MST

MS MSD MSDD MST ■ ■ ■ TO-5 HIGH-PERFORMANCE RELAYS MS SENSITIVE TO-5 HIGH-PERFORMANCE RELAY MSD SENSITIVE TO-5 DIODE SUPPRESSED HIGH-PERFORMANCE RELAY MSDD SENSITIVE TO-5 DIODE SUPPRESSED/PROTECTED HIGH-PERFORMANCE RELAY MST SENSITIVE TO-5 DIODE SUPPRESSED/TRANSISTOR DRIVEN HIGH-PERFORMANCE RELAY QUALIFIED TO MIL-R-39016/11 QUALIFIED TO MIL-R-39016/16 QUALIFIED TO MIL-R-39016/21 QUALIFIED TO MIL-R-28776/3 – X1 A2 A1 A3 B3 X2 B2 B1 A2 A1 A3 X2 + X1 B2 B1 B3 A2 A1 – X2 + – X1 B2 B1 X2 A2 A1 A3 B3 XB + X1 B2 B1 A3 B3 TERMINAL VIEW TERMINAL VIEW TERMINAL VIEW TERMINAL VIEW FEATURES ■ ■ FEATURES ■ ■ ■ FEATURES ■ FEATURES ■ Hermetically sealed High shock & vibration ratings ■ Spreader pads ■ Excellent RF switching Suppression diode Hermetically sealed High shock & vibration ratings ■ Spreader pads ■ Excellent RF switching Suppression & protection diodes ■ Hermetically sealed ■ High shock & vibration ratings ■ Spreader pads ■ Excellent RF switching CONTACT RATINGS Transistor driver & suppression diode ■ Hermetically sealed ■ High shock & vibration ratings ■ Spreader pads ■ Excellent RF switching ELECTRICAL CHARACTERISTICS CONTACT ARRANGEMENT 2 Form C (DPDT) CONTACT MATERIAL CONTACT LOAD TYPE OPERATIONS MIN. Stationary: Gold/platinum/palladium/silver alloy (gold plated) Moveable: Gold/platinum/palladium/silver alloy (gold plated) CONTACT RESISTANCE 1.0 A @ 28 Vdc 250 mA @ 115 Vac, 60 Hz & 400 Hz 100 mA @ 115 Vac, 60 Hz & 400 Hz 0.2 A @ 28 Vdc 0.1 A @ 28 Vdc 30 µA @ 50 mVdc 0.1 A @ 28 Vdc Resistive 100,000 Resistive (case not grounded) 100,000 Resistive 100,000 Inductive (0.32 Henry) 100,000 Lamp 100,000 Low Level 1,000,000 Intermediate Current 50,000 Before Life: 100 milliohms max. (measured @ 10 mA @ 6 Vdc) After Life: 200 milliohms max. (measured @ 1 A @ 28 Vdc) MECHANICAL LIFE EXPECTANCY .375 (9.53) MAX .335 (8.51) DIA MAX .370 (9.40) DIA MAX .031 ± .003 (0.79) .035 (0.89) TRANSISTOR BASE CONNECTION (MAT ONLY) TERMINALS W 1.500 MIN (38.1) 36° ± 3° C .500 MIN (12.7) P .187±.010 (4.75±.25) (Length excludes mounting pad) 1 million operations COIL VOLTAGE 5 to 48 Vdc COIL POWER 565 mW max. @ 25°C DUTY CYCLE .200 (5.08) DIA GROUND PIN (OPTIONAL) Continuous PICK-UP VOLTAGE OPTIONAL PINS .017+.002 (0.43) DIA -.001 Approximately 50% of nominal coil voltage PICK-UP SENSITIVITY .370 (9.40) DIA MAX ENCLOSURE HEADER 60 mW max. @ 25°C 12 Tyco Electronics Corporation www.tycoelectronics.com 800-522-6752 (U.S.A.) or 717-564-0100 Specifications subject to change. CII and TYCO are trademarks. ©2003 by Tyco Electronics Corporation OPERATING CHARACTERISTICS TIMING ENVIRONMENTAL CHARACTERISTICS TEMPERATURE RANGE SEMICONDUCTOR CHARACTERISTICS DIODE OperateTime: 4.0 ms max. Release Time: MS: 2.0 ms max. MSD/MSDD: 7.5 ms max. (suppression diode, suppression/steering diodes) MST: 7.5 ms max . (transistor driven) CONTACT BOUNCE -65°C to +125°C WEIGHT 100 Vdc peak inverse voltage (PIV) 1.0 Vdc max. transient voltage TRANSISTOR 0.12 oz. (3.40 gms) 0.13 oz. (3.45 gms) with spreader pad attached VIBRATION RESISTANCE TO-5 HIGH-PERFORMANCE RELAYS 30 G’s, 10 to 3,000 Hz SHOCK RESISTANCE 75 G’s, 6 ±1 ms max. QPL APPROVAL 0.3 Vdc min. base turn off voltage 6.0 Vdc min. emitter-base breakdown voltage (BVEBO) @ 25°C 80.0Vdc min. collector-base breakdown voltage (BVCBO) @ 25°C & IC=100 μA 1.5 ms max DIELECTRIC WITHSTANDING VOLTAGE Between Open Contacts: 500 Vrms 60 Hz Between Adjacent Contacts: 500 Vrms 60 Hz Between Contacts & Coil: 500 Vrms 60 Hz INSULATION RESISTANCE MIL-R-39016/11 (JMS) MIL-R-39016/16 (JMSD) MIL-R-39016/21 (JMSDD) MIL-R-28776/3 (JMST) .103 (2.62) .156 (3.96) .014 ±.003 (0.36) .370 (9.40) SQ MAX .100 (2.54) .395 (10.03) SQ MAX .150 (3.81) 0.47 (1.19) DIA 10,000 megohms min. @ 500 Vdc 1,000 megohms @ 500 Vdc (coil to case @ +125°C) .100 (2.54) .100 (2.54) .140 – .175 DIA (3.56 – 4.45) S S2 SPREADER & MOUNTING PADS W COIL DATA NOM. COIL VOLTAGE (Vdc) COIL RESISTANCE IN OHMS ±10% @ 25°C (Note 1) COIL CIRCUIT CURRENT mA (MAX.) (Note 1&2) COIL CIRCUIT CURRENT mA (MIN.) (Note 1&2) PICKUP VOLTAGE Vdc (MAX.) @ 25°C (Note 2) BASE TURN ON CURRENT mA (MAX.) @ 25°C PICKUP VOLTAGE Vdc (MAX.) @ 125°C (Note 2) BASE TURN ON CURRENT mA (MAX.) @ 125°C DROP-OUT VOLTAGE Vdc (MIN.) @ 25°C (Note 2) DROP-OUT VOLTAGE Vdc (MIN.) @ -65°C (Note 2) NOM. COIL POWER (mW) @ 25°C MAX. COIL VOLTAGE COIL DESIG. MS/MSD 5.0 100 6.0 200 9.0 400 12.0 850 18.0 1,600 26.5 3,300 36.0 6,500 48.0 11,000 MSDD 5.0 6.0 9.0 12.0 18.0 26.5 36.0 48.0 MST 5.0 6.0 9.0 12.0 18.0 26.5 36.0 48.0 64 125 400 850 1,600 3,300 6,500 11,000 100 200 400 850 1,600 3,300 6,500 11,000 n/a n/a n/a n/a n/a n/a n/a n/a 78.1 48.9 23.6 15.0 12.2 8.8 6.1 4.8 59.3 35.4 25.8 16.7 13.1 9.5 6.4 5.1 n/a n/a n/a n/a n/a n/a n/a n/a 56.8 36.3 18.1 11.7 9.6 7.0 4.9 3.9 43.5 26.4 19.7 12.2 9.7 6.9 4.8 3.7 2.6 3.4 4.85 7.0 9.8 14.0 20.0 25.8 2.9 4.0 6.1 7.8 11.3 15.2 21.7 27.8 2.8 3.8 5.2 7.4 10.0 14.2 20.0 25.8 n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a 0.37 0.25 0.18 0.12 0.09 0.06 0.034 0.026 3.5 4.5 6.8 9.0 13.5 18.0 27.0 36.0 3.7 4.8 8.0 11.0 14.5 19.0 27.2 34.8 3.6 4.8 7.8 11.0 14.5 19.0 27.0 36.0 n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a n/a 1.50 1.00 0.75 0.47 0.38 0.24 0.17 0.13 0.23 0.28 0.55 0.64 0.92 1.4 1.8 2.4 0.8 0.9 1.1 1.3 1.5 1.7 2.3 2.8 0.22 0.28 0.54 0.63 0.91 1.37 1.80 2.40 0.12 0.18 0.35 0.41 0.59 0.89 1.25 1.60 0.7 0.8 0.9 1.0 1.1 1.3 1.7 2.0 0.14 0.18 0.35 0.41 0.59 0.89 1.25 1.60 250 180 203 169 203 213 199 209 391 288 203 169 203 213 199 209 250 180 203 169 203 213 199 209 7.5 10.0 15.0 20.0 30.0 40.0 57.0 75.0 7.0 10.0 15.0 20.0 30.0 40.0 57.0 75.0 7.0 10.0 15.0 20.0 30.0 40.0 57.0 75.0 5 6 9 12 18 26 36 48 5 6 9 12 18 26 36 48 5 6 9 12 18 26 36 48 Note 1: Coil resistance not directly measurable. Coil current should be within limits shown when tested at nominal voltage at 25°C for 5 seconds max. Note 2: Set base current at 3 mA to 15 mA during measurements. SPECIFYING A PART NUMBER EXAMPLE: TYPE TERMINALS DIODES TRANSISTOR GROUND PINS COILS SPREADER/MOUNTING PADS MS C D G -26 S 13 Tyco Electronics Corporation www.tycoelectronics.com 800-522-6752 (U.S.A.) or 717-564-0100 Specifications subject to change. CII and TYCO are trademarks. ©2003 by Tyco Electronics Corporation