1EGS1-1

CORCOM Product Guide Smallest Filtered Power Entry Modules with Metric Fuseholders GG/HG Series UL Recognized CSA Certified VDE Approved HG1/GG1 GG8 GG Series The GG series power entry modules combine the functions of a general purpose RFI filter with an IEC power cord connector and single or dual metric fusing, in the smallest possible panel space. A choice of .250” terminals or wire leads is available for the load-side terminations. For maximum cost effectiveness, 6 amp models should be used for all applications rated 6 amps or less, unless the higher performance of the 3 amp models, or the much higher performance of the 1 amp models, is needed. Models with C-suffix additionally incorporate a ground choke1 to isolate the equipment chassis from external ground at RF frequencies. Specifications Maximum leakage current,each line-to-ground HG Models @ 120 VAC 60 Hz: 2 µA @ 250 VAC 50 Hz: 5 µA Hipot rating (one minute): line-to-ground line-to-line Operating frequency: Rated voltage (max.): Fuse (not included): GG Models .25 mA .42 mA 1550 VAC 1450 VDC 50/60 Hz 250 VAC Accepts one 5x20mm fuse (-1 models) or two 5 x 20 mm fuses (-2 models) .250 [6.35mm] terminals (G1) 5" wire leads (EGG8) HG Series A medical version of our GG series, these filters offer the same compact design but reduce the line-to-ground capacitance in order to meet UL 2601 patient care requirements. Terminals: Minimum insertion loss in dB: Line-to-ground in 50 ohm circuit Current Rating .01 GG/GS Models 1A 12 3A – 6A – HG Models 1A 12 3A – 6A – .05 23 10 1 23 10 4 Frequency-MHz .10 .15 .5 1 5 29 15 4 29 15 10 32 19 10 32 19 14 41 30 16 40 25 18 47 36 22 40 26 18 50 48 36 28 22 14 10 50 50 40 22 21 14 30 55 53 50 18 21 14 Electrical Schematics GG/GS/HG LINE LOAD Note 1 Note 2 GG-C LINE LOAD Line-to-line in 50 ohm circuit Current Rating GG/GS Models 1A 3A 6A HG Models 1A 3A 6A .01 1 1 1 1 1 1 .15 3 2 2 3 2 2 Frequency-MHz .5 1 3 5 14 11 10 26 30 30 23 14 13 35 30 30 41 25 23 35 30 30 47 38 33 35 30 30 10 50 44 39 27 30 30 30 44 40 42 20 30 30 Note 1 Note 2 Resistor location for reference only. Note 1: Depicts single fuse for -1 models. Note 2: For HG delete line-to-ground capacitors. CAUTION: DO NOT ATTEMPT TO OPERATE A SINGLE-FUSED MODEL WITHOUT THE FUSE DOOR IN PLACE! 102 Catalog 1654001 Revised 03-04 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. USA Cust. Svc.: 1-800-468-2023 CORCOM Prods: 1-847-680-7400 1-508-992-4495 Germany: 49-89-6089-0 www.cor.com www.tycoelectronics.com CORCOM Product Guide Smallest Filtered Power Entry Modules with Metric Fuseholders (Continued) GG/HG Series Case Styles GG1/HG1 D 1.22 [30.9] C EGS C E A B D E A B Power Entry Modules Recommended Panel Cutout GG/HG Typical dimensions: Terminals: .250 [6.35] (3) Holes: .07 [1.8] Dia. Mounting Holes: .126 [3.20] Dia. (2) 1.30 33.0 1.14 29.0 1.417 36.0 .138 Dia. 3.5 Snap-In Version (EGS) 1.29 32.76 1.18 R .010 29.97 .25 for panel thickness .032-.080 [.81-2.03] GG8 Blue Green/Yellow Brown Front or back mounting. R .138 3.5 Case Dimensions B C .6 15.2 D E A Typical dimensions: Wire leads: 5.0 [127.0] Min. 18 AWG Mounting Holes: .126 [3.20] Dia. (2) A B C D E ± .015 (max) (max) (max) ± .38 (max) 1.66 1.13 1.29 1.417 1.76 42.2 28.7 32.8 36.0 44.7 2.02 1.13 1.29 1.417 1.76 EGG8-1/EGG8-2 51.1 28.7 32.8 36.0 44.7 1.13 1.29 1.417 1.76 EGG1C-1/EGG1C-2 2.02 62.2 28.7 32.8 36.0 44.7 2.02 1.13 1.29 1.417 1.76 EGG8C-1/EGG8C-2 51.1 28.7 32.8 36.0 44.7 1.50 1.13 1.29 1.46 1.42 EGS1-1/EGS1-2 38.1 28.7 32.5 36.0 36.1 *HG 1-2 models same as GG 1-2. Part No. EGG1-1/EGG1-2/ EHG1-2 Load Side Terminations Terminals Terminals Wire Leads Wire Leads Terminals Terminals Terminals Terminals Wire Leads Wire Leads Terminals Terminals Terminals Terminals Wire Leads Wire Leads Terminals Terminals Terminals Terminals Terminals Part Number RFI Filter Type Current Rating3 Metric Fuseholders 1EGG1-1 General Purpose2 1 1 1EGG1-2 General Purpose 1 2 1EGG8-1 General Purpose 1 1 1EGG8-2 General Purpose 1 2 1EGS1-1 General Purpose 1 1 1EGS1-2 General Purpose 1 2 3EGG1-1 General Purpose 3 1 3EGG1-2 General Purpose 3 2 3EGG8-1 General Purpose 3 1 3EGG8-2 General Purpose 3 2 3EGS1-1 General Purpose 3 1 3EGS1-2 General Purpose 3 2 6EGG1-1 General Purpose 6 1 6EGG1-2 General Purpose 6 2 6EGG8-1 General Purpose 6 1 6EGG8-2 General Purpose 6 2 6EGS1-1 General Purpose 6 1 6EGS1-2 General Purpose 6 2 1EHG1-2 Medical 1 2 3EHG1-2 Medical 3 2 6EHG1-2 Medical 6 2 1 Ground choke available on general purpose models. Add suffix (1EGG1C-1). Does not include EGS models. 2 General purpose filter for susceptibility applications. 3 Current rating @120 VAC and 250 VAC. 103 Catalog 1654001 Revised 03-04 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. USA Cust. Svc.: 1-800-468-2023 CORCOM Prods: 1-847-680-7400 1-508-992-4495 Germany: 49-89-6089-0 www.cor.com www.tycoelectronics.com