WP44YD

4mm SOLID STATE LAMP WP44YD YELLOW Features zLOW POW ER CONSUMPTION. zPOPULAR 4mm DIAMETER. zRELIABLE AND RUGGED. zRoHS COMPLIANT. Description The Yellow source color devices are made with G allium Arsenide Phosphide on Gallium Phosphide Y ellow Light Emitting Diode. zVERSATILE MOUNTING ON P.C. BOARD OR PANEL. Package Dimension s Notes: 1. All dimensions are in millimeters (inches) . 2. T olerance is ± 0 .25(0.01") unless otherwise noted . 3. Lead spacing is measured where the lead emerge from the package. 4 . Specifications are subject to change without notice . SPEC NO: DSAF2369 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 1 OF 4 ERP:1101004590 Selection Guid e Part No. Dice Lens Type Iv (mcd) @ 10mA Min. WP44YD YELLOW (GaAsP/GaP) YELLOW DIFFUSED 3 Typ. 10 Viewing Angle 2θ1/2 80° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol λpeak λD ∆λ1/2 C VF IR Parameter Peak Wavelength Dominant Wavelength Spectral Line Half-width Capacitance Forward Voltage Reverse Current Device Yellow Yellow Yellow Yellow Yellow Yellow Typ. 590 588 35 20 2.1 2.5 10 Max. Units nm nm nm pF V uA Test Conditions IF=20mA IF=20mA IF=20mA VF=0V;f=1MHz IF=20mA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Power dissipation DC Forward Current Peak Forward Current [1] Reverse Voltage Operating / Storage Temperature Lead Solder Temperature [2] Lead Solder Temperature [3] Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. Yellow 105 30 140 5 -40°C To +85°C 260°C For 3 Seconds 260°C For 5 Seconds Units mW mA mA V SPEC NO: DSAF2369 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 2 OF 4 ERP:1101004590 Yellow WP44YD SPEC NO: DSAF2369 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 3 OF 4 ERP:1101004590 PACKING & LABEL SPECIFICATIONS WP44YD Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2369 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/19/2005 DRAWN: S.H.CHEN PAGE: 4 OF 4 ERP:1101004590