212D12LFR

www.make-ps.com E-mail:info@make-ps.com 200LFR series Single & Dual Output DC/DC Converter FEATURES • • • • • Up to 81 % Efficiency Single and Dual Output, 2 watt converter Available in 5, 12, 24 and 48 VDC Inputs Industry Standard Pinout Short Circuit Protection DESCRIPTIONS The 200LFR series 2 watt power modules are specially designed to provide low output ripple, and tight regulation in a low-profile 16 pin DIP package. The series consists of 28 models with input voltages of 5V, 12V, 24V and 48V, and offers regulated output voltages of 3.3V, 5V, 12V, 15V, ±5V, ±12V and ±15V. The -40oC to +65oC operating temperature range makes it ideal for data communication equipment, mobile battery driven equipment, distributed power systems, telecommunication equipment, mixed analog/digital subsystems, automatic test instrumentation and industrial robot systems. INPUT CHARACTERISTICS Min Input Voltage 5 VDC Input Models 4.5 12 VDC Input Models 9 24 VDC Input Models 18 48 VDC Input Models 36 Input Fuse Requirements 5 VDC Input Models 12 VDC Input Models 24 VDC Input Models 48 VDC Input Models Reverse Polarity Input Current Input Filter Typ Max Unit/Comments 5 12 24 48 1000 500 250 120 1.0 9 18 36 72 VDC VDC VDC VDC mA; Slow blow type mA; Slow blow type mA; Slow blow type mA; Slow blow type Amp Pi Filter OUTPUT CHARACTERISTICS Output Voltage Set Point Output Voltage Balance (Duals) Line Regulation Min Typ Max Unit/Comments ±2.0 % Output voltage at nominal line & FL ±1.0 ±3.0 % Equal Output Loads ±0.2 ±0.5 % Output voltage measured from min. input line to maximum ±0.75 % Output voltage measured from FL to 25% load 75 mV p-p, Over Line, Load & Temp., 20 MHz B.W., using 1 μf bypass capacitor %Rated Output Load 120 Continuous, Automatic Recovery ±0.01 ±0.02 % per degree C GENERAL CHARACTERISTICS Switching Frequency Isolation Voltage Isolation Resistance Isolation Capacitance MTBF (MIL-HBK-217F) Min Typ Max Unit/Comments kHz 300 VDC, 1 minute 1500 Mohm, 500VDC 1000 250 420 pF, 100kHz, 1Volt Million Hours, 1 +25oC, Ground Benign Load Regulation Ripple/Noise Overload Protection Short Circuit Protection Temperature Coefficient >> B-25 www.make-ps.com ENVIRONMENTAL SPECIFICATIONS Operating Temp. Range Storage Temp. Range Relative Humidity Cooling Min -40 -40 Typ Max +65 +125 95 Unit/Comments o C; Ambient o C % Humidity; noncondensing Free-Air Convection E-mail:info@make-ps.com PHYSICAL CHARACTERISTICS Case Size Case Material Flammability Weight Unit/Comments 0.94 X 0.54 X 0.3 inches (23.9 X13.7 X 7.6 mm) Non-Conductive Black Plastic UL94V-0 5.1 Grams OUTLINE DRAWING 0.94 (23.9) SIDE VIEW 0.02 (0.5) 0.3 (7.6) 0.02(0.5) PIN DIA. 6 PLACES 0.15 (3.8) 6 PLACES 2X 0.1(2.5) 1 7 8 0.4 0.54 10.2 13.7 9 BOTTOM VIEW 16 10 PIN OUT CHART Pins 1 7 8 9 10 16 SINGLE - V in NC NC + V out - V out + V in DUAL - Vin NC Common +V out - V out +V in Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 Pin : ±0.002 ±0.05 NC = No Connection All specifications are typical at nominal input, nominal load and 25°C unless otherwise specified. Capacitor mounted close to the power module helps ensure stability of the unit, it is recommended to use a good quality low ESR capacitor of 2.2mF for the 5V input devices, a 1.0mF for the 12V input devices and a 0.47mF for the 24V and 48V devices. >> B-26 www.make-ps.com HOW TO ORDER E-mail:info@make-ps.com HOW TO ORDER 2 15 Wattage Output Voltage Output Configuration (S=Single, D=Dual) D XX LFR - Y ROHS Compliant Series Nominal Input Voltage MODEL SELECTION CHART Model Nominal Input Voltage (VDC) 5 5 5 5 12 12 12 12 24 24 24 24 48 48 48 48 5 5 5 12 12 12 24 24 24 48 48 48 Output Voltage (VDC) 3.3 5 12 15 3.3 5 12 15 3.3 5 12 15 3.3 5 12 15 ±5 ±12 ±15 ±5 ±12 ±15 ±5 ±12 ±15 ±5 ±12 ±15 203V3S5LFR 205S5LFR 212S5LFR 215S5LFR 203V3S12LFR 205S12LFR 212S12LFR 215S12LFR 203V3S24LFR 205S24LFR 212S24LFR 215S24LFR 203V3S48LFR 205S48LFR 212S48LFR 215S48LFR 205D5LFR 212D5LFR 215D5LFR 205D12LFR 212D12LFR 215D12LFR 205D24LFR 212D24LFR 215D24LFR 205D48LFR 212D48LFR 215D48LFR Full Load Output Current (mA) 500 400 167 134 500 400 167 134 500 400 167 134 500 400 167 134 ±200 ±83 ±67 ±200 ±83 ±67 ±200 ±83 ±67 ±200 ±83 ±67 Min Load Output Current (mA) 125 100 42 33 125 100 42 33 125 100 42 33 125 100 42 33 ±50 ±21 ±17 ±50 ±21 ±17 ±50 ±21 ±17 ±50 ±21 ±17 Full Load No Load Input Current Input Current (mA) (mA) 40 40 40 40 20 20 20 20 10 10 10 10 8 8 8 8 40 40 40 20 20 20 10 10 10 8 8 8 471 548 534 582 184 217 209 220 96 109 109 108 108 108 108 108 667 615 598 242 224 226 119 112 110 62 57 57 Efficiency (%) 70 73 75 73 73 77 80 80 72 77 80 81 71 73 79 79 64 69 71 73 78 78 74 78 80 71 77 77 >> B-27 www.make-ps.com DERATING CURVES E-mail:info@make-ps.com MODEL 200LFR Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 100LFM Natural Convection 400LFM 200LFM 50 60 70 80 90 100 110 TEMPERATURE ° C >> B-28