LTL2H3KRK-012A

LITE-ON ELECTRONICS, INC. Property of Lite-On Only Features * High luminous intensity output. * Low power consumption. * High efficiency. * Versatile mounting on P.C. board or panel. * I.C. Compatible/low current requirements. * Popular T-13/4 diameter. Package Dimensions Part No. LTL2H3KRK-012A Lens Water Clear Source Color AlInGaP Super Red Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25mm(.010") unless otherwise noted. 3. Protruded resin under flange is 1.0mm(.04") max. 4. Lead spacing is measured where the leads emerge from the package. 5. Specifications are subject to change without notice. Part No. : LTL2H3KRK-012A BNS-OD-C131/A4 Page : 1 of 5 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Absolute Maximum Ratings at TA=25℃ Parameter Power Dissipation Peak Forward Current (1/10 Duty Cycle, 0.1ms Pulse Width) Continuous Forward Current Derating Linear From 50℃ Reverse Voltage Operating Temperature Range Storage Temperature Range Lead Soldering Temperature [1.6mm(.063") From Body] 90 30 0.4 5 -40℃ to + 100℃ -55℃ to + 100℃ 260℃ for 5 Seconds mA mA mA/℃ V Maximum Rating 75 Unit mW Part No. : LTL2H3KRK-012A BNS-OD-C131/A4 Page : 2 of 5 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Electrical / Optical Characteristics at TA=25℃ Parameter Symbol Min. Typ. Max. Unit Test Condition IF = 20mA Note 1 Note 2 (Fig.5) Measurement @Peak (Fig.1) Note 4 Luminous Intensity IV 2θ1/2 λP λd Δλ 560 1300 mcd Viewing Angle 15 deg Peak Emission Wavelength 639 nm Dominant Wavelength 631 nm Spectral Line Half-Width 20 nm Forward Voltage VF 2.0 2.4 V μA IF = 20mA Reverse Current IR 100 VR = 5V Capacitance C 40 pF VF = 0 , f = 1MHz NOTE: 1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE eye-response curve. 2. θ1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity. 3. Iv classification code is marked on each packing bag. 4. The dominant wavelength, λd is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device. Part No. : LTL2H3KRK-012A BNS-OD-C131/A4 Page : 3 of 5 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Typical Electrical / Optical Characteristics Curves (25℃ Ambient Temperature Unless Otherwise Noted) Part No. : LTL2H3KRK-012A BNS-OD-C131/A4 Page : 4 of 5 LITE-ON ELECTRONICS, INC. Property of Lite-On Only Features * Compatible with radial lead automatic insertion equipment. * Most radial lead plastic lead lamps available packaged in tape and folding. * 2.54mm (0.1") straight lead spacing available. * Folding packaging simplifies handling and testing. Package Dimensions Specification Item Tape Feed Hole Diameter Component Lead Pitch Front to Rear Deflection Feed Hole to Bottom of Component Feed Hole to Overall Component Height Lead Length After Component Height Feed Hole Pitch Lead Location Center of Component Location Total Tape Thickness Feed Hole Location Adhesive Tape Width Adhesive Tape Position Tape Width Symbol D F △H H1 H2 L P P1 P2 T W0 W1 W2 W3 Minimum mm 3.8 2.3 -21.5 29.9 W0 12.4 4.4 5.05 -8.5 14.5 0 17.5 0.488 0.173 0.198 -0.334 0.571 0 0.689 inch 0.149 0.091 -0.846 1.177 Maximum mm 4.2 3.0 2.0 22.5 31.5 11.0 13.0 5.8 7.65 0.90 9.75 15.5 3.0 19.0 inch 0.165 0.118 0.078 0.886 1.240 0.433 0.511 0.228 0.301 0.035 0.384 0.610 0.118 0.748 Part No. : LTL2H3KRK-012A BNS-OD-C131/A4 Page : 5 of 5