DC-05GWA

BAR GRAPH 5 SEGMENT Part Number: DC-05GWA Green Features Description z Suitable for level indicators. The Green source color devices are made with Gallium z Low current operation. Phosphide Green Light Emitting Diode. z Excellent on/off contrast. z End stackable. z Mechanically rugged. z Different colors in one unit available. z Standard : gray face, white segment. z RoHS compliant. t h g i r b g n i K Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAF3265 REV NO: V.7A DATE: JUL/04/2016 PAGE: 1 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1331000365 Selection Guide Part No. Emitting Color (Material) DC-05GWA Iv (ucd) [1] @ 10mA Lens Type Green (GaP) White Diffused Min. Typ. 5600 12000 *1400 *4000 Description 5 Segment Bar graph-Display Notes: 1. Luminous intensity / luminous Flux: +/-15%. * Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Emitting Color Typ. λpeak Peak Wavelength Green 565 λD [1] Dominant Wavelength Green 568 Δλ1/2 Spectral Line Half-width Green 30 C Capacitance Green 15 VF [2] Forward Voltage IR Reverse Current t h Max. Units Test Conditions nm IF=10mA nm IF=10mA nm IF=10mA pF VF=0V;f=1MHz 2.5 V IF=10mA 10 uA VR=5V g i r b g in Green 2 Green Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to CIE127-2007 standards. 4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. K Absolute Maximum Ratings at TA=25°C Parameter Values Units 62.5 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Power dissipation Reverse Voltage Operating / Storage Temperature Lead Solder Temperature[2] -40°C To +85°C 260°C For 3-5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAF3265 REV NO: V.7A DATE: JUL/04/2016 PAGE: 2 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1331000365 Green t h DC-05GWA g i r b g in K SPEC NO: DSAF3265 REV NO: V.7A DATE: JUL/04/2016 PAGE: 3 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1331000365 PACKING & LABEL SPECIFICATIONS DC-05GWA t h g i r b g in K Terms and conditions for the usage of this document 1. The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3. When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6. All design applications should refer to Kingbright application notes available at http://www.kingbright.com/application_notes SPEC NO: DSAF3265 REV NO: V.7A DATE: JUL/04/2016 PAGE: 4 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1331000365 t h g i r b g n i K SPEC NO: DSAF3265 REV NO: V.7A DATE: JUL/04/2016 PAGE: 5 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1331000365 t h g i r b g n i K SPEC NO: DSAF3265 REV NO: V.7A DATE: JUL/04/2016 PAGE: 6 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1331000365