LTDL-TX12S05

LITE-ON TECHNOLOGY CORPORATION P r o p er t y o f Lit e- On Only FEATURES * High speed transmission （13.2 Mbps , NRZ code ） * Build-in LED driving circuit allows connecting directly to modulation IC for digital audio equipment. * Wide range of operating voltage from 3V to 5V * Same package as fiber optic receiving module LTDL-TX12S05 APPLICATIONS * Digital audio system * CD, MD & DVD players PACKAGE DIMENSIONS NOTES: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.3 mm (.012") unless otherwise noted. 3. In the absence of comfrimation by device data sheets. LITE-ON takes no respondibility for any defects that may occur in equipment using any devices shown in catalogs, data book. etc. Contant LITE-ON in order to obtain the latest device data sheets before using any LITE-ON device. Part No. : LTDL-TX12S05 DATA SHEET BNS-OD-C131/A4 Page : 1 of 6 LITE-ON TECHNOLOGY CORPORATION P r o p er t y o f Lit e- On Only ELECTRO－OPTICAL CHARACTERISTICS ABSOLUTE MAXIMUM RATINGS AT TA=25℃ PARAMETER MAXIMUM RATING UNIT -0.5 ~ +7 V -0.5 ~ VDD +0.5 V Supply Voltage (VDD) Input Voltage (VIN) Operating Temperature Range -20 ℃ to +70 ℃ Storage Temperature Range -30 ℃ to +80 ℃ Lead Soldering Temperature [1.6mm(.063") From Body] 260℃ for 5 Seconds ELECTRICAL OPTICAL CHARACTERISTICS AT TA=25℃ PARAMETER SYMBOL MIN. TYP. MAX. UNIT TEST CONDITION NRZ code Ts － － 13.2 Mbps Operating Voltage VDD 2.75 － 5.25 V Peak Emission Wavelength λPeak 630 650 690 nm VDD = 2.75 ~ 5.25 V Fiber Coupling Light Output Pc -21 -18 -15 dBm *1 Current Consumption IDD － 6 8 mA *1 High Level Input Voltage VIH 2 － － V *1 Low Level Input Voltage VIL － － 0.8 V *1 “LowàHigh”propagation delay time tPLH － － 166 ns “HighàLow”propagation delay time tPHL － － 155 ns Pulse Width Distortion ΔtW -18 － +18 ns Jitter Δtj － 1 18 ns Data Rate Part No. : LTDL-TX12S05 DATA SHEET BNS-OD-C131/A4 Page : *2 *2 2 of 6 LITE-ON TECHNOLOGY CORPORATION P r o p er t y o f Lit e- On Only * 1 Measuring method of optical output coupling power V IN V DD GND IDD VDD （1） THE SONY POC-10（POF, 1m）or its equivalent fiber optic cable should be used as the standard fiber optic cable. （2） The ANRITSUML910B（receiver MA9802）or its equivalent optical power meter shall be used. （3） Set the sensitivity of wavelength of the optical power at 660nm. （4） It measuers in the condition where did fiber optic cable straight , but the curve of range within contented a prtformance of the fiber optic cable makes a passable. Item Measuring Methed Pc Measured on the optical power meter. IDD Measured on the ammeter. VIH At the optical fiber coupling light output： -21 ≦ Pc ≦ -15dBm VIL At the optical fiber coupling light output： Pc ≦ -36 dBm Part No. : LTDL-TX12S05 DATA SHEET BNS-OD-C131/A4 Page : 3 of 6 LITE-ON TECHNOLOGY CORPORATION P r o p er t y o f Lit e- On Only * 2 Measuring pulse response Note： （1） Vcc = 2.75V~ 5.25V （2） Input Singnal：13.2 M bps NRZ code , VIH ≧ 2.0V , VIL ≧ 0.8V , tr , tf ≦ Ins. （3） The SONY POC-10（POF 1m）or its equivalent optical fiber cable should be used. （4） Characteristics of standard rceiver are according to another sheet. （5） The Tektronix TDS380P or its equivalent oscilloscope should be used. （6） When measuring delay time, use the probe A and B of the same type and length. Part No. : LTDL-TX12S05 DATA SHEET BNS-OD-C131/A4 Page : 4 of 6 LITE-ON TECHNOLOGY CORPORATION P r o p er t y o f Lit e- On Only Rise and Fall Times and Pulse Width Distortion Input Signal 50% （CH1） tf tr 90% VOH 50% Output Signal （CH2） VOL 10% t PLH t PHL Pulse Width Distortion= tw = tPHL-tPLH Jitter （CH2） 50% Input Signal （CH1） 50% Output Signal （CH2） tj Part No. : LTDL-TX12S05 DATA SHEET BNS-OD-C131/A4 tj Page : 5 of 6 LITE-ON TECHNOLOGY CORPORATION P r o p er t y o f Lit e- On Only Notice l The circuit application examples in this publication are provided to explain representative applications of LITE-ON devices and are not intended to guarantee any circuit design or license any intellectual property rights. LITE-ON takes no responsibility for any problems related to any intellectual property right of a third party resulting from the use of LITE-ON devices. l Contact LITE-ON in order to obtain the latest device data sheets before using any LITE-ON device. LITE-ON reserves the right to make changes in the specifications, characteristics, data, materials, structure, and other contents described herein at any time without notice in order to improve design or reliability. Manufacturing locations are also subject to change without notice. l Observe the following points when using any devices in this publication. LITE-ON takes no responsibility for damage caused by improper use of the devices which does not meet the conditions and absolute maximum ratings to be used specified in the relevant data sheet nor meet the following conditions： ( i ) The devices in this publication are designed for use in general electronic equipment designs such as： --- Personal computers --- Office automation equipment --- Telecommunication equipment【terminal】 --- Test and measurement equipment --- Industrial control --- Audio visual equipment --- Consumer electronics ( ii ) Measure such as fail-safe function and redundant design should be taken to ensure reliability and safety when LITE-ON device are used for or in connection with equipment that requires higher reliability such as： --- Transportation control and safety equipment（i.e., aircraft, train, automobiles, ect.） --- Traffic signals --- Gas leakage sensor breakers --- Alarm equipment --- Various safety devices, etc. ( iii ) LITE-ON devices shall not be used for or in connection with equipment that requires an extremely high level of reliability and safety such as： --- Space applications --- Telecommunication equipment（trunk lines） --- Nuclear power control equipment --- Medical and other life support equipment（e.g., scuba） l If the LITE-ON devices listed in this publication fall within the scope of strategic products described in the Foreign Exchange and Foreign Trade Law of Republic of China , it is necessary to obtain approval to export such LITE-ON devices. l This publication is the proprietary product of LITE-ON and is copyrighted, with all rights reserved. Under the copyright laws, no part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, in whole or in part, without the express written permission of LITE-ON. Express written permission is also required before any use of this publication may be made by a third party. l Contact and consult with a LITE-ON representative if there are any questions about the contents of this publication. Part No. : LTDL-TX12S05 DATA SHEET BNS-OD-C131/A4 Page : 6 of 6