CP2600SB

JIEJIE MICROELECTRONICS CO. , Ltd CPxxxxSB Series TSS Rev.4.1   DESCRIPTION:  CPxxxxSB series thyristors are a type of semiconduct component. They are designed to protect baseband equipment from damaging overvoltage transients. Such as modems, telephones, line cards, answering machines, FAX machines, T1/E1, xDSL and more.   SMB    FEATURES:  Lower capacitance.  Low profile package.  Low on-state voltage.  Excellent capability of absorbing transient surge.  Quick response to surge voltage (ns Level).  Eliminates overvoltage caused by fast rising transients.  Moisture sensitivity level: Level 1.  Non degenerative. Symbol ABSOLUTE MAXIMUM RATINGS (TA=25℃, RH=45%-75%, unless otherwise noted)  Parameter Symbol Value Unit TSTG -60 to +150 ℃ Operating junction temperature range TJ -40 to +125 ℃ Repetitive peak pulse current IPP 80 A Storage temperature range   ELECTRICAL CHARACTERISTICS (TA=25℃) Symbol Parameter VDRM Peak off-state voltage IDRM  Off-state current VS Switching voltage IS  Switching current VT  On-state voltage IT  On-state current IH  Holding current CO Off-state capacitance TEL：+86-513-83639777 -1 / 5- http://www.jjwdz.com CPxxxxSB Series JieJie Microelectronics CO. , Ltd MARKING  1409 CP-8B: Device Marking Code 1409: In ninth week, 2014 CP-8B     ELECTRICAL CHARACTERISTICS (TA=25℃, continued) VS①@IS IDRM@VDRM Part Number μA V max VT@ IT IH CO② V mA V A mA pF max max max max min max Marking CP0080SB 1 6 15 800 4 2.2 30 50 CP-8B CP0220SB 1  18 30 800 4 2.2 30 50 CP22B CP0300SB 1  25 40 800 4 2.2 30 50 CP03B CP0640SB 1  58 77 800 4 2.2 120 40 CP06B CP0720SB 1  66 87 800 4 2.2 120 40 CP07B CP0900SB 1  75 98 800 4 2.2 120 40 CP09B CP1100SB 1  90 130 800 4 2.2 120 35 CP11B CP1300SB 1  120 160 800 4 2.2 120 35 CP13B CP1500SB 1  140 180 800 4 2.2 120 35 CP15B CP1800SB 1  170 220 800 4 2.2 120 35 CP18B CP2300SB 1  190 260 800 4 2.2 120 30 CP23B CP2600SB 1  220 300 800 4 2.2 120 30 CP26B CP3100SB 1  275 350 800 4 2.2 120 25 CP31B CP3500SB 1  320 400 800 4 2.2 120 25 CP35B CP3800SB 1  340 450 800 4 2.2 120 25 CP38B  ① Vs is measured at 100KV/s ② Off-state capacitance is measured in VDC=2V, VRMS=1V, f=1MHz TEL：+86-513-83639777 -2 / 5- http://www.jjwdz.com CPxxxxSB Series JieJie Microelectronics CO. , Ltd SURGE RATINGS  IPP (A) min Series B 2×10μs 8×20μs 10×360μs 10×1000μs 250 250 125 80   ORDERING INFORMATION      SOLDERING PARAMETERS  Pb-Free assembly (see FIG.2) Reflow Condition Pre Heat -Temperature Min (Ts(min)) +150℃ -Temperature Max(Ts(max)) +200℃ -Time (Min to Max) (ts) 60-180 secs. Average ramp up rate (Liquidus Temp(TL)to peak) 3℃/sec. Max Ts(max) to TL - Ramp-up Rate 3℃/sec. Max Reflow -Temperature(TL)(Liquidus) +217℃ -Temperature(tL) 60-150 secs. Peak Temp (Tp) +260(+0/-5)℃ Time within 5℃of actual Peak Temp (tp) 30secs. Max Ramp-down Rate 6℃/sec. Max Time 25℃ to Peak Temp (TP) 8 min. Max Do not exceed +260℃ TEL：+86-513-83639777 -3 / 5- http://www.jjwdz.com CPxxxxSB Series JieJie Microelectronics CO. , Ltd FIG.1: tr × td pulse waveform FIG.2: Reflow condition %IPP tp tr = rise time to peak value td = decay time to half value 100 TP Critical Zone TL to TP Ramp-up Peak value TL tL Temperature TS(max) Half value 50 t(μs) 0 0 tr Ramp-down Preheat TS(min) ts 25 td FIG.3: Normalized Vs change vs. junction temperature time to peak temperatue (t 25℃ to peak) Time   FIG.4: Normalized DC holding current vs. case temperature Percent of Vs change(%) 2.0 12 IH (Tj )/IH(T j =25 ℃ ) 1.8 1.6 8 1.4 4 1.2 25℃ 25℃ 1.0 0 0.8 -4 0.6 -8 -40 -20 0 20 T j (℃ ) 40 60 80 100 120 140 0.4 -40 -20 0 20 T C (℃ ) 40 60 80 100 120 140   PACKAGE MECHANICAL DATA  B Dim ensions H F A C Ref. D K J L J G E M illim eters M in. M ax. A 3.30 B M in. M ax. 3.94 0.130 0.155 4.30 4.80 0.169 0.189 C 1.90 2.20 0.075 0.087 D 0.95 1.52 0.037 0.060 E 5.20 5.60 0.205 0.220 F 0.051 0.203 0.002 0.008 G 0.15 0.31 0.006 0.012 H 2.10 2.40 0.083 0.094 J 2.20 L 0.087 2.60 K DO -214AA (SM B) Inches 2.30 0.102 0.091   TEL：+86-513-83639777 -4 / 5- http://www.jjwdz.com   CPxxxxSB Series JieJie Microelectronics CO. , Ltd TAPE AND REEL SPECIFICATION‐SMB  P0 P2 Ref. Cathode B0 W F E D0 A0 P1     Dimensions Millimeters Inches A0 3.76 ± 0.3 0.148 ± 0.012 B0 5.69± 0.3 0.224 ± 0.012 C 330.0 13.0 D0 1.55 ± 0.1 0.061 ± 0.004 E 1.75 ± 0.2 0.069 ± 0.008 E1 13.3 ± 0.3 0.524± 0.012 0.217 ± 0.008 F 5.5 ± 0.2 P0 4.00 ± 0.2 0.157 ± 0.008 P1 8.00 ± 0.2 0.3145 ± 0.008 P2 2.00 ± 0.2 0.079 ± 0.008 W 12.0± 0.2 0.472 ± 0.008 W1 15.7 ± 2.0 0.618 ± 0.079   OUTLINE UNIT WEIGHT (g/PCS) typ. REEL (PCS) PER CARTON (PCS) REEL DIAMETERS (mm) TAPING 0.098 3,000 48,000 330 Information furnished in this document is believed to be accurate and reliable. However, Jiangsu JieJie Microelectronics Co.,Ltd assumes no responsibility for the consequences of use without consideration for such information nor use beyond it.Information mentioned in this document is subject to change without notice, apart from that when an agreement is signed, Jiangsu JieJie complies with the agreement. Products and information provided in this document have no infringement of patents. Jiangsu JieJie assumes no responsibility for any infringement of other rights of third parties which may result from the use of such products and information. This document is the 4.1st version which is made in 11-Aug.-2017. This document supersedes and replaces all information previously supplied. is a registered trademark of Jiangsu JieJie Microelectronics Co.,Ltd. Copyright©2017 Jiangsu JieJie Microelectronics Co.,Ltd. Printed All rights reserved. TEL：+86-513-83639777 -5 / 5- http://www.jjwdz.com