SPH1642HT5H-1

SPH1642HT5H-1 HARDY V2 WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE The SPH1642HT5H-1 is a miniature, high-performance, low power, matched sensitivity top port silicon microphone. Using Knowles’ proven high performance SiSonic™ MEMS technology, the SPH1642HT5H-1 consists of an acoustic sensor, a low noise input buffer, and an output amplifier. These devices are suitable for applications such as cellphones, smart phones, laptop computers, sensors, digital still cameras, portable music recorders, and other portable electronic devices where excellent wideband audio performance and RF immunity are required. P R O D U C T F E AT U R E S • Matched Sensitivity • LGA Package • Flat Frequency Response Change Pump • Low Current Vdd Regulator • MaxRF Protection • Top Port MEMS Transducer • Ultra-Stable Performance OUT Buffer • Standard SMD Reflow GND • Omnidirectional T Y P I C A L A P P L I C AT I O N S ABSOLUTE MAXIMUM RATINGS • Portable electronics • Cellphones Table 1: Absolute Maximum Ratings • Laptop Computers Parameter Absolute Maximum Rating Units Vdd to Ground -0.3, +5.0 V Out to Ground -0.3, Vdd+0.3 V Input Current to any pin ±5 mA Storage Temperature -40 to +100 °C Operating Temperature -30 to +100 °C • Tablets • Digital Still Cameras • Portable Music Recorders Stresses exceeding these “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only. Functional operation at these or any other conditions beyond those indicated under “Acoustic & Electrical Specifications” is not implied. Exposure beyond those indicated under “Acoustic & Electrical Specifications” for extended periods may affect device reliability. knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE ACOUSTIC & ELECTRICAL SPECIFICATIONS1 Table 2: General Microphone Specifications Test Conditions: 23 ±2°C, 55±20% R.H., Vdd=1.8V, no load, unless otherwise indicated Parameter Symbol Supply Voltage Vdd Supply Current Idd Sensitivity Conditions Min Typ Max Units 1.5 - 3.6 V Vdd = 3.6V - 132 185 Vdd = 1.8V - 117 130 S 94 dB SPL @ 1 kHz -39 -38 -37 dBV/Pa Signal to Noise Ratio SNR 94 dB SPL @ 1 kHz, A-weighted - 65 - dB(A) Total Harmonic Distortion THD 94 dB SPL @ 1 kHz, S = Typ, Rload > 2kΩ - 0.25 - % 1% THD @ 1 kHz Vdd = 1.8v, S = Typ, Rload > 2kΩ - 107 - dB SPL Acoustic Overload Point AOP 10% THD @ 1 kHz, Vdd = 1.8v, S = Typ, Rload > 2kΩ - 124 - dB SPL Low Frequency Rolloff LFRO -3dB relative to 1kHz - 55 - Hz Power Supply Rejection Ratio PSRR 200 mVpp sinewave @ 1kHz, Vdd = 1.8 v - 77 - dB Power Supply Rejection PSR+N 200 mVpp 7/8 duty cycle rectangular wave @ 217 Hz, Vdd = 1.8V, A-weighted - -102 - dBV(A) DC Output Vdd = 1.8V - 1.30 - V Output Impedance @ 1 kHz - 500 Ω Sensitivity Drop Vdd(min) ≤ Vdd ≤ Vdd(max) - ±0.25 dB Directivity - Omnidirectional Polarity 1 Increasing sound pressure Increasing output voltage Sensitivity and Supply Current are 100% tested. APPLICATION NOTES Figure 1: Typical Application Circuit Codec or Applications Processor Vdd Vdd GND Vdd Analog Mic Interface Mic Vdd OUT Rout GND NOTES: All Ground pins must be connected to ground. Capacitors near the microphone should not contain Class 2 dielectrics due to their piezoelectric effects. Detailed information on acoustic, mechanical, and system integration can be found in the latest SiSonicTM Design Guide application note. knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. 2 µA SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE PERFORMANCE CURVES Test Conditions: Vdd=1.8V, no load, unless otherwise indicated Figure 2: Typical Free Field Response Normalized to 1 kHz Figure 3: Typical PSRR vs Frequency Figure 4: Typical THD vs SPL Figure 5: Typical Idd vs Vdd Figure 6: THD vs Frequency Figure 7: Noise Floor Power Spectral Density knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. 3 SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE MECHANICAL SPECIFICATIONS Item Dimension Tolerance Pin # Pin Name Type Description Length (L) 3.50 ±0.10 1 GROUND Power Ground Width (W) 2.65 ±0.10 2 GROUND Power Ground Height (H) 1.00 ±0.10 3 GROUND Power Ground Acoustic Port (AP) 0.325 ±0.10 4 OUTPUT Signal Output Signal 5 TEST PIN (Knowles Internal Use) N/A Connect to Ground 6 Vdd Power Power Supply NOTES: Pick Area only extends to 0.25 mm of any edge or hole unless otherwise specified. Dimensions are in millimeters unless otherwise specified. Tolerance is ±0.15mm unless otherwise specified. Detailed information on AP size considerations can be found in the latest SiSonicTM Design Guide application note. Further optimizations based on application should be performed. Example Land Pattern Example Solder Stencil Pattern knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. 4 SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE PACKAGING & MARKING DETAIL Model Number Suffix Reel Diameter Quantity Per Reel SPH1642HT5H-1 -8 13” 5,900 “º”: orientation mark Alpha Character A: “S”: Knowles SiSonicTM Production “E”: Knowles Engineering Samples “P”: Knowles Prototype Samples “JIN -NUMBER”: Unique Job Identification Number for product traceability NOTES: Dimensions are in millimeters unless otherwise specified. Vacuum pickup only in the pick area indicated in Mechanical Specifications. Tape & reel per EIA-481. Labels applied directly to reel and external package. Shelf life: Twelve (12) months when devices are to be stored in factory supplied, unopened ESD moisture sensitive bag under maximum environmental conditions of 30°C, 70% R.H. knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. 5 SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE RECOMMENDED REFLOW PROFILE Profile Feature Pb-Free Average Ramp-up rate (TSMAX to TP) 3°C/second max. NOTES: Based on IPC/JDEC J-STD-020 Revision C. Preheat • Temperature Min (TSMIN) • Temperature Max (TSMAX) • Time (TSMIN to TSMAX) (tS) 150°C 200°C 60-180 seconds Time maintained above: • Temperature (TL) • Time (tL) 217°C 60-150 seconds Peak Temperature (TP) 260°C Time within 5°C of actual Peak Temperature (tP) 20-40 seconds Ramp-down rate (TP to TSMAX) 6°C/second max Time 25°C to Peak Temperature 8 minutes max All temperatures refer to topside of the package, measured on the package body surface. ADDITIONAL NOTES: (A) MSL (moisture sensitivity level) Class 1. (B) Maximum of 3 reflow cycles is recommended. (C) In order to minimize device damage: • Do not board wash or clean after the reflow process. • Do not brush board with or without solvents after the reflow process. • Do not directly expose to ultrasonic processing, welding, or cleaning. • Do not insert any object in port hole of device at any time. • Do not apply over 30 psi of air pressure into the port hole. • Do not pull a vacuum over port hole of the microphone. • Do not apply a vacuum when repacking into sealed bags at a rate faster than 0.5 atm/sec. knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. 6 SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE MATERIALS STATEMENT Meets the requirements of the European RoHS directive 2011/65/EC as amended. Meets the requirements of the industry standard IEC 61249-2-21:2003 for halogenated substances and Knowles Green Materials Standards Policy section on Halogen-Free. Ozone depleting substances are not used in the product or the processes used to make the product, including compounds listed in Annex A, B, and C of the “Montreal Protocol on Substances That Deplete the Ozone Layer.” RELIABILITY SPECIFICATIONS Test Description Reflow 5 reflow cycles with peak temperature of +260°C High Temperature Storage +105°C environment for 1,000 hours (IEC 68-2-2 Test Ba) Low Temperature Storage -40°C environment for 1,000 hours (IEC 68-2-1 Test Aa) High Temperature Bias +105°C environment while under bias for 1,000 hours (IEC 68-2-2 Test Ba) Low Temperature Bias -40°C environment while under bias for 1,000 hours (IEC 68-2-1 Test Aa) Temperature/Humidity Bias +85°C/85% R.H. environment while under bias for 1,000 hours (JESD22-A101A-B) Thermal Shock 100 cycles of air-air thermal shock from -40°C to +125°C with 15 minute soaks (IEC 68-2-4) Vibration 12 minutes in each X, Y, Z axis from 20 to 2,000 Hz with peak acceleration of 20 G (MIL 883E, Method 2007.2,A) Mechanical Shock 3 pulses of 10,000 G in each of the X, Y, and Z directions (IEC 68-2-27 Test Ea) ESD-HBM 3 discharges of ±2kV direct contact to I/O pins (MIL 883E, Method 3015.7) ESD-HBM (LID/GND) 3 discharges of ±8kV direct contact to lid while unit is grounded (MIL 883E, Method 3015.7) ESD-MM 3 discharges of ±200V direct contact to IO pins (ESD STM5.2) NOTES: Microphones must meet all acoustic and electrical specifications before and after reliability testing. After 3 reflow cycles, the sensitivity of the microphones shall not deviate more than 1 dB from its initial value. knowles.com | DATASHEET SPH1642HT5H-1 REV E © 2017, Knowles Electronics, LLC, Itasca, IL, USA. All Rights Reserved. 7 SiSonic, Knowles and the logo are trademarks of Knowles Electronics, LLC. WIDE BANDWIDTH, LOW NOISE, PRECISION TOP PORT SISONICTM MICROPHONE SPECIFICATION REVISIONS Revision Specification Changes Date A Initial Release ECR#15-181 5/21015 B Changed THD to 0.25% ECR#15-129 7/21/2015 C Changed microphone photograph ECR#16-1240 10/27/2016 D Update Pin description ECR #17-1656 5/15/17 E Update Temperature range ECR#17-2010 11/13/17 Information contained herein is subject to change without notice. It may be used by a party at their own discretion and risk. We do not guarantee any results or assume any liability in connection with its use. This publication is not to be taken as a license to operate under any existing patents. 8 Knowles Corporation 1151 Maplewood Drive Itasca, Illinois 60143 Phone: 1 (630) 250-5100 Fax: 1 (630) 250-0575 sales@knowles.com Model/Reference Number: Datasheet SPH1642HT5H-1 REV E © Copyright 2017 Knowles