AMC-182

AM-182 / AMC-182 Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz Features • 28.5 dB Typical Gain • 2.7 dB Typical Low Noise Rev. V4 TO-8-1 Description M/A-COM’s AM-182 is a high gain feedback amplifier with high intercept and compression points. This amplifier is packaged in a TO-8 package. Due to the internal power dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-182 is ideally suited for use where a high intercept, high reliability amplifier is required. Ordering Information Part Number AM-182 PIN AMC-182 SMA Package TO-8-1 Connectorized Outline Drawing: SMA Connectorized * Absolute Maximum Ratings 1 Parameter Max. Input Power Vbias Operating Temperature Storage Temperature Absolute Maximum +13 dBm +15.75 V -55°C to +85°C -65°C to +125°C 1. Operation of this device above any one of these parameters may cause permanent damage. ∗ Dimensions are inches (millimeters) ±0.015 (0.38) unless otherwise specified. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-182 / AMC-182 Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz Electrical Specifications: 2,3 TA = -55°C to +85°C Case Temperature Parameter Gain Rev. V4 Test Conditions @+25oC Frequency 300 MHz Units dB Min. 27.2 Typ. 28.2 Max. 29.2 Frequency Response Gain Variation with Temperature 1 dB Compression Noise Figure Reverse Transmission VSWR Output IP2 Output IP3 Vbias Ibias Power Dissipation — — Output Power — — — Two-Tone inputs up to 0 dBm Two-Tone inputs up to 0 dBm 5 - 1000 MHz 5 - 1000 MHz 5 - 1000 MHz 5 - 1000 MHz 5 - 1000 MHz 5 - 1000 MHz 5 - 1000 MHz 5 - 1000 MHz — — — dB dB dBm dB dB Ratio dBm dBm VDC mA mW — — +9 — — — +28 +18 +14.5 — — — — — — -36 — — — +15.0 44 660 ±1.2 ±1.2 — 4.5 -32 2.0:1 — — +15.5 50 — — Vbias = +15.0 VDC @ +15 V Bias 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 800 mW must be provided in use. 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-182 / AMC-182 Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz Typical Performance Curves Rev. V4 3 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.