205D24HFS

www.make-ps.com E-mail:info@make-ps.com 200HFS series Single & Dual Output DC/DC Converter FEATURES • • • • • • Miniature Single-Inline-Package (SIP) 1000 VDC Input/Output Isolation High Efficiency Wide Operating Temperature Range MTBF > 2,000,000 Hours Low Cost DESCRIPTIONS The 200HFS series is a family of cost effective 2 watt single and dual output DC/DC converters in ultra-miniature SIP packages. 21 models operate from input bus voltages of 5V, 12 and 24V; producing output voltage levels of 3.3V, 5V,12V, 15V, ±5, ±12V and ±15V for a wide choice. The 200HFS series is ideal for a variety of applications including distributed power systems, mixed analog / digital subsystems, portable test equipment, local power networks and battery backed systems. INPUT CHARACTERISTICS Min Typ Max Input Voltage 5 VDC Input Models 4.5 5 5.5 12 VDC Input Models 10.8 12 13.2 24 VDC Input Models 21.6 24 26.4 Input Fuse Requirements 5 VDC Input Models 1000 12 VDC Input Models 500 24 VDC Input Models 200 Reverse Polarity Input 0.3 Current Input Filter Unit/Comments VDC VDC VDC mA; Slow blow type mA; Slow blow type mA; Slow blow type A Pi Filter OUTPUT CHARACTERISTICS Output Voltage Set Point Output Voltage Balance (Duals) Line Regulation Min Typ Max Unit/Comments ±1.0 ±3.0 % Output voltage at nominal line & FL ±0.1 ±1.0 % Equal Output Loads ±1.2 ±1.5 %; % Change / 1 % change in Input voltage % Output voltage See Model Selection Chart measured from FL to 20% load 100 150 mV p-p, Nom.Line @FL, 20MHz B.W., using 1 μf bypass capacitor 200 mV p-p, Over Line, Load & Temp., 20 MHz B.W., using 1 μf bypass capacitor %Rated Output Load 120 0.5 Second ±0.01 ±0.02 % per degree C GENERAL CHARACTERISTICS Switching Frequency Isolation Voltage Isolation Resistance Isolation Capacitance MTBF (MIL-HBK-217F) Min Typ Max Unit/Comments kHz 50 80 100 VDC, 60 sec 1000 Mohm, 500VDC 1000 80 120 pF, 100kHz, 1Volt Thousand Hours, 2000 +25oC, Ground Benign Load Regulation Ripple/Noise Ripple/Noise Overload Protection Short Circuit Protection Temperature Coefficient >> B-29 www.make-ps.com ENVIRONMENTAL SPECIFICATIONS Operating Temp. Range Operating Temp. Range Storage Temp. Range Relative Humidity Cooling Min -40 -25 -40 Typ Max +70 +90 +125 95 Unit/Comments o C; Ambient o C; Case o C % Humidity; noncondensing Free-Air Convection E-mail:info@make-ps.com PHYSICAL CHARACTERISTICS Case Size Case Material Flammability Weight Unit/Comments 0.77 X 0.30 X 0.40 inches (19.5 X 7.6 X 10.2 mm) Non-Conductive Black Plastic UL94V-0 2.7 Grams OUTLINE DRAWING 0.77 (19.5) SIDE VIEW 0.40 (10.2) 0.13 (3.2) 0.05 (1.3) 0.30 (7.6) 0.09 (2.1) 0.73 (18.5) 0.100 (2.54) BOTTOM VIEW 1 2 4 5 6 0.010 (0.25) 0.02 (0.5) PIN OUT CHART Pins 1 2 4 5 6 Single + Vin - Vin - Vout No Pin + Vout Dual + Vin - Vin -Vout Common + Vout Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 All specifications are typical at nominal input, nominal load and 25° C unless otherwise specified. External, low ESR, 10 microfarad (minimum) capacitor across output is recommended for operation. 0.02 (0.5) >> B-30 www.make-ps.com HOW TO ORDER E-mail:info@make-ps.com HOW TO ORDER 2 XX S XX HFS - Y Wattage Output Voltage Output Configuration (S=Single, D=Dual) ROHS Compliant Series Nominal Input Voltage MODEL SELECTION CHART Model 203S5HFS 205S5HFS 212S5HFS 215S5HFS 205D5HFS 212D5HFS 215D5HFS 203S12HFS 205S12HFS 212S12HFS 215S12HFS 205D12HFS 212D12HFS 215D12HFS 203S24HFS 205S24HFS 212S24HFS 215S24HFS 205D24HFS 212D24HFS 215D24HFS Nominal Input Voltage (VDC) 5 5 5 5 5 5 5 12 12 12 12 12 12 12 24 24 24 24 24 24 24 Output Voltage (VDC) 3.3 5.0 12.0 15.0 ±5.0 ±12.0 ±15.0 3.3 5.0 12.0 15.0 ±5.0 ±12.0 ±15.0 3.3 5.0 12.0 15.0 ±5.0 ±12.0 ±15.0 Max. Output Current (mA) 500 400 165 133 ±200 ±83 ±66 500 400 165 133 ±200 ±83 ±66 500 400 165 133 ±200 ±83 ±66 Input Current @ Max. Load Typ. (mA) 452 526 495 499 519 504 501 185 212 200 200 210 201 200 92 108 101 101 105 102 100 Input Current @ No. Load Typ. (mA) 60 60 60 60 60 60 60 30 30 30 30 30 30 30 15 15 15 15 15 15 15 Efficiency @ FL (%) 73 76 80 80 77 79 79 74 78 82 83 79 82 82 74 77 77 81 79 81 82 Max. Load Regulation (%) 11 11 7 7 10 7 7 8 8 5 5 8 5 5 8 8 8 5 8 5 5 Min. Output Current (mA) 10 8 3 2.5 ±4 ±1.5 ±1 10 8 3 2.5 ±4 ±1.5 ±1 10 8 3 2.5 ±4 ±1.5 ±1 >> B-31 www.make-ps.com DERATING CURVES E-mail:info@make-ps.com MODEL 200HFS Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 400LFM 100LFM 200LFM Natural Convection 50 60 70 80 90 100 110 TEMPERATURE ° C >> B-32