LTP-12088M-03

LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only LED DISPLAY LTP-12088M-03 DATA SHEET Rev 01 Description RDR Original Spec By Phanomkorn J. July 31, 2008 Phanomkorn J. 02 Change the test condition on page 4-6 to Ip=80mA, 2msec1/8 Duty August 19, 2008 Phanomkorn J. 03 Paper Correction October 15, 2008 Phanomkorn J. NPPR Original Spec December 03, 2008 Phanomkorn J. A Add pin φ on page 2 of 8 January 29, 2009 SPEC. NO.: DATE : DS30-2008-0184 January 29, 2009 A 0 OF 8 REV. NO. : PAGE NO. : PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 0 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only FEATURES ＊1.22 inch (31.0 mm) MATRIX HEIGHT. ＊LOW POWER REQUIREMENT. ＊SINGLE PLANE, WIDE VIEWING ANGLE. ＊SOLID STATE RELIABILITY. ＊8×8 ARRAY WITH X-Y SELECT. ＊COMPATIBLE WITH USASCII AND EBCDIC CODES. ＊STACKABLE HORIZONTALLY. ＊CATEGORIZED FOR LUMINOUS INTENSITY. ＊LEAD-FREE PACKAGE(ACCORDING TO ROHS) DESCRIPTION The LTP-12088M-03 is a 1.22 inch (31.0 mm) matrix height 8 ×8 dot matrix display. This device is multi-color applicable display. The AlInGaP Green LED chips, which are made from AlInGaP on GaAs substrate. The AlInGaP Hyper Red LED chips, which are made from AlInGaP on GaAs substrate. The device has black face and white dot color. The product is binned by luminous intensity and dominant wavelength in the red mode of operation. DEVICE PART NO. MULTI-COLOR LTP-12088M-03 DESCRIPTION Anode Column Cathode Row PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 1 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only PACKAGE DIMENSIONS NOTES: 1. All dimensions are in millimeters. Tolerances are± 0.25 mm (0.01“) unless otherwise noted. 2. Pin tip’s shift tolerance is +/- 0.4 mm. 3. Foreign material on segment ≦10mils 4. Ink contamination (surface) ≦20mils 5. Bending≦1/100 6. Bubble in segment ≦10mils INTERNAL CIRCUIT DIAGRAM PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 2 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only PIN CONNECTION NO CONNECTION NO 13 CONNECTION CATHODE ROW 4 1 ANODE COLUMN 5 AlInGaP GREEN 2 ANODE COLUMN 5 AlInGaP HYPER RED 14 ANODE COLUMN 4 AlInGaP HYPER RED 3 CATHODE ROW 5 15 ANODE COLUMN 4 AlInGaP GREEN 16 CATHODE ROW 3 4 ANODE COLUMN 6 AlInGaP GREEN 5 ANODE COLUMN 6 AlInGaP HYPER RED 17 ANODE COLUMN 3 AlInGaP HYPER RED 6 CATHODE ROW 6 18 ANODE COLUMN 3 AlInGaP GREEN 19 CATHODE ROW 2 7 ANODE COLUMN 7 AlInGaP GREEN 8 ANODE COLUMN 7 AlInGaP HYPER RED 20 ANODE COLUMN 2 AlInGaP HYPER RED 9 CATHODE ROW 7 21 ANODE COLUMN 2 AlInGaP GREEN 22 CATHODE ROW 1 10 ANODE COLUMN 8 AlInGaP GREEN 11 ANODE COLUMN 8 AlInGaP HYPER RED 23 ANODE COLUMN 1 AlInGaP HYPER RED 12 CATHODE ROW 8 24 ANODE COLUMN 1 AlInGaP GREEN PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 3 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only ABSOLUTE MAXIMUM RATING AT Ta=25oC PARAMETER Average Power Dissipation Per Dot Peak Forward Current Per Dot Average Forward Current Per Dot Derating Linear From 25℃ Per Dot Reverse Voltage Per Dot Operating Temperature Range Storage Temperature Range AlInGaP GREEN 70 60 25 0.28 5 -35℃ to +105℃ -35℃ to +105℃ UNIT mW mA mA mA/℃ V Soldering Conditions: 1/16 inch below seating plane for 3 seconds at 2600C or of temperature unit (during assembly) not over max. temperature rating above. ELECTRICAL / OPTICAL CHARACTERISTICS AT Ta=25oC AlInGaP GREEN PARAMETER Average Luminous Intensity Peak Emission Wavelength Spectral Line Half-Width Dominant Wavelength Forward Voltage any Dot Reverse Current any Dot Luminous Intensity Matching Ratio (Similar Light Area) SYMBOL MIN. TYP. MAX. UNIT TEST CONDITION IV λp ∆λ λd VF IR IV-m 9000 22000 571 15 572 2.05 2.3 2.6 2.8 100 2:1 µcd nm nm nm V µA Ip=80mA, Tp =2 ms, 1/8 Duty IF=20mA IF=20mA IF=20mA IF=20mA IF=80mA VR=5V Ip=80mA Tp =2 ms, 1/8 Duty Note: Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (Commission International De L’Eclairage) eye-response curve. PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 4 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only ABSOLUTE MAXIMUM RATING AT Ta=25oC PARAMETER Average Power Dissipation Per Dot Peak Forward Current Per Dot Average Forward Current Per Dot Derating Linear From 25℃ Per Dot Reverse Voltage Per Dot Operating Temperature Range Storage Temperature Range AlInGaP HYPER RED 70 90 25 0.28 5 -35℃ to +105℃ -35℃ to +105℃ UNIT mW mA mA mA/℃ V Soldering Conditions: 1/16 inch below seating plane for 3 seconds at 2600C or of temperature unit (during assembly) not over max. temperature rating above. ELECTRICAL / OPTICAL CHARACTERISTICS AT Ta=25oC AlInGaP HYPER RED PARAMETER Average Luminous Intensity Peak Emission Wavelength Spectral Line Half-Width Dominant Wavelength Forward Voltage any Dot Reverse Current any Dot Luminous Intensity Matching Ratio (Similar Light Area) SYMBOL MIN. TYP. MAX. UNIT TEST CONDITION IV λp ∆λ λd VF IR IV-m 17000 24000 650 20 639 2.1 2.3 2.6 2.8 100 2:1 µcd nm nm nm V µA Ip=80mA Tp =2 ms, 1/8 Duty IF=20mA IF=20mA IF=20mA IF=20mA IF=80mA VR=5V Ip=80mA Tp =2 ms, 1/8 Duty Note: Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (Commission International De L’Eclairage) eye-response curve. PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 5 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only ELECTRICAL / OPTICAL CHARACTERISTICS AT Ta=25oC Amber = AlInGaP HYPER RED + AlInGaP GREEN PARAMETER Average Luminous Intensity Peak Emission Wavelength Spectral Line Half-Width Dominant Wavelength Forward Voltage any Dot (AlInGap Green) Forward Voltage any Dot (AlInGap Hyper Red) Reverse Current any Dot Luminous Intensity Matching Ratio (Similar Light Area) SYMBOL MIN. TYP. MAX. UNIT IV λp ∆λ λd 2800 0 32000 611 17 605 2.05 VF 2.1 IR IV-m 2.6 100 2:1 µA 2.6 V IF=20mA VR=5V Ip=80mA Tp =2 ms, 1/8 Duty µcd nm nm nm TEST CONDITION Ip=80mA Tp =2 ms, 1/8 Duty IF=20mA IF=20mA IF=20mA IF=20mA Note: Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (Commission International De L’Eclairage) eye-response curve. PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 6 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only TYPICAL ELECTRICAL / OPTICAL CHARACTERISTIC CURVES (25oC Ambient Temperature Unless Otherwise Noted) PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 7 of 8 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only TYPICAL ELECTRICAL / OPTICAL CHARACTERISTIC CURVES (25oC Ambient Temperature Unless Otherwise Noted) PART NO.: LTP-12088M-03 BNS-OD-C131/A4 PAGE: 8 of 8