LTDL-TA16A-T

L ITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only FEATURES * TTL INTERFACE COMPATIBLE * HIGH SPEED OPTIC SIGNAL TRANSMISSION * BUILT-IN LED DRIVER * LOW POWER CONSUMPTION VDD Vin LED VDD * 2.7V ~ 5.25V HIGH ON FLOATING 2.7V ~ 5.25V LOW OFF FLOATING 2.7V ~ 5.25V FLOATING OFF * WATER CLEAR EPOXY COMPOUND PACKAGED. Vin HIGH LOW LED OFF OFF PACKAGE DIMENSIONS NOTES: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1mm(.004") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Mark color:Black Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 1 of 4 L ITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only ABSOLUTE MAXIMUM RATINGS AT TA=25℃ PARAMETER Supply Voltage (VDD) Input Voltage (VIN) Power Dissipation (P) Operating Temperature Range Storage Temperature Range Lead Soldering Temperature [1.6mm(.063") From Body] MAXIMUM RATING -0.5 ~ +7 -0.5 ~ VDD +0.5 120 -25 ℃ to + 70 ℃ -40 ℃ to + 70 ℃ 260℃ ≦5 Seconds UNIT V V mW ELECTRICAL OPTICAL CHARACTERISTICS AT TA=25℃ PARAMETER Transmission Speed Operating Voltage Peak Emission Wavelength Fiber coupling light output Dissipation current High level input voltage Low level input voltage “Low High”propagation delay time “High Low”propagation delay time Pulse width distortion Jitter SYMBOL MIN. Ts VDD λPeak Pc IDD VIH VIL － 2.75 630 -21 － 2 － － － -15 － TYP. － － 650 -17 5 － － － － － － MAX. 16 5.25 690 -15 12 － 0.8 100 100 15 15 UNIT Mbps V nm dBm mA V V ns ns ns ns *3 *1 *2 TEST CONDITION NRZ signal tPLH tPHL ΔtW Δtj Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 2 of 4 L ITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only *1 Measuring method of optical output coupling power Transmitter Standard plastic optical fiber cable Optical power meter Calibrate the optical power meter to sense the light with wavelength 650nm. V IN VDD GND +- VDD 0.1uF *2 Power dissipation measuring method Transmitter V IN V DD GND 0.1uF A IDD +- VDD Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 3 of 4 L ITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only *3 Measuring pulse response Transmitter Standard plastic optical fiber cable Standard receiver Output Signal V IN V DD GND +- V DD 0.1uF Input Oscilloscope Trigger:CH1 NRZ code "1010..." pattern CH1 CH2 Input signal (CH1) 50% Standard receiver output (CH2) 50% t PLH Pulse width distortion t PHL tw = t PHL-t PLH Note (1) NRZ code: 16MHz (2)The impedance of the probe for the oscilloscope must be more than 1M and less than 10pf. Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 4 of 4