115D5HFS

www.make-ps.com E-mail:info@make-ps.com 100HFS series Single & Dual Output DC/DC Converter FEATURES • • • • • • Miniature Single-Inline-Package (SIP) 1000 VDC Input/Output Isolation High Efficiency Wide Operating Temperature Range MTBF > 2,000,000 Hours Low Cost DESCRIPTIONS The 100HFS series is a family of cost effective 1 watt single and dual output DC/DC converters in ultra-miniature SIP packages. 24 models operate from input bus voltages of 5V, 12 and 24V; producing output voltage levels of 5V, 9V, 12V, 15V, ±5, ±9V, ±12V or ±15V. With footprint as little as 0.108 in2, the 100HFS series is ideal for innumerable board level power distribution applications where space is critical. INPUT CHARACTERISTICS Min Typ Input Voltage 5 VDC Input Models 4.5 5 12 VDC Input Models 10.8 12 15 VDC Input Models 13.5 15 24 VDC Input Models 21.6 24 Input Fuse Requirements 5 VDC Input Models 500 12 VDC Input Models 200 15 VDC Input Models 150 24 VDC Input Models 100 Reverse Polarity Input Current Input Filter Max Unit/Comments 5.5 13.2 16.5 26.4 VDC VDC VDC VDC mA; Slow blow type mA; Slow blow type mA; Slow blow type mA; Slow blow type A 0.3 Internal Capacitor OUTPUT CHARACTERISTICS Output Voltage Set Point Output Voltage Balance (Duals) Line Regulation Min Typ Max Unit/Comments ±1.0 ±3.0 % Output voltage at nominal line & FL ±0.1 ±1.0 % Equal Output Loads ±1.2 ±1.5 %; % Change / Percentage change in Input voltage % Output voltage See Model Selection Chart measured from FL to 20% load 100 150 mV p-p, Nom.Line 50 75 @FL, 20MHz B.W., using 1 μf bypass capacitor 200 mV p-p, Over Line, 150 Load & Temp., 20 MHz B.W., using 1 μf bypass capacitor 0.5 Second ±0.01 ±0.02 % per degree C GENERAL CHARACTERISTICS Min Typ Max Unit/Comments Switching Frequency Single Dual Isolation Voltage Isolation Resistance Isolation Capacitance MTBF (MIL-HBK-217F) 50 90 110 kHz 70 100 120 kHz VDC, 1 sec 1100 Mohm, 500VDC 1000 60 100 pF, 100kHz, 1Volt Thousand Hours, 2000 +25oC, Ground Benign Load Regulation Ripple/Noise - Single Dual Ripple/Noise - Single - Dual Short Circuit Protection Temperature Coefficient >> B-5 www.make-ps.com ENVIRONMENTAL SPECIFICATIONS Min Operating Temp. Single Dual Operating Temp. Range Storage Temp. Range Relative Humidity Cooling -40 -40 -25 -40 Typ Max Unit/Comments +75 +85 +90 +125 95 C; Ambient C; Ambient o C; Case o C % Humidity; noncondensing Free-Air Convection o o E-mail:info@make-ps.com PHYSICAL CHARACTERISTICS Unit/Comments Case Size Single: 5 & 12 VDC Input 24 VDC Input Dual: 5 & 12 VDC Input 24 VDC Input Case Material Flammability Weight Single: 5 & 12 VDC Input 24 VDC Input Dual: 5 & 12 VDC Input 24 VDC Input 0.45 X 0.24 X 0.40 inches (11.5 X 6.1 X 10.2 mm) 0.45 X 0.28 X 0.40 inches (11.5 X 7.1 X 10.2 mm) 0.77 X 0.24 X 0.40 inches (19.5 X 6.1 X 10.2 mm) 0.77 X 0.28 X 0.40 inches (19.5 X 7.1 X 10.2 mm) Non-Conductive Black Plastic UL94V-0 1.3 Grams 1.7 Grams 2.2 Grams 2.6 Grams OUTLINE DRAWING SINGLE 0.45 (11.5) DUAL 0.77 (19.5) 0.02 (0.5) SIDE 0.40 (10.2) SIDE 0.010 (0.25) 0.24 (6.1) 5 & 12V Input 1 2 4 5 6 0.010 (0.25) 0.02 (1.3) 1 2 3 4 BOTTOM 0.02 (0.5) PIN OUT CHART Pins 1 2 3 4 5 6 Single - Vin + Vin - Vout + Vout Dual + Vin - Vin - Vout Common + Vout Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 All specifications are typical at nominal input, nominal load and 25° C unless otherwise specified. External, low ESR, 10 microfarad (minimum) capacitor across output is recommended for operation. 0.28 (7.1) 24V Input 0.41 (10.5) 0.07 (1.8) 0.100 (2.54) 0.13 (3.2) 0.08 (1.9) 0.08 (2.1) 0.100 (2.54) 0.200 TYP (5.08) 0.73 (18.5) BOTTOM 0.13 (3.2) 0.40 (10.2) 0.02 (0.5) >> B-6 www.make-ps.com HOW TO ORDER E-mail:info@make-ps.com HOW TO ORDER 1 XX S XX HFS - Y Wattage Output Voltage Output Configuration (S=Single, D=Dual) ROHS Compliant Series Nominal Input Voltage MODEL SELECTION CHART Model 105S5HFS 109S5HFS 112S5HFS 115S5HFS 105D5HFS 109D5HFS 112D5HFS 115D5HFS 105S12HFS 109S12HFS 112S12HFS 115S12HFS 105D12HFS 109D12HFS 109D12HFS 115D12HFS 105S24HFS 109S24HFS 112S24HFS 115S24HFS 105D24HFS 109D24HFS 112D24HFS 115D24HFS Nominal Input Voltage (VDC) 5 5 5 5 5 5 5 5 12 12 12 12 12 12 12 12 24 24 24 24 24 24 24 24 Input Voltage Range (VDC) 4.5 - 5.5 4.5 - 5.5 4.5 - 5.5 4.5 - 5.5 4.5 - 5.5 4.5 - 5.5 4.5 - 5.5 4.5 - 5.5 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 21.6 - 26.4 21.6 - 26.4 21.6 - 26.4 21.6 - 26.4 21.6 - 26.4 21.6 - 26.4 21.6 - 26.4 21.6 - 26.4 Output Voltage (VDC) 5.0 9.0 12.0 15.0 ±5.0 ±9.0 ±12.0 ±15.0 5.0 9.0 12.0 15.0 ±5.0 ±9.0 ±12.0 ±15.0 5.0 9.0 12.0 15.0 ±5.0 ±9.0 ±12.0 ±15.0 Max. Output Current (mA) 200 110 84 67 ±100 ±56 ±42 ±34 200 110 84 67 ±100 ±56 ±42 ±34 200 100 84 67 ±100 ±56 ±42 ±34 Efficiency @ FL (%) 69 76 77 78 72 77 78 79 71 77 79 80 74 79 81 81 70 76 79 79 72 76 79 80 Max. Load Regulation (%) 11 8 7 6 8 8 8 8 9 5 5 4 8 8 8 8 8 5 4 4 8 8 8 8 >> B-7 www.make-ps.com DERATING CURVES E-mail:info@make-ps.com MODEL 100HFS Single - 3.3V, 5V & ±5V Output Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 100LFM Natural Convection 400LFM 200LFM MODEL 100HFS Single - 24V Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 100LFM Natural Convection 200LFM 400LFM 50 60 70 80 90 100 110 50 60 70 80 90 100 110 TEMPERATURE ° C TEMPERATURE ° C MODEL 100HFS Dual - 5V Output Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 100LFM Natural Convection 200LFM 400LFM MODEL 100HFS Dual - all other outputs Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 100LFM 400LFM 200LFM Natural Convection 50 60 70 80 90 100 110 50 60 70 80 90 100 110 TEMPERATURE ° C TEMPERATURE ° C >> B-8