MOC3052M-A

L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only FEATURES * Isolation voltage between input and output Viso : 5,000Vrms * 6pin DIP photocoupler, triac driver output * High repetitive peak off-state voltage VDRM : Min. 600V * High critical rate of rise of off-state voltage ( dV/dt : MIN. 1000V / µs ) * Wide lead spacing package : MOC3052M-A * UL approved ( No. E113898 ) * FIMKO approved ( No. 15469 ) * NEMKO approved ( No. P00102123 ) * DEMKO approved ( No. 309968-01 ) * SEMKO approved ( No. 0032019 / 01-11 ) * CSA approved (No. CA91533-1) * VDE approved (No. 094722) * RoHS compliance FEATURES * Incandescent Lamp Dimmers * Interfacing Microprocessors to 115 and 240 Vac Peripherals * Lamp Ballasts * Motor Controls * Solid State Relays * Static AC Power Switch * Solenoid / Valve Controls * Temperature Controls Part No. : MOC3052M-A BNS-OD-C131/A4 Page : 1 of 7 L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only OUTLINE DIMENSIONS Wide lead spacing package: *1. *2. *3. *4. Year date code. 2-digit work week. Factory identification mark shall be marked (Z : Taiwan, Y : Thailand). Model No.: MOC3052M-A Part No. : MOC3052M-A BNS-OD-C131/A4 Page : 2 of 7 L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only \ ABSOLUTE MAXIMUM RATING ( Ta = 25°C ) PARAMETER Forward Current INPUT Reverse Voltage Power Dissipation Off-State Output Terminal Voltage OUTPUT Peak Repetitive Surge Current ( PW=1ms, 120pps ) Collector Power Dissipation Total Power Dissipation *1 Isolation Voltage Ambient Operating Temperature Range Storage Temperature Range *2 Soldering Temperature SYMBOL IF VR PD VDRM VTSM PC Ptot Viso TA Tstg TL RATING 50 6 70 600 1 300 330 5,000 -40 ~ +100 -55 ~ +150 260 UNIT mA V mW V A mW mW Vrms °C °C °C *1. AC For 1 Minute, R.H. = 40 ~ 60% Isolation voltage shall be measured using the following method. (1) Short between anode and cathode on the primary side and between collector, emitter on the secondary side. (2) The isolation voltage tester with zero-cross circuit shall be used. (3) The waveform of applied voltage shall be a sine wave. *2. For 10 Seconds Part No. : MOC3052M-A BNS-OD-C131/A4 Page : 3 of 7 L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only ELECTRICAL - OPTICAL CHARACTERISTICS ( Ta = 25°C ) PARAMETER Forward Voltage INPUT Reverse Current *1 Peak Blocking Current, Either Direction OUTPUT Peak On-State Voltage, Either Direction *2 Critical rate of Rise of Off-State Voltage IR IDRM — — — 10 10 100 µA nA VR=6V VDRM = 600V SYMBOL MIN. TYP. MAX. UNIT VF — 1.2 1.4 V CONDITIONS IF=20mA VTM — — 1.9 V V/µs ITM=100 mA Peak dv/dt 1000 — — Led Trigger Current, Current *3 Required to Latch Output, Either Direction Holding Current, Either Direction IFT — － 10 mA Main Terminal Voltage = 3V COUPLED IH — 400 — µA Turn-On time ton — 80 200 µs VD=9V, IF=20mA RL=100Ω *1 Test voltage must be applied within dv/dt rating. *2 This is static dv/dt. Commutating dv/dt is a function of the load-driving thyristor(s) only. *3 All devices are guaranteed to trigger at an IF value less than or equal to max IFT. Therefore, recommended operating IF lies between max 10mA for MOC3052 and absolute max IF (50mA) Part No. : MOC3052M-A BNS-OD-C131/A4 Page : 4 of 7 L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only CHARACTERISTICS CURVES Fig.1 Forward Current vs. Ambient Temperature 60 Forward current I F (mA) Fig.2 On-state Current vs. Ambient Temperature ITM , on-state current (A) 50 40 30 20 10 0 -40 -20 0.10 0.05 0 20 40 60 80 100 120 o 0 -40 -20 0 20 40 60 80 100 120 o Ambient temperature Ta ( C) Ambient temperature Ta ( C) Fig.3 Minimum Trigger Current vs. Ambient Temperature 10 Minimum trigger current I FT (mA) Fig.4 Forward Current vs. Forward Voltage 100 VP= 6V RL= 100 Forward current I F (mA) 8 6 4 2 0 20 40 60 80 o 80 C o 100 C 10 o 60 C o 40 oC 20 C o 1 100 0.4 0.8 1.2 1.6 2.0 Ambient temperature ( C) Forward voltage VF (V) Fig.5 On-state Voltage vs. Ambient Temperature 3.0 I TM= 100mA On-state voltage VTM(V) Fig.6 Holding Current vs. Ambient Temperature 1 VP= 6V Forward current I H (mA) 2.6 2.2 1.8 1.4 1.0 20 40 60 80 o 0.1 0.01 100 20 40 60 80 o 100 Ambient temperature Ta ( C) Ambient Temperature Ta ( C) Part No. : MOC3052M-A BNS-OD-C131/A4 Page : 5 of 7 L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only CHARACTERISTICS CURVES Fig.7 Turn-on Time vs. Forward Current 80 Fig.8 Repetitive Peak Off-state Current vs. Temperature 1000 Turn-on time Ton ( s) VP= 9V RL= 100 60 Repetitive Peak Off-state Current Idrm (nA) 100 40 10 20 0 10 20 30 40 50 1 20 40 60 80 O 100 Forward current I F (mA) Ambient temperature Ta ( C) Fig.9 On-state Current vs. On-state Voltage 100 Basic Driver Circuit TRIAC DRIVER + Vcc RLED 1 2 Q 3 4 POWER TRIAC 5 6 R LOAD On-state current ITM (mA) 80 CONTROL 60 RET. 40 20 0 AC LINE RLED= (Vcc-VF LED-VsatQ)/ IFT R= Vp AC line/ITSM 0 0.5 1.0 1.5 2.0 2.5 3.0 On-state voltage VTM (V) RECOMMENDED FOOT PRINT PATTERNS (MOUNT PAD) Unit : mm Part No. : MOC3052M-A BNS-OD-C131/A4 Page : 6 of 7 L ITE- O N TECH NO LO G Y CO RP O RATIO N Property of LITE-ON Only Notes - Lite-On is continually improving the quality, reliability, function or design and Lite-On reserves the right to make changes without further notices. - The products shown in this publication are designed for the general use in electronic applications such as office automation equipment, communications devices, audio/visual equipment, electrical application and instrumentation. - For equipment/devices where high reliability or safety is required, such as space applications, nuclear power control equipment, medical equipment, etc, please contact our sales representatives. - When requiring a device for any ”specific” application, please contact our sales in advice. - If there are any questions about the contents of this publication, please contact us at your convenience. - The contents described herein are subject to change without prior notice. - No contacting with pin 5. - Inhibit immersing unit’s body in solder paste. Part No. : MOC3052M-A Page : 7 of 7