ACSA08-51SURKWA

SURFACE MOUNT DISPLAY PRELIMINARY SPEC Part Number: ACSA08-51SURKWA Hyper Red Features 0.8INCH DIGIT HEIGHT. LOW CURRENT OPERATION. EXCELLENT CHARACTER APPEARANCE. I.C. COMPATIBLE MECHANICALLY RUGGED. GRAY FACE,WHITE SEGMENT. PACKAGE: 200PCS/ REEL MOISTURE SENSITIVITY LEVEL : LEVEL 4. RoHS COMPLIANT. Description The Hyper Red source color devices are made with DH InGaAlP on GaAs substrate Light Emitting Diode. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. 3. The gap between the reflector and PCB shall not exceed 0.25mm. SPEC NO: DSAG8876 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 1 OF 5 ERP: 1351000558 Selection Guide Part No. Dice Lens Type Iv (ucd) [1] @ 10mA Min. ACSA08-51SURKWA Hyper Red (InGaAlP) WHITE DIFFUSED 18000 Typ. 61000 Common Anode, Rt. Hand Decimal. Description Note: 1. Luminous intensity/ luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD [1] Δλ1/2 C VF [2] IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Hyper Red Hyper Red Hyper Red Hyper Red Hyper Red Hyper Red Typ. 650 635 28 35 1.95 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR=5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Hyper Red 75 30 185 5 -40°C To +85°C Units mW mA mA V SPEC NO: DSAG8876 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 2 OF 5 ERP: 1351000558 Hyper Red ACSA08-51SURKWA SPEC NO: DSAG8876 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 3 OF 5 ERP: 1351000558 ACSA08-51SURKWA Recommended Soldering Pattern (Units : mm; Tolerance: ± 0.15) Reel Dimension Tape Specifications (Units : mm) SPEC NO: DSAG8876 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 4 OF 5 ERP: 1351000558 PACKING & LABEL SPECIFICATIONS ACSA08-51SURKWA SPEC NO: DSAG8876 APPROVED: WYNEC REV NO: V.2 CHECKED: Joe Lee DATE: MAY/29/2007 DRAWN: Y.L.LI PAGE: 5 OF 5 ERP: 1351000558