APE2712SURCK

2.7x1.2mm SMD CHIP LED LAMP APE2712SURCK HYPER RED Features 2.7mmx1.2mm SMT LED,1.3mm THICKNESS. LOW POWER CONSUMPTION. WIDE VIEWING ANGLE. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE :2000PCS / REEL. RoHS COMPLIANT. Description The Hyper Red source color devices are made with DH InGaAlP on GaAs substrate Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.008") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAB1735 APPROVED: J. Lu REV NO: V.4 CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: W.J.ZHU PAGE: 1 OF 4 ERP:1203001107 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 20 mA Min. APE2712SURCK HYPER RED (InGaAlP) WATER CLEAR 70 Typ. 150 Viewing Angle 2θ1/2 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Hyper Red Hyper Red Hyper Red Hyper Red Hyper Red Hyper Red Typ. 650 635 28 35 1.95 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Hyper Red 170 30 185 5 -40°C To +85°C Units mW mA mA V SPEC NO: DSAB1735 APPROVED: J. Lu REV NO: V.4 CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: W.J.ZHU PAGE: 2 OF 4 ERP:1203001107 SPEC NO: DSAB1735 APPROVED: J. Lu REV NO: V.4 CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: W.J.ZHU PAGE: 3 OF 4 ERP:1203001107 APE2712SURCK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage,luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB1735 APPROVED: J. Lu REV NO: V.4 CHECKED: Allen Liu DATE: MAR/15/2005 DRAWN: W.J.ZHU PAGE: 4 OF 4 ERP:1203001107