHERM1 CTHERM2 CTHERM3 CTHERM4 RTHERM1 RTHERM2 RTHERM1 RTHERM1 5 4 3 2 5 4 3 2 4 3 2 1 4 3 2 1 1.45E+00 4.54E+00 1.09E+01 1.01E+02 2.49E+00 5.20E-04 5.43E-01 3.05E-02 .ENDS 8TQ100 Data and specifications subject to change without notice. This product has been designed and qualified for Industrial Level and Lead-Free. Qualification Standards can be found on IR's Web site. IR WORLD HEADQUARTERS: 2 33 Kansas St., El Segundo, California 90245, USA Tel: (310) 252-7105 TAC Fax: (310) 252-7309 Visit us at www.irf.com for sales contact information. 06/06 www.irf.com 7