AA3020SYC

3.0x2.0mm SURFACE MOUNT LED LAMP AA3020SYC SUPER BRIGHT YELLOW Features 3.0MM X 2.0MM, 1.4MM HIGH, ONLY MINIMUM SPACE REQUIRED. SUITABLE FOR COMPACT OPTOELECTRONIC APPLICATIONS. LOW POWER CONSUMPTION. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Description The Super Bright Yellow device is made with DH InGaAlP (on GaAs substrate) light emitting diode chip. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAD1218 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: Y.W.WANG PAGE: 1 OF 4 ERP:1201000147 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 20mA Min. AA3020SYC SUPER BRIGHT YELLOW (InGaAIP) WATER CLEAR 50 Typ. 120 Viewing Angle 2θ1/2 90° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Super Bright Yellow Super Bright Yellow Super Bright Yellow Super Bright Yellow Super Bright Yellow Super Bright Yellow Typ. 590 588 28 25 2.0 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating/Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Super Bright Yellow 125 30 150 5 -40°C To +85°C Units mW mA mA V SPEC NO: DSAD1218 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: Y.W.WANG PAGE: 2 OF 4 ERP:1201000147 Super Bright Yellow AA3020SYC SPEC NO: DSAD1218 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: Y.W.WANG PAGE: 3 OF 4 ERP:1201000147 AA3020SYC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1218 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/05/2005 DRAWN: Y.W.WANG PAGE: 4 OF 4 ERP:1201000147