CC56-12EWA

14.22mm (0.56INCH) FOUR DIGIT NUMERIC DISPLAY Part Number: CC56-12EWA High Efficiency Red Features Description  0.56 inch digit height. The High Efficiency Red source color devices are made with  Low current operation. Gallium Arsenide Phosphide on Gallium Phosphide Orange  Excellent character appearance. Light Emitting Diode.  Easy mounting on P.C. boards or sockets.  Mechanically rugged.  Standard : gray face, white segment.  RoHS compliant. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAB2487 REV NO: V.10A DATE: OCT/15/2014 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1304000165 Selection Guide Part No. Dice CC56-12EWA Lens Type High Efficiency Red (GaAsP/GaP) Iv (ucd) [1] @ 10mA Min. Typ. 3600 5800 *1400 *2400 White Diffused Description Common Cathode, Rt. Hand Decimal. Notes: 1. Luminous intensity/ luminous Flux: +/-15%. *Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD [1] Dominant Wavelength Δλ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 617 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF [2] Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR=5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to the CIE127-2007 compliant national standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating / Storage Temperature Lead Solder Temperature[2] -40°C To +85°C 260°C For 3-5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAB2487 REV NO: V.10A DATE: OCT/15/2014 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1304000165 High Efficiency Red CC56-12EWA SPEC NO: DSAB2487 REV NO: V.10A DATE: OCT/15/2014 PAGE: 3 OF 6 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1304000165 PACKING & LABEL SPECIFICATIONS CC56-12EWA Terms and conditions for the usage of this document 1.The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2.The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3.When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4.The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5.The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6.All design applications should refer to Kingbright application notes available at http://www.kingbright.com/application_notes SPEC NO: DSAB2487 REV NO: V.10A DATE: OCT/15/2014 PAGE: 4 OF 6 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1304000165 SPEC NO: DSAB2487 REV NO: V.10A DATE: OCT/15/2014 PAGE: 5 OF 6 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1304000165 SPEC NO: DSAB2487 REV NO: V.10A DATE: OCT/15/2014 PAGE: 6 OF 6 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1304000165