BC04-11SEKWA

10.2mm (0.4INCH) THREE DIGIT NUMERIC DISPLAY Part Number: BC04-11SEKWA Super Bright Orange Features Description z 0.4 inch digit height. The Super Bright Orange device is made with AlGaInP (on z Low current operation. GaAs substrate) light emitting diode chip. z Excellent character appearance. z Easy mounting on P.C. boards or sockets. z Mechanically rugged. z Standard : gray face, white segment. z RoHS compliant. Package Dimensions& Internal Circuit Diagram K g in g i r b t h Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAK2780 REV NO: V.6A DATE: JUN/24/2016 PAGE: 1 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: F.Zhang ERP: 1303000579 Selection Guide Part No. Emitting Color (Material) BC04-11SEKWA Super Bright Orange (AlGaInP) Iv (ucd) [1] @ 10mA Lens Type White Diffused Min. Typ. 52000 160000 *21000 *48000 Description Common Cathode Note: 1. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Emitting Color Typ. λpeak Peak Wavelength Super Bright Orange 610 λD [1] Dominant Wavelength Super Bright Orange Δλ1/2 Spectral Line Half-width Super Bright Orange C Capacitance Super Bright Orange VF [2] Forward Voltage Super Bright Orange IR Reverse Current Super Bright Orange Units Test Conditions nm IF=10mA nm IF=10mA nm IF=10mA pF VF=0V;f=1MHz 2.5 V IF=10mA 10 uA VR=5V g i r 601 29 b g n i K t h Max. 15 2.0 Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to CIE127-2007 standards. 4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25°C Parameter Values Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA 5 V Reverse Voltage Operating / Storage Temperature Lead Solder Temperature[2] -40°C To +85°C 260°C For 3-5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAK2780 REV NO: V.6A DATE: JUN/24/2016 PAGE: 2 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: F.Zhang ERP: 1303000579 Super Bright Orange t h g i r b g n i K BC04-11SEKWA SPEC NO: DSAK2780 REV NO: V.6A DATE: JUN/24/2016 PAGE: 3 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: F.Zhang ERP: 1303000579 PACKING & LABEL SPECIFICATIONS BC04-11SEKWA t h g i r b g in K Terms and conditions for the usage of this document 1. The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3. When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6. All design applications should refer to Kingbright application notes available at http://www.kingbright.com/application_notes SPEC NO: DSAK2780 REV NO: V.6A DATE: JUN/24/2016 PAGE: 4 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: F.Zhang ERP: 1303000579 K g in g i r b t h SPEC NO: DSAK2780 REV NO: V.6A DATE: JUN/24/2016 PAGE: 5 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: F.Zhang ERP: 1303000579 K g in g i r b t h SPEC NO: DSAK2780 REV NO: V.6A DATE: JUN/24/2016 PAGE: 6 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: F.Zhang ERP: 1303000579