DD-12SURKWB

12 SEGMENT BAR GRAPH ARRAY Part Number: DD-12SURKWB Hyper Red Features Description z Suitable for level indicators. The Hyper Red source color devices are made with Al- z Low current operation. GaInP on GaAs substrate Light Emitting Diode. z Wide viewing angle. z Mechanically rugged. z Different colors in one unit available. z Black face, white segment. z RoHS compliant. g i r b Package Dimensions& Internal Circuit Diagram K g in t h Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAK2952 REV NO: V.5A DATE: JAN/01/2016 PAGE: 1 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: J.L.Liang ERP: 1331000533 Selection Guide Part No. Emitting Color (Material) DD-12SURKWB Iv (ucd) [1] @ 10mA Lens Type Hyper Red (AlGaInP) Min. Typ. 52000 95000 *14000 *30000 White Diffused Description 12 Segments Bar graph-Display Notes: 1. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Emitting Color Typ. λpeak Peak Wavelength Hyper Red 645 λD [1] Dominant Wavelength Hyper Red 630 Δλ1/2 Spectral Line Half-width Hyper Red 28 C Capacitance Hyper Red 35 VF [2] Forward Voltage Hyper Red IR Reverse Current Hyper Red t h Max. Units Test Conditions nm IF=10mA nm IF=10mA nm IF=10mA pF VF=0V;f=1MHz 2.5 V IF=10mA 10 uA VR=5V g i r b g in 1.85 Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to CIE127-2007 standards. 4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. K Absolute Maximum Ratings at TA=25°C Parameter Values Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating / Storage Temperature Lead Solder Temperature[2] -40°C To +85°C 260°C For 3-5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAK2952 REV NO: V.5A DATE: JAN/01/2016 PAGE: 2 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: J.L.Liang ERP: 1331000533 Hyper Red t h g i r b g n i K DD-12SURKWB SPEC NO: DSAK2952 REV NO: V.5A DATE: JAN/01/2016 PAGE: 3 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: J.L.Liang ERP: 1331000533 PACKING & LABEL SPECIFICATIONS DD-12SURKWB t h g i r b g in K Terms and conditions for the usage of this document 1. The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3. When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6. All design applications should refer to Kingbright application notes available at http://www.kingbright.com/application_notes SPEC NO: DSAK2952 REV NO: V.5A DATE: JAN/01/2016 PAGE: 4 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: J.L.Liang ERP: 1331000533 K g in g i r b t h SPEC NO: DSAK2952 REV NO: V.5A DATE: JAN/01/2016 PAGE: 5 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: J.L.Liang ERP: 1331000533 K g in g i r b t h SPEC NO: DSAK2952 REV NO: V.5A DATE: JAN/01/2016 PAGE: 6 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: J.L.Liang ERP: 1331000533