AHRF650_1

PolySwitch® PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device PRODUCT: AHRF650 Raychem Circuit Protection Products DOCUMENT: SCD 25185 PCN: A43987 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 1 OF 2 Specification Status: RELEASED Electrical Rating Voltage: 16VDC MAX Insulating Material: Cured, Flame Retardant Epoxy Polymer Lead Material: 20 AWG Tin Plated Copper (0.8 mm [0.032] nom. diameter) Part Marking: Raychem Logo and Voltage 16 HF6.5 Part Identification Lot Identification (can be on back) TABLE I. INSTALLATION ENVELOPE DIMENSIONS: A B MIN MAX MIN MAX -12.7 -22.2 -(0.50) -(0.88) *Rounded off approximation CURRENT RATINGS TIME TO TRIP C MIN 4.3 (0.17) MAX 5.8 (0.23) MIN 7.6 (0.30) D MAX --MIN --E MAX 3.0 (0.12) F TYP 1.2 (0.05) G MIN --MAX 5.08 (0.20) mm: in*: TABLE II. PERFORMANCE RATINGS: RESISTANCE Ra MAX OHMS AT 25°C 0.026 TRIPPED-STATE POWER DISSIPATION WATTS AT 25°C TYP 4.3 AMPS SECONDS AT AT 25°C 25°C, 32.5 A HOLD TRIP MAX 6.5 13.7 7.0 Reference Documents: Precedence: Effectivity: CAUTION: OHMS AT 25°C MIN MAX 0.009 0.018 PS400, PS300 (reference for R1 MAX) This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. © 2002, 2007 Tyco Electronics Corporation. All rights reserved. PolySwitch® PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device PRODUCT: AHRF650 Raychem Circuit Protection Products DOCUMENT: SCD 25185 PCN: A43987 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability TEST CONDITIONS (see note 2) 25kV 25 cycles, 16V, 200A Fault Current Durability End-of-life Mode Verification Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 350 cycles, 16V/100A 1750 cycles, 16V/100A 3 cycles, 26V, 1 minute duration 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures