KP-3216SEC

3.2x1.6mm SMD CHIP LED LAMP P/N: KP-3216SEC SUPER BRIGHT ORANGE Features 3.2mmx1.6mm SMT LED, 1.1mm THICKNESS. LOW POWER CONSUMPTION. WIDE VIEWING ANGLE. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Description The Super Bright Orange device is made with DH InGaAlP (on GaAs substrate) light emitting diode chip. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.0079") unless otherwise noted. 3. Specifications are subject to change without notice. S PEC NO: DSAC1230 APPROVED: J. Lu REV NO: V.6 CHECKED: Allen Liu DATE: NOV/11/2005 DRAWN: Y.L.LI PAGE: 1 OF 4 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 20mA Min. KP-3216SEC SUPER BRIGHT ORANGE (InGaAlP) WATER CLEAR 70 Typ. 200 Viewing Angle 2θ1/2 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Super Bright Orange Super Bright Orange Super Bright Orange Super Bright Orange Super Bright Orange Super Bright Orange Typ. 610 601 29 30 2.0 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. Super Bright Orange 75 30 195 5 -40°C To +85°C Units mW mA mA V S PEC NO: DSAC1230 APPROVED: J. Lu REV NO: V.6 CHECKED: Allen Liu DATE: NOV/11/2005 DRAWN: Y.L.LI PAGE: 2 OF 4 Super Bright Orange KP-3216SEC S PEC NO: DSAC1230 APPROVED: J. Lu REV NO: V.6 CHECKED: Allen Liu DATE: NOV/11/2005 DRAWN: Y.L.LI PAGE: 3 OF 4 KP-3216SEC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity / luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. S PEC NO: DSAC1230 APPROVED: J. Lu REV NO: V.6 CHECKED: Allen Liu DATE: NOV/11/2005 DRAWN: Y.L.LI PAGE: 4 OF 4