WP1513SURC-E

T-1 3/4 (5mm) SOLID STATE LAMP WP1513SURC/E HYPER RED Features z LOW z T-1 z VERSATILE z RELIABLE z RoHS Description The Hyper Red source color devices are made with DH InGaAlP on GaAs substrate Light Emitting Diode. MOUNTING ON P.C. BOARD OR PANEL. POWER CONSUMPTION. 3/4 DIAMETER PACKAGE, TAPERED TYPE. AND RUGGED. COMPLIANT. Package Dimension s Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2373 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1101001796 Selection Guid e Part No. Dice Lens Type Iv (mcd) @ 20mA Min. WP1513SURC/E HYPER RED (InGaAlP) WATER CLEAR 1500 Typ. 2200 Viewing Angle 2θ1/2 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Hyper Red Hyper Red Hyper Red Hyper Red Hyper Red Hyper Red Typ. 640 630 25 45 1.9 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating/Storage Temperature Lead Solder Temperature [2] Lead Solder Temperature [3] Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. Hyper Red 150 30 200 5 -40°C To +85°C 260°C For 3 Seconds 260°C For 5 Seconds Units mW mA mA V SPEC NO: DSAF2373 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1101001796 Hyper Red WP1513SURC/E SPEC NO: DSAF2373 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1101001796 PACKING & LABEL SPECIFICATIONS WP1513SURC/E Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2373 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1101001796