0
登录后你可以
  • 下载海量资料
  • 学习在线课程
  • 观看技术视频
  • 写文章/发帖/加入社区
会员中心
创作中心
发布
  • 发文章

  • 发资料

  • 发帖

  • 提问

  • 发视频

创作活动
LTC3407EMSE

LTC3407EMSE

  • 厂商:

    LINER

  • 封装:

  • 描述:

    LTC3407EMSE - Dual Synchronous, 600mA, 1.5MHz Step-Down DC/DC Regulator - Linear Technology

  • 详情介绍
  • 数据手册
  • 价格&库存
LTC3407EMSE 数据手册
LTC3407 Dual Synchronous, 600mA, 1.5MHz Step-Down DC/DC Regulator FEATURES ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ DESCRIPTIO High Efficiency: Up to 96% Very Low Quiescent Current: Only 40µA 1.5MHz Constant Frequency Operation High Switch Current: 1A on Each Channel No Schottky Diodes Required Low RDS(ON) Internal Switches: 0.35Ω Current Mode Operation for Excellent Line and Load Transient Response Short-Circuit Protected Low Dropout Operation: 100% Duty Cycle Ultralow Shutdown Current: IQ < 1µA Output Voltages from 5V down to 0.6V Power-On Reset Output Externally Synchronizable Oscillator Small Thermally Enhanced MSOP and 3mm × 3mm DFN Packages The LTC®3407 is a dual, constant frequency, synchronous step down DC/DC converter. Intended for low power applications, it operates from 2.5V to 5.5V input voltage range and has a constant 1.5MHz switching frequency, allowing the use of tiny, low cost capacitors and inductors 2mm or less in height. Each output voltage is adjustable from 0.6V to 5V. Internal synchronous 0.35Ω, 1A power switches provide high efficiency without the need for external Schottky diodes. A user selectable mode input is provided to allow the user to trade-off ripple noise for low power efficiency. Burst Mode® operation provides high efficiency at light loads, while Pulse Skip Mode provides low ripple noise at light loads. To further maximize battery life, the P-channel MOSFETs are turned on continuously in dropout (100% duty cycle), and both channels draw a total quiescent current of only 40µA. In shutdown, the device draws
LTC3407EMSE
### 物料型号 - LTC3407:双同步降压DC/DC转换器,最大输出电流600mA,开关频率1.5MHz。

### 器件简介 - LTC3407是一款双路、恒定频率、同步降压DC/DC转换器,适用于低功耗应用。输入电压范围2.5V至5.5V,内部同步0.35Ω、1A功率开关提供高效率,无需外置肖特基二极管。

### 引脚分配 - VFB1(Pin 1):输出反馈,接收跨输出的外部电阻分压器的反馈电压,标称电压为0.6V。 - RUN1(Pin 2):调节器1使能,强制此引脚至VIN使调节器1工作,强制至GND关闭调节器1。 - VIN(Pin 3):主电源供应,必须接近解耦至GND。 - SW1(Pin 4):调节器1开关节点连接至电感器,此引脚在VIN和GND之间摆动。 - GND(Pin 5):主地,连接至C_OUT和CIN的负端。 - MODE/SYNC(Pin 6):模式选择和振荡器同步,控制设备操作。 - SW2(Pin 7):调节器2开关节点连接至电感器,此引脚在VIN和GND之间摆动。 - POR(Pin 8):上电复位,当输出电压不在规定范围内时为低电平,两通道均调节后175ms后为高电平。 - RUN2(Pin 9):调节器2使能,强制此引脚至VIN使调节器2工作,强制至GND关闭调节器2。 - VFB2(Pin 10):输出反馈,接收跨输出的外部电阻分压器的反馈电压,标称电压为0.6V。 - Exposed Pad (GND)(Pin 11):功率地,连接至C_OUT和CIN的负端,必须焊接至PCB上的电地。

### 参数特性 - 输入电压范围:2.5V至5.5V。 - 输出电压范围:可调至0.6V至5V。 - 开关频率:1.5MHz,可同步至外部振荡器。 - 效率:高达96%。 - 关闭状态下的电流:<1µA。

### 功能详解 - LTC3407采用恒定频率、电流模式架构,提供突发模式和脉冲跳跃模式以优化效率和噪声。 - 通过外部分压器设置输出电压,内部比较器比较分压后的输出电压与参考电压,调节电感器电流。 - 过压和欠压比较器会在输出电压不在规定范围内时拉低POR输出。

### 应用信息 - 适用于PDA/掌上电脑、数码相机、手机、便携式媒体播放器、PC卡、无线和DSL调制解调器等应用。

### 封装信息 - DFN封装:10引脚塑料DFN(3mm×3mm)。 - MSOP封装:10引脚塑料MSOP。
LTC3407EMSE 价格&库存

很抱歉,暂时无法提供与“LTC3407EMSE”相匹配的价格&库存,您可以联系我们找货

免费人工找货