WP7104SEC/J3

T-1 (3mm) SOLID STATE LAMP PRELIMINARY SPEC Part Number: WP7104SEC/J3 Hyper Red Features Description zLow power consumption. The Hyper Red device is based on light emitting diode chip zPopular T-1 diameter package. made from AlGaInP. zGeneral purpose leads. zReliable and rugged. zLong life - solid state reliability. zAvailable on tape and reel. zRoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 1 OF 4 ERP: 1101024770 Selection Guide Part No. Dice WP7104SEC/J3 Lens Type Hyper Red (AlGaInP) WATER CLEAR Viewing Angle [1] Iv (mcd) [2] @ 20mA Min. Typ. 2θ1/2 3300 7000 34° Notes: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. 2. Luminous intensity/ luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Hyper Red λD [1] Dominant Wavelength Δλ1/2 Max. Units Test Conditions 640 nm IF=20mA Hyper Red 625 nm IF=20mA Spectral Line Half-width Hyper Red 25 nm IF=20mA C Capacitance Hyper Red 27 pF VF=0V;f=1MHz VF [2] Forward Voltage Hyper Red 2.2 2.8 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 84 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 2 OF 4 ERP: 1101024770 RED Hyper Red WP7104SEC/J3 SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 3 OF 4 ERP: 1101024770 PACKING & LABEL SPECIFICATIONS SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu WP7104SEC/J3 DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 4 OF 4 ERP: 1101024770