WP13ID

2mm FLAT TOP LED LAMP WP13ID HIGH EFFICIENCY RED Features M OUNTS FLUSH WITH PANEL. L OW POWER CONSUMPTION. S UITABLE FOR AUDIO PANEL INDICATOR. F ITS 2mm HOLE IN PANEL UP TO 3.5mm (.138"). LONG LIFE - SOLID STATE RELIABILITY. RoHS COMPLIANT. Description The High Efficiency Red source color devices are made with Gallium Arsenide Phosphide on Gallium Phosphide Orange Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2530 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 1 OF 3 ERP:1101009211 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 10mA Min. WP13ID HIGH EFFICIENCY RED (GaAsP/GaP) RED DIFFUSED 5 Typ. 10 Viewing Angle 2 θ 1/2 70° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device High Efficiency Red High Efficiency Red High Efficiency Red High Efficiency Red High Efficiency Red High Efficiency Red Typ. 627 625 45 15 2.0 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR= 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Lead Solder Temperature [2] Lead Solder Temperature [3] Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. High Efficiency Red 105 30 160 5 -40°C To +85°C 260°C For 3 Seconds 260°C For 5 Seconds Units mW mA mA V SPEC NO: DSAF2530 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 2 OF 3 ERP:1101009211 High Efficiency Red WP13ID Remarks: If special sorting is required (e.g. binning based on forward voltage,luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2530 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 3 OF 3 ERP:1101009211