WP443HDT

2.4mm FLAT TOP LED LAMP WP443HDT BRIGHT RED Features LOW POWER CONSUMPTION. I.C.COMPTATIBLE. LONG LIFE - SOLID STATE RELIABILITY. FITS 2.4mm HOLE IN PANEL UP TO 4mm THICK. RoHS COMPLIANT. Description The Bright Red source color devices are made with Gallium Phosphide Red Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. S PEC NO: DSAE9392 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 1 OF 4 ERP: 1101004593 Selection Guide Part No. Dice Lens Type Iv (mcd) @ 10mA Min. WP443HDT BRIGHT RED (GaP) RED DIFFUSED 0.4 Typ. 2 Viewing Angle 2θ1/2 100° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Bright Red Bright Red Bright Red Bright Red Bright Red Bright Red Typ. 700 660 45 40 2.25 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating/Storage Temperature Lead Solder Temperature [2] Lead Solder Temperature [3] Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. Bright Red 120 25 130 5 -40°C To +85°C 260°C For 3 Seconds 260°C For 5 Seconds Units mW mA mA V S PEC NO: DSAE9392 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 2 OF 4 ERP: 1101004593 Bright Red WP443HDT S PEC NO: DSAE9392 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 3 OF 4 ERP: 1101004593 PACKING & LABEL SPECIFICATIONS WP443HDT Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. S PEC NO: DSAE9392 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: APR/18/2005 DRAWN: W.J.ZHU PAGE: 4 OF 4 ERP: 1101004593