WP7104F3BT

T-1 (3mm) INFRA-RED EMITTING DIODE PRELIMINARY SPEC WP7104F3BT Features MECHANICALLY AND SPECTRALLY MATCHED TO THE PHOTOTRANSISTOR. BLUE TRANSPARENT LENS. RoHS COMPLIANT. Description F3 Made Gallium Arsenide Infrared Emitting diodes. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2296 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/15/2005 DRAWN: W.J.ZHU PAGE: 1 OF 4 ERP:1101008142 Selection Guide Part No. Dice Lens Type Po (mW/sr) @ 20mA *50mA Min. 7 WP7104F3BT GaAs BLUE TRANSPARENT *18 Notes: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. 2. * Luminous intensity with asterisk is measured at 50mA. Viewing Angle 2θ1/2 34° 34° Typ. 28 *70 Electrical / Optical Characteristics at TA=25°C Parameter Forward Voltage Reverse Current Capacitance Peak Spectral Wavelength Spectral Bandwidth P/N F3 F3 F3 F3 F3 Symbol VF IR C λP ∆λ1/2 Typ. 1.2 90 940 50 Max. 1.6 10 Units V uA pF nm nm Test Conditions IF=20mA VR=5V VF=0V;f=1MHz IF=20mA IF=20mA Absolute Maximum Ratings at TA=25°C Parameter Power Dissipation DC Forward Current Peak Forward Current[1] Reverse Voltage Operating Temperature Storage Temperature Lead Solder Temperature [2] Lead Solder Temperature [3] Notes: 1. 1/100 Duty Cycle, 10µs Pulse Width. 2. 2mm below package base. 3. 5mm below package base. Symbol PT IF iFS VR TA TSTG F3 100 50 1.2 5 -40 To +85 -40 To +85 260°C For 3 Seconds 260°C For 5 Seconds Units mW mA A V °C °C SPEC NO: DSAF2296 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/15/2005 DRAWN: W.J.ZHU PAGE: 2 OF 4 ERP:1101008142 WP7104F3BT SPEC NO: DSAF2296 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/15/2005 DRAWN: W.J.ZHU PAGE: 3 OF 4 ERP:1101008142 PACKING & LABEL SPECIFICATIONS WP7104F3BT Remarks: If special sorting is required (e.g. binning based on forward voltage or radiant intensity), the typical accuracy of the sorting process is as follows: 1. Radiant Intensity: +/-15% 2. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2296 APPROVED: J. Lu REV NO: V.1 CHECKED: Allen Liu DATE: APR/15/2005 DRAWN: W.J.ZHU PAGE: 4 OF 4 ERP:1101008142