KCPSA04-103

SURFACE MOUNT DISPLAY Part Number: KCPSA04-103 YELLOW Features 0.4 INCH CHARACTER HEIGHT. LOW CURRENT OPERATION. HIGH CONTRAST AND LIGHT OUTPUT. EASY MOUNTING ON P.C. BOARDS OR SOCKETS. CATEGORIZED FOR LUMINOUS INTENSITY. MECHANICALLY RUGGED. GRAY FACE,WHITE SEGMENT. PACKAGE : 400PCS / REEL. MOISTURE SENSITIVITY LEVEL : LEVEL 4. RoHS COMPLIANT. Description The Yellow source color devices are made with Gallium Arsenide Phosphide on Gallium Phosphide Yellow Light Emitting Diode. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. 3.The gap between the reflector and PCB shall not exceed 0.25mm S PEC NO: DSAG4714 APPROVED: J. Lu REV NO: V.1 CHECKED: Joe Lee DATE: MAY/20/2006 DRAWN: W.J.ZHU PAGE: 1 OF 4 Selection Guide Part No. Dice Lens Type Iv (ucd) [1] @ 10mA Min. KCPSA04-103 YELLOW (GaAsP/GaP) WHITE DIFFUSED 800 Typ. 3400 Common Anode, Rt. Hand Decimal. Description Note: 1. Luminous Intensity / Luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD [1] ∆λ1/2 C VF [2] IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Yellow Yellow Yellow Yellow Yellow Yellow Typ. 590 588 35 20 2.1 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Yellow 75 30 140 5 -40°C To +85°C Units mW mA mA V S PEC NO: DSAG4714 APPROVED: J. Lu REV NO: V.1 CHECKED: Joe Lee DATE: MAY/20/2006 DRAWN: W.J.ZHU PAGE: 2 OF 4 Yellow KCPSA04-103 S PEC NO: DSAG4714 APPROVED: J. Lu REV NO: V.1 CHECKED: Joe Lee DATE: MAY/20/2006 DRAWN: W.J.ZHU PAGE: 3 OF 4 KCPSA04-103 Recommended Soldering Pattern (Units : mm; Tolerance: ±0.15) Tape Specifications (Units : mm) S PEC NO: DSAG4714 APPROVED: J. Lu REV NO: V.1 CHECKED: Joe Lee DATE: MAY/20/2006 DRAWN: W.J.ZHU PAGE: 4 OF 4