TC07-11PBWA

18mm (0.7 INCH) SINGLE COLOR DOT M ATRIX DISPLAY ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICE S TC07-11PBWA BLUE Features z0.7 zDOT Description The Blue source color devices are made with I nGaN on SiC Light Emitting Diode. Static electricity and surge damage the LEDS. I t is recommended to use a wrist band or a nti - electrostatic glove when handling the LEDs. All devices, equipment and machinery must be e lectrically grounded. INCH MATRIX HEIGHT. SIZE 2mm. CURRENT OPERATION. WITH ASCII AND EBCDIC CODES. zLOW zCOMPATIBLE zSTACKABLE zEASY VERTICALLY AND HORIZONTALLY. zMECHANICALLY zSTANDARD: z RoHS MOUNTING ON P.C. BOARDS OR SOCKETS. RUGGED. GRAY FACE, WHITE DOT. COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAC2563 APPROVED: J. Lu REV NO: V.4 CHECKED: Joe Lee DATE: MAY/21/2005 DRAWN: H.Q.YUAN PAGE: 1 OF 3 Selection Guid e Iv (ucd) @ 10mA Min. TC07-11PBWA BLUE (InGaN) WHITE DIFFUSED 4700 Typ. 13200 Column Cathode Part No. Dice Lens Type Description Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Blue Blue Blue Blue Blue Blue Device Typ. 468 470 25 65 3.65 4.2 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Lead Solder Temperature [2] Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. Blue 102 30 160 5 -40°C To +85°C 260°C For 5 Seconds Units mW mA mA V SPEC NO: DSAC2563 APPROVED: J. Lu REV NO: V.4 CHECKED: Joe Lee DATE: MAY/21/2005 DRAWN: H.Q.YUAN PAGE: 2 OF 3 Blue TC07-11PBWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAC2563 APPROVED: J. Lu REV NO: V.4 CHECKED: Joe Lee DATE: MAY/21/2005 DRAWN: H.Q.YUAN PAGE: 3 OF 3