C0201C104K9PAC

Product Bulletin Surface Mount Ceramic Chip Capacitors – C0201 Series - X5R Dielectric Outline Drawing W T S ELECTRODES L B NICKEL PLATE CONDUCTIVE METALLIZATION TIN PLATE Dimensions – Millimeters (Inches) EIA Size Metric Size Code Code 0201 0603 L L ength 0.6 (.024) ± 0.03 (.001) W Width 0.3 (.012) ± 0.03 (.001) B Bandwidth 0.15 (.006) ± 0.05 (.002) S Separation - See Capacitance Value Table below for thickness dimension. Capacitance Value Capacitance Value (uF) 0.01 0.10 KEMET Part Number C0201C103K4PAC C0201C104K9PAC Voltage 16 6.3 Capacitance Tolerance K,M K,M Thickness 0.3 (.012) ± 0.03 (.001) 0.3 (.012) ± 0.03 (.001) Qty 7" Reel 15,000 15,000 Capacitor Ordering Information C 0201 Style C - Ceramic Size Code See dimension table Specification C - Standard C 104 K 9 P A C End Metallization C = Standard (Tin-plate nickel barrier) Failure Rate Level A = Not Applicable Capacitance Code, pF First two digits represent significant figures. Third digit specifies number of zeros. 100 pF = 101. (Use “9” for 1.0 through 9.9 pF) (Use “8” for 0.1 through .99 pF) Capacitance Tolerance K = ± 10% M = ± 20% Temperature Characteristic Designated by Capacitance Change Over Temperature Range P = X5R (±15%) (-55°C +85°C) Voltage 9 = 6.3V 4 = 16V F-9078C 08/06 Electrical Parameters As detailed in the KEMET Surface Mount Catalog F3102 for X5R, with following specific requirements based on room temperature (25°C) parameters: • Operating Range: -55°C to +85°C, with no-bias capacitance shift limited to ± 15% over that range. • Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 500 megohm microfarads or 10000MΩ, whichever of the two is smaller. • Capacitance and Dissipation Factor (DF) measured at 1 kHz and 1 Vrms. DF Limit is 10% max.** ** Please refer to individual specifications. Soldering Process These components are suitable for reflow only. All parts incorporate the standard KEMET barrier layer of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resistance to leaching. Marking These chips will be supplied unmarked. In general, the information in the KEMET Surface Mount catalog F3102 applies to these capacitors. The information in this bulletin supplements that in the catalog. F-9078C 08/06 © KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com