ACSA08-51SEKWA

SURFACE MOUNT DISPLAY PRELIMINARY SPEC Part Number: ACSA08-51SEKWA Super Bright Orange Features 0.8INCH DIGIT HEIGHT. LOW CURRENT OPERATION. EXCELLENT CHARACTER APPEARANCE. I.C. COMPATIBLE MECHANICALLY RUGGED. GRAY FACE,WHITE SEGMENT. PACKAGE: 200PCS/ REEL MOISTURE SENSITIVITY LEVEL : LEVEL 4. RoHS COMPLIANT. Description The Super Bright Orange device is made with InGaAlP (on GaAs substrate) light emitting diode chip. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. 3. The gap between the reflector and PCB shall not exceed 0.25mm. SPEC NO: DSAG8875 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 1 OF 5 ERP: 1351000564 Selection Guide Part No. Dice Lens Type Iv (ucd) [1] @ 10mA Min. ACSA08-51SEKWA Super Bright Orange (InGaAlP) WHITE DIFFUSED 18000 Typ. 80000 Common Anode, Rt. Hand Decimal. Description Note: 1. Luminous intensity/ luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD [1] Δλ1/2 C VF [2] IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Super Bright Orange Super Bright Orange Super Bright Orange Super Bright Orange Super Bright Orange Super Bright Orange Typ. 610 601 29 15 2.1 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR=5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Super Bright Orange 75 30 195 5 -40°C To +85°C Units mW mA mA V SPEC NO: DSAG8875 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 2 OF 5 ERP: 1351000564 Super Bright Orange ACSA08-51SEKWA SPEC NO: DSAG8875 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 3 OF 5 ERP: 1351000564 ACSA08-51SEKWA Recommended Soldering Pattern (Units : mm; Tolerance: ± 0.15) Reel Dimension Tape Specifications (Units : mm) SPEC NO: DSAG8875 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 4 OF 5 ERP: 1351000564 PACKING & LABEL SPECIFICATIONS ACSA08-51SEKWA SPEC NO: DSAG8875 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 5 OF 5 ERP: 1351000564