TVB270SA_04

Tyco / Electronics Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 SiBar™ Thyristor Surge Protectors PRODUCT: TVB270SA DOCUMENT: 24305 PCN: 574139 REV LETTER: F REV DATE: AUGUST 24, 2004 PAGE NO.: 1 OF 2 Specification Status: RELEASED PHYSICAL DESCRIPTION Marking: REBB Date Code Device Code A B MIN MAX MIN MAX mm: 4.06 4.57 3.30 3.81 in*: (0.160) (0.180) (0.130) (0.150) C MIN 1.90 (0.075) D** H J K MAX MIN MAX MIN MAX MIN MAX MIN MAX 2.41 1.96 2.11 0.05 0.15 0.15 0.30 0.76 1.27 (0.095) (0.077) (0.083) (0.002) (0.006) (0.006) (0.012) (0.030) (0.050) P S REF MIN MAX mm: 0.51 5.21 5.59 in*: (0.020) (0.205) (0.220) *Rounded off approximation * D DIMENSION SHALL BE MEASURED WITHIN DIMENSION P Other Physical Characteristics Form Factor: Lead Material: Encapsulation Material: Solderability: Solder Heat Withstand: Solvent Resistance: Mechanical Shock: Vibration: Tape and Reel packaging: Agency Recognition: Precedence: CAUTION: Materials Information ELV Compliant SMB (Surface Mount, JEDEC DO-214AA Package) Tin/lead finish Epoxy, meets UL94 V-0 requirements per MIL-STD-750, Method 2026 per MIL-STD-750, Method 2031 per MIL-STD-750, Method 1022 per MIL-STD-750, Method 2016 per MIL-STD-750, Method 2056 per EIA 481-1 UL This specification takes precedence over documents referenced herein. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. © 2004 Tyco Electronics Corporation. All rights reserved. Tyco / Electronics Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 SiBar™ Thyristor Surge Protectors PRODUCT: TVB270SA DOCUMENT: 24305 PCN: 574139 REV LETTER: F REV DATE: AUGUST 24, 2004 PAGE NO.: 2 OF 2 DEVICE RATINGS @ 25º C (Both Polarities) Parameter Repetitive Off-State Voltage, Maximum at ID = 5 µA Non-Repetitive Peak Telcordia GR-1089 CORE 10x1000 µs Impulse Current TIA-968 lightning Type A Metallic 10/560 µs Double exponential TIA-968 lightning Type A Longit. 10/160 µs Waveform Telcordia GR-1089 Intrabuilding 2/10 µs (Notes 1 and 2) IEC61000-4-5 (Voc 1.2/50us) 8/20 µs ITU-T K.20/K.21 (Voc 10/700us) 5/310 µs TIA-968 lightning Type B (Voc 9/720us) 5/320 µs Critical Rate of Rise of On-State Current Powered Pulse Amplifier, C=30µF, V=600V Maximum 2x10 µsec waveform, VOC=750V, ISC=150A peak DEVICE THERMAL RATINGS Storage Temperature Range Operating Temperature Range Blocking or conducting state Overload Junction Temperature Maximum; Conducting state only Maximum Lead Temperature for Soldering Purpose; for 10 seconds Symbol VDM IPP1 IPP2 IPP3 IPP4 IPP5 IPP6 IPP7 Value 270 50 70 100 150 150 90 90 Units V A A A A A A A di/dt di/dt 500 110 A/µs A/µs TSTG TA TJ TL -55 to 150 -40 to 125 +150 +260 ºC ºC ºC ºC ELECTRICAL CHARACTERISTICS Both polarities (TJ @ 25ºC unless otherwise noted) Characteristics Symbol Min Breakover Voltage (+25ºC) VBO ----(dv/dt = 0.4kV/ µsec, Isc=900mA, VDC = 500V (both polarities)) Breakover Voltage Temperature Coefficient dVBO/dTJ ----Off-State Current (VD1= 50V) ID1 ----(VD2=VDM) ID2=IDM ----On-State Voltage (IT=1A) VT ----(PW ≤ 300 µsec, Duty Cycle ≤ 2% (Note 2)) Breakover Current IBO ----Holding Current (Note 2) IH 150 Peak Onstage Surge Current ITSM 22 (Measured @ 60Hz, 1 cycle, 600V) Critical Rate of Rise of Off-State Voltage dv/dt 2000 (Linear waveform, VD = 0.8 X Rated VBO, TJ= +25ºC) Capacitance (f=1.0 Mhz, 50VDC bias, 1Vrms) C1 ----(f=1.0 Mhz, 2VDC bias, 1Vrms) C2 ----Note 1. Allow cooling before test second polarity Note 2. Measured under pulse conditions to reduce heating Typ 310 Max 365 Units V 0.1 ----------------------------15 32 ----2.0 5.0 4.0 800 ----------------- %/ºC µA µA V mA mA A V/µs pF pF VOLTAGE-CURRENT CHARACTERISTIC