WP1413SGDL

4mm CYLINDRICAL LED LAMP WP1413SGDL SUPER BRIGHT GREEN Features CYLINDRICAL TYPE, FLAT TOP. CONVEX CATHODE MARK ON BODY. LOW POWER CONSUMPTION. I.C. COMPATIBLE. RELIABLE AND RUGGED. LONG LIFE - SOLID STATE RELIABILITY. RoHS COMPLIANT. Description The Super Bright Green source color devices are made with Gallium Phosphide Green Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. S PEC NO: DSAF2542 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE:APR/16/2005 DRAWN: B.H.LI PAGE: 1 OF 3 ERP: 1101001464 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 20mA Min. WP1413SGDL SUPER BRIGHT GREEN (GaP) GREEN DIFFUSED 2.6 Typ. 10 Viewing Angle 2 θ 1/2 100° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Super Bright Green Super Bright Green Super Bright Green Super Bright Green Super Bright Green Super Bright Green Typ. 565 568 30 15 2.2 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating/Storage Temperature Lead Solder Temperature [2] Lead Solder Temperature [3] Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. Super Bright Green 105 25 140 5 -40°C To +85°C 260°C For 3 Seconds 260°C For 5 Seconds Units mW mA mA V S PEC NO: DSAF2542 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE:APR/16/2005 DRAWN: B.H.LI PAGE: 2 OF 3 ERP: 1101001464 Super Bright Green WP1413SGDL Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. S PEC NO: DSAF2542 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE:APR/16/2005 DRAWN: B.H.LI PAGE: 3 OF 3 ERP: 1101001464