P1602ACMCLXX

SIDACtor ® Protection Thyristors Broadband Optimized™ Protection MC Series - Modified TO-220 Description MC Series Modified TO-220 are low capacitance SIDACtor® devices designed to protect various types of broadband equipment from damaging overvoltage transients. The series provides a robust single port solution that enables equipment to comply with various global regulatory standards while limiting the impact to broadband signals. Features and Benefits Low voltage overshoot Agency Approvals Agency Agency File Number E133083 Low on-state voltage Does not degrade with use Fails short circuit when surged in excess of ratings Robust Modified TO-220 Package Applicable Global Standards TIA-968-A PIN 1 PIN 2 PIN 3 40% lower capacitance than our Baseband Protectors, for applications that demand greater signal integrity Custom lead forms available Pinout Designation GR 1089 Intra-building* IEC 61000-4-5 YD/T 1082 YD/T 993 YD/T 950 TIA-968-B ITU K.20/21 Enhanced Level ITU K.20/21 Basic Level GR 1089 Inter-building* *A-rated parts require series resistance Schematic Symbol 1 (T) 3 (R) 2 (G) Electrical Characteristics VDRM VS VDRM VS IH mA min Pins 1-2, 3-2 50 80 80 154 190 260 320 360 440 500 50 50 50 150 150 150 150 150 150 150 IS mA max 800 800 800 800 800 800 800 800 800 800 IT A max 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 VT @ IT=2.2 Amps V min 4 4 4 4 4 4 4 4 4 4 @lDRM=5μA @100V/μs @lDRM=5μA @100V/μs Part Number Marking Capacitance V min V max V min V max Pins 1-2, 3-2 P0302AAMCLxx P0302AAMC P0602AAMCLxx P0602AAMC P0602ACMCLxx P0602ACMC P1402ACMCLxx P1402ACMC P1602ACMCLxx P1602ACMC P2202ACMCLxx P2202ACMC P2702ACMCLxx P2702ACMC P3002ACMCLxx P3002ACMC P3602ACMCLxx P3602ACMC P4202ACMCLxx P4202ACMC 6 25 25 58 65 90 120 140 170 190 25 40 40 77 95 130 160 180 220 250 12 50 50 116 130 180 240 280 340 380 Pins 1-3 See Capacitance Values Table Table continues on next page. © 2011 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com for current information. 80 Revised: February 22, 2011 SIDACtor ® Protection Thyristors Broadband Optimized™ Protection Electrical Characteristics (continued) VDRM VS VDRM VS VT @ IT=2.2 Amps Capacitance V min 4 4 See Capacitance Values Table Part Number Marking @lDRM=5μA @100V/μs @lDRM=5μA @100V/μs IH mA min Pins 1-2, 3-2 150 150 IS mA max 800 800 IT A max 2.2 2.2 V min P4802ACMCLxx P6002ACMCLxx P4802ACMC P6002ACMC 220 275 V max 300 350 V min 440 550 V max 600 700 Pins 1-2, 3-2 Pins 1-3 Notes: - Absolute maximum ratings measured at TA= 25ºC (unless otherwise noted). - Devices are bi-directional (unless otherwise noted). - XX Part Number Suffix: ‘RP’ (Reel Pack), Blank (Bulk Pack), or ‘60’ (Type 60 lead form, Bulk Pack. Special order item -- contact factory.) Capacitance Values pF Pin 1-2 / 3-2 Tip-Ground, Ring-Ground MIN MAX 25 55 15 35 25 45 40 60 35 55 45 70 40 60 35 55 35 50 30 50 30 45 30 45 pF Pin 1-3 Tip-Ring MIN MAX 15 35 10 20 10 25 20 35 20 35 25 40 20 35 20 35 15 30 15 30 15 30 15 25 Part Number P0302AAMCLxx P0602AAMCLxx P0602ACMCLxx P1402ACMCLxx P1602ACMCLxx P2202ACMCLxx P2702ACMCLxx P3002ACMCLxx P3602ACMCLxx P4202ACMCLxx P4802ACMCLxx P6002ACMCLxx Note: Off-state capacitance (CO) is measured at 1 MHz with a 2 V bias. Surge Ratings IPP Series 0.2x310 0.5x700 2 1 2x10 2x10 2 1 8x20 1.2x50 2 1 10x160 10x160 2 1 10x560 1 10x560 2 A min 50 150 5x320 1 9x720 2 A min 75 200 10x360 1 10x360 2 A min 75 175 10x1000 1 10x1000 2 A min 45 100 5x310 1 10x700 2 A min 75 200 ITSM 50/60 Hz A min 20 30 di/dt A/μs Max 500 500 A min A C Notes: 1 Current waveform in μs 2 Voltage waveform in μs A min 150 500 A min 150 400 A min 90 200 20 50 - Peak pulse current rating (IPP) is repetitive and guaranteed for the life of the product. - IPP - The device must initially be in thermal equilibrium with -40°C < TJ < © 2011 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com for current information. 81 Revised: February 22, 2011 SIDACtor ® Protection Thyristors Broadband Optimized™ Protection Thermal Considerations Package Modified TO-220 Symbol TJ TS PIN 1 PIN 2 PIN 3 Parameter Operating Junction Temperature Range Storage Temperature Range Thermal Resistance: Junction to Ambient Value Unit °C °C R0JA 50 °C/W V-I Characteristics +I tr x td Pulse Waveform tr = r ise time to peak value td = decay time to half value IPP – Peak Pulse Current – %IPP IT IS IH IDRM -V VT VDRM VS +V 100 Peak Value Waveform = tr x td 50 Half Value 0 0 -I tr td t – Time (μs) Normalized VS Change vs. Junction Temperature Normalized DC Holding Current vs. Case Temperature 2.0 Percent of VS Change – % 12 IH (TC = 25ºC) 14 10 8 6 4 2 0 -4 -6 -8 -40 -20 0 20 40 60 80 100 120 140 160 1.8 1.6 1.4 1.2 1.0 0.8 0.6 0.4 -40 -20 0 20 40 60 80 100 120 140 160 IH 25 °C 25°C Ratio of Junction Temperature (TJ) – °C Case Temperature (TC) - ºC © 2011 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com for current information. 82 Revised: February 22, 2011 SIDACtor ® Protection Thyristors Broadband Optimized™ Protection Soldering Parameters Pb-Free assembly (see Fig. 1) Reflow Condition - Temperature Min (Ts(min)) Figure 1 TP Ramp-up tP Critical Zone TL to TP Pre Heat - Temperature Max (Ts(max)) - Time (Min to Max) (ts) 60-180 secs. 3°C/sec. Max. 3°C/sec. Max. 60-150 secs. Temperature Average ramp up rate (Liquidus Temp (TL) to peak) TS(max) to TL - Ramp-up Rate Reflow - Temperature (TL) (Liquidus) - Temperature (tL) TL TS(max) Preheat tL Ramp-down TS(min) tS Peak Temp (TP) Time within 5°C of actual Peak Temp (tp) Ramp-down Rate Time 25°C to Peak Temp (TP) Do not exceed 30 secs. Max. 6°C/sec. Max. 8 min. Max. 25 time to peak temperature (t 25ºC to peak) Time Physical Specifications Lead Material Terminal Finish Body Material Copper Alloy 100% Matte-Tin Plated Environmental Specifications High Temp Voltage Blocking 80% Rated VDRM (VAC Peak 504 or 1008 hrs. MIL-STD-750 (Method 1040) JEDEC, JESD22-A-101 cycles. MIL-STD-750 (Method 1051) EIA/JEDEC, JESD22-A104 52 VDC JEDEC, JESD22-A-101 JEDEC, JESD22-A-101 -65°C, 1008 hrs. 10 cycles. MIL-STD-750 (Method 1056) JEDEC, JESD22-A-106 JEDEC, JESD22-A-102 Temp Cycling UL recognized epoxy meeting flammability classification 94V-0 Biased Temp & Humidity High Temp Storage Low Temp Storage Thermal Shock Autoclave (Pressure Cooker Test) Resistance to Solder Heat Moisture Sensitivity Level © 2011 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com for current information. 83 Revised: February 22, 2011 SIDACtor ® Protection Thyristors Broadband Optimized™ Protection Part Numbering P xxx 2 A x MC L xx TYPE P = SIDACtor MEDIAN VOLTAGE CONSTRUCTION VARIABLE PACKAGE TYPE Blank, RP or 60 -- for Type 60 orders, contact factory Part Marking XXXXXXXXX Part Marking Code (Refer to Electrical Characteristics Table) PACKING OPTIONS RoHS COMPLIANT MC Series xxxxx Date Code IPP RATING Dimensions - Modified TO-220 A O Tape and Reel Specification — Modified TO-220 Inches Min Max 0.410 0.375 0.130 0.575 0.035 0.205 0.105 0.075 0.085 0.024 0.188 0.310 Millimeters Min 9.14 2.80 0.63 4.95 2.41 1.52 1.78 0.46 4.52 7 .37 Max 1.626 (41.15) 0.240 (6.10) 0.019 (0.5) 0.750 ± 0.010 (19.05 ± 0.25) 0.360 (9.14) 0.500 (12.7) D A F Temperature Measurement Point P PIN 3 PIN 2 PIN 1 L K H J M N 0.400 0.360 0.110 0.540 0.025 0.195 0.095 0.060 0.070 0.018 0.178 0.290 10.16 10.42 9.53 3.30 0.89 5.21 2.67 1.90 2.16 0.61 4.78 7 .87 D F G H J K L M 0.720 (18.29) G 13.71 14.61 0.100 (2.54) 0.100 (2.54) 14.173 (360.0) Dimensions are in inches (and millimeters). Direction of Feed The modified TO-220 package is designed to meet mechanical standards as set forth in JEDEC publication number 95. N O P 1.968 (50.0) Packing Options Package Type Description Modified TO-220 Tape and Reel Pack A Modified TO-220 Bulk Pack Modified TO-220, Type 60 Lead Form Bulk Pack Quantity 700 500 500 Added Suffix RP N/A 60 (special order item, contact factory for details) Industry Standard EIA-468-B N/A N/A © 2011 Littelfuse, Inc. Specifications are subject to change without notice. Please refer to www.littelfuse.com for current information. 84 Revised: February 22, 2011