AP1608SYCK

1.6X0.8mm SMD CHIP LED LAMP AP1608SYCK SUPER BRIGHT YELLOW Features 1.6mmX0.8mm SMT LED, 1.1mm THICKNESS. LOW POWER CONSUMPTION. W IDE VIEW ING ANGLE. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE: 2000PCS / REEL . RoHS COMPLIANT. Description The Super Bright Yellow source color devices are made with DH InGaAlP on GaAs substrate Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ± 0 .1(0.004") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAB2719 APPROVED: J. Lu REV NO: V.8 CHECKED: Allen Liu DATE:MAR/15/2005 DRAWN: B.H.LI PAGE: 1 OF 4 ERP: 1203000080 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 20mA Min. AP1608SYCK SUPER BRIGHT YELLOW (InGaAIP) WATER CLEAR 18 Typ. 120 Viewing Angle 2 θ 1/2 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Super Bright Yellow Super Bright Yellow Super Bright Yellow Super Bright Yellow Super Bright Yellow Super Bright Yellow Typ. 590 590 20 20 2.0 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating/Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Super Bright Yellow 125 30 175 5 -40°C To +85°C Units mW mA mA V SPEC NO: DSAB2719 APPROVED: J. Lu REV NO: V.8 CHECKED: Allen Liu DATE:MAR/15/2005 DRAWN: B.H.LI PAGE: 2 OF 4 ERP: 1203000080 Super Bright Yellow AP1608SYCK SPEC NO: DSAB2719 APPROVED: J. Lu REV NO: V.8 CHECKED: Allen Liu DATE:MAR/15/2005 DRAWN: B.H.LI PAGE: 3 OF 4 ERP: 1203000080 AP1608SYCK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB2719 APPROVED: J. Lu REV NO: V.8 CHECKED: Allen Liu DATE:MAR/15/2005 DRAWN: B.H.LI PAGE: 4 OF 4 ERP: 1203000080