AMC-151

AM-151/AMC-151 Cascadable Amplifier 10 to 500MHz Features • NOISE FIGURE: 5 dB (TYP.) • HIGH THIRD ORDER IP: +38 dBM (TYP.) • P1dB: +21 dBm (TYP.) Rev. V5 Product Image Description The AM-151 amplifier uses a coupler feedback design with high intercept and compression points. The use of coupler feedback minimized noise figure and DC current in a high intercept amplifier. This amplifier is packaged a TO-8 package. Due to the internal power dissipation, the thermal rise is minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-151 is ideally suited for use where a high intercept high reliability amplifier is required. Ordering Information Part Number AM-151-PIN* AMC-151- SMA** Absolute Maximum Ratings Parameter Package TO-8-1 SMA Connectorized Maximum Input Power DC Voltage Continuous Input Power Operating Temperature Storage Temperature +20 dBm +15.75 V +18 dBm -55º to +85ºC -65º to +125ºC Absolute Maximum *Mounting kit part number AU00071 required for PCB application **SMA Connectorized part is not RoHs compliant. Electrical Specifications: Z0 = 50Ω, VCC = +15 VDC** Parameter Gain Frequency Response Gain Variation with Temperature 1 dB Compression Noise Figure (max) Reverse Transmission VSWR Output IP Output IP V bias I bias Power Dissiapation V bias = +15 Vdc @ +15 V Bias 2 3 Test Conditions @ +25oC Frequency 50 MHz 5-500 MHz 5-500 MHz Units MHz dB dB dBm dBm dB dB Ratio dBm dBm dBm mA mW Min. 11.5 Typ. 12.0 Max. 12.5 ±1.0 ±0.8 Output Power 5-500 MHz 10-500 MHz 5-500 MHz 5-500 MHz 5-500 MHz +19 +20 7.0 -16.0 -13.0 2.0:1 +48 +34 +14.5 +15.0 85 1275 +15.5 100 Two-tone inputs up to +10 dBm Two-tone inputs up to +10 dBm 5-500 MHz 5-500 MHz ***Heat Sinking: Operation at case temperature above +95oC is not recommended. Heat sinking adequate to dissipate 1.3 W must be provided in use. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-151/AMC-151 Cascadable Amplifier 10 to 500MHz Typical Performance Curves at +25°C Gain Rev. V5 Outline Drawing: TO-8-1 * DC IN RF IN RF OUT .150 TYP. (3.8) .300 (7.6) TYP. GND 4X Ø .018+/-.005 (0.46+/-0.13) .220 MIN (5.6) .220 (5.6) M AX .450 (11.4) Ø .50 (12.7+0.5) WEIGHT (APPROX) 0.10 OUNCES 2.8 GRAMS Outline Drawing: SMA Connectorized * 1.344 (34.14) .562 (14.28) DC IN .457 (11.61) 0.72 (17.07) 1.344 (34.14) 2X CONNECTOR .672 (17.1) 2X .12 112-40 UNC-2B .46 20 Ø 1.000 (25.4) .750+/-.020 (19.05)+/-0.5 .375+/-.020 (9.53+/-0.51) WEIGHT (APPROX) 1.62 OUNCES 46 GRAMS ∗ Dimensions in ( ) are in mm. Unless otherwise noted: .XXX = + .010” (.XX = + 0.25) .XX = + 0.02 (.X = + 0.5) 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.