MASYVS0061-1066B

Synthesizer , SMT 1046 — 1085 MHz, 200 kHz Features ♦ Fully Integrated VCO, PLL, Loop Filter ♦ High Performance, Low Cost ♦ Miniature SMT Package (LSM6) MASYVS0061-1066 Rev: E Description This synthesizer design integrates a high performance VCO, PLL, IC and discrete loop filter in a surface mount package. This SMT package provides electrical shielding, easy PCB assembly and repeatable performance. The synthesizer is designed for use in wireless base stations. M/A-COM synthesizers are manufactured in an ISO9001 certified facility, incorporating surface mount assembly and automated electrical testing. This ensures consistent electrical performance and quality over volume production quantities. Electrical Specifications1: TA = +25°C, Z0 = 50 Ohms, Fref = 10MHz, Vcc1 = 5V, Vcc2 = 3.3V. Parameter Frequency Range RF Output Power Phase Noise Test Conditions Over Top 2 Units MHz dBm dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc Min 1046 +2.5 Typ Max 1085 +7.5 Over Top 2 SSB at 600 kHz offset from carrier SSB at 800 kHz offset from carrier SSB at 1800 kHz offset from carrier SSB at 6000 kHz offset from carrier -145 -151 -153 -160 -33 -85 -87 -93 -97 -100 -144 -148 -151 -157 -20 -79 -84 -90 -95 -97 450 Harmonic Suppression Spurious Suppression (Non-Harmonic) Phase comparison frequency ( ± 200 kHz) ± 400 kHz ± 600 kHz ± 800 kHz Reference breakthrough ( ± 10 MHz) Over Fout , Measured to within ± 4 degrees Measured over 577υs time slot Measured over 577υs time slot Recommended operating condition Recommended operating condition Recommended operating condition Recommended operating condition dBc dBc dBc dBc dBc υs Degree Degree mA mA V V +4.75 +3.1 Frequency Lock Time Phase Error (rms) Phase Error (peak) VCO Supply Current (ICC1) PLL Supply Current (ICC2) VCO Power Supply (VCC1) PLL Power Supply (VCC2) 0.6 1.7 47 13 +5.00 +3.3 1.0 4 55 15 +5.25 +3.5 1. All specification limits are indicated values @ +25 ºC and apply over Fout unless otherwise stated. 2. Top = -40ºC to +85ºC operating temperature. 1 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/ACOM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/ACOM assume any liability whatsoever arising out of the use. or application of any product(s) or information. • North America Tel: 800.366.2266 / Fax: 978.366.2266 • Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 • Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information. Synthesizer , SMT 1046 — 1085 MHz, 200 kHz Electrical Specifications1: (cont’d) Parameter Step Size (∆F) Reference Frequency (FR) PLL Programming PLL Lock Monitor Output Test Conditions Recommended operating limit 1.0 V pp ± 0.2V square wave with input filter Units kHz MHz MASYVS0061-1066 Min Typ 200 Max 10 100 3-wire serial CMOS IAW ADF4113, Charge Pump 5 mA Logic high = VCC2 x 0.8 Min and Logic low = VCC2 x 0.2 Max Locked = VCC2 - 0.4 Min , Unlocked = 0.4V Max Pin Configuration Pin No. 1 2 3 4 5 6 7 Function VCC1 GND REF I/P GND VCC2 GND RF O/P Pin No. 8 9 10 11 12 13 14 Function GND Lock Detect Clock Data Load Enable GND GND Absolute Maximum Ratings TA = +25°C Parameter VCO Supply Voltage (VCC1) PLL Supply Voltage (VCC1) Reference Frequency Level Data, Clock, Strobe Voltages Operating Temperature Storage Temperature Solder Assembly Temperature Absolute Maximum -0.3V to 6.5 V -0.3V to 6.5 V -0.3V to 6.5 V -0.3V to Vcc + 0.3 V -40°C to +85°C -45°C to +120°C See App Note M2032 Functional Block Diagram 1. Operation of this device above any one of these parameters may cause permanent damage. 2. Static sensitive, observe appropriate handling precautions. Environmental Specifications Devices are designed to function after exposure to the shock, vibration, thermal shock and moisture conditions typically encountered in base station and other infrastructure environments. Ordering Information Part Number MASYVS0061-1066 B 1. The diagram above shows a typical application. 2. The Reference input and RF output are internally AC coupled. 3. The diagram applies when digital lock detect is selected. For analog open-drain mode, a filter is required. See AN3003 for design information. MASYVS0061-1066 T MASYVS0061-1066 R Package Bulk Packaging Tape and Reel (300/Reel) 1 Reverse Tape and Reel (300/Reel) 1 1. See application note M513. 2 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/ACOM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/ACOM assume any liability whatsoever arising out of the use. or application of any product(s) or information. • North America Tel: 800.366.2266 / Fax: 978.366.2266 • Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 • Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information. Synthesizer , SMT 1046 — 1085 MHz, 200 kHz Recommended PCB Layout MASYVS0061-1066 Outline Drawing 3 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/ACOM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/ACOM assume any liability whatsoever arising out of the use. or application of any product(s) or information. • North America Tel: 800.366.2266 / Fax: 978.366.2266 • Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 • Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.