705S12PW

www.make-ps.com E-mail:info@make-ps.com 700PW series FEATURES • • • • • • • Single and Dual Output DC/DC Converter 6 sided Continuous Shielding 10W/In3 Power Density Wide 2:1 Input Voltage Range UL 1950 Approved CSA 22.9-950 Approved VDE / EN 60950 Approved >1,100,000 Hours MTBF DESCRIPTIONS The 700PW series is a family of high density, compact 7.5W DC/DC converter that combine economy with high performance. Eighteen models operate over 2:1 input voltage ranges of 9 to 18, 18 to 36 or 36 to 72VDC; providing single and dual outputs of 5, 12, 15, ±5, ±12 or ±15VDC. Standard features include 1000VDC input/output isolation, efficiency as high as 82%, tight line/load regulation and low output ripple and noise. Continuous short circuit protection and internal filter to reduce reflected ripple current are standard. All models are packaged in compact, low profile 1” X 2” X 0.4” inch metal cases. INPUT CHARACTERISTICS Min Typ Max Unit/Comments Input Voltage Range 12 VDC Input Models 24 VDC Input Models 48 VDC Input Models Input Fuse Requirements 12 VDC Input Models 24 VDC Input Models 48 VDC Input Models Reflected Ripple Current Input Filter 9 18 36 12 24 48 1500 750 500 18 36 72 VDC VDC VDC mA, Slow blow type mA, Slow blow type mA, Slow blow type See Model Selection Guide LC Filter OUTPUT CHARACTERISTICS Output Voltage Accuracy Output Voltage Balance Dual Outputs Line Regulation Single Outputs Dual Outputs Load Regulation Single Outputs Dual Outputs Ripple/Noise 5V Outputs 12V and 15V Outputs Short Circuit Protection Transient Recovery Time Temperature Coefficient Over Voltage Protection Min Typ Max Unit/Comments ±0.5 ±1.0 %; Output voltage at nominal line & FL ±0.5 ±2.0 %; Equal Output Loads ±0.5 % 1 ±1.0 % 1 ±0.2 % ±1.0 % 2 2 GENERAL CHARACTERISTICS Switching Frequency Isolation Voltage Isolation Resistance Isolation Capacitance MTBF (MIL-HBK-217F) Min Typ Max Unit/Comments kHz 100 VDC, 1 minute 1000 Mohm, 500VDC 1000 pF, 100kHz, 1Volt 80 Million Hours, 1.1 +25oC, Ground Benign mV p-p, Nom.Line FL, 20Mhz B.W .using 1 μf bypass capacitor 1 % Vout Continuous, Automatic Recovery 200 μS to within1% error band for 25% step load change ±0.02 % per oC See Model Selection Guide 75 1 2 = % Output voltage measured from min. input line to maximum = Output voltage measured from FL to 10% Load >> B-82 www.make-ps.com ENVIRONMENTAL SPECIFICATIONS Operating Temp. Range Storage Temp. Range Relative Humidity Cooling Min -40 -40 Typ Max +75 +125 95 Unit/Comments o C; Ambient o C % Humidity; noncondensing Free-Air Convection E-mail:info@make-ps.com PHYSICAL CHARACTERISTICS Case Size Case Material Shield Connection 12V and 24V Input Models 48V Input Models Flammability Weight Unit/Comments 1.0 X 2.0 X 0.4 inches (25.5 X 51.0 X 10.2 mm) Coated Metal with NonConductive Base Negative Input, Pin 2 Positive Input, Pin 3 UL94V-0 42.5 Grams OUTLINE DRAWING 0.40 (10.2) 0.40 (10.2) 0.10 (2.54) 3 4 5 + Vout Common - Vout or NC .040± .005 (1.01) DIA. 0.80 (20.3) BOTTOM 1 2 SIDE (50.8) 2.00 +Vin - Vin 0.60 (15.2) 0.40 (10.2) 0.30 MIN. (7.5) 0.40 (10.2) 0.40 (10.2) 1.00 (25.4) PIN OUT CHART Pins Single 1 + Vin 2 - Vin 3 + Vout 4 NC 5 - Vout NC = No Connection Dual + Vin - Vin + Vout Common - Vout Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 All specifications are typical at nominal input, nominal load and 25° C unless otherwise specified. External, low ESR, 10 microfarad (minimum) capacitor across output is recommended for operation. >> B-83 www.make-ps.com HOW TO ORDER E-mail:info@make-ps.com HOW TO ORDER 7 Wattage Output Voltage Output Configuration (S=Single, D=Dual) XX D XX PW Series Nominal Input Voltage MODEL SELECTION CHART Model Nominal Input Voltage (VDC) 12 12 12 12 12 12 24 24 24 24 24 24 48 48 48 48 48 48 Output Voltage (VDC) 5 12 15 ±5 ±12 ±15 5 12 15 ±5 ±12 ±15 5 12 15 ±5 ±12 ±15 Full Load Output Current (mA) 1500 625 500 ±750 ±313 ±250 1500 625 500 ±750 ±313 ±250 1500 625 500 ±750 ±313 ±250 No Load Input Current (mA) 46 46 46 46 46 46 50 50 50 50 50 50 40 40 40 40 40 40 Full Load Input Current (mA) 791 791 791 791 783 783 386 386 386 382 382 382 198 198 198 204 198 198 Reflected Ripple Current (mA) 120 120 120 120 120 120 60 60 60 60 60 60 30 30 30 30 30 30 Output Over Voltage (VDC) 6.8 15 18 ±6.8 ±15 ±18 6.8 15 18 ±6.8 ±15 ±18 6.8 15 18 ±6.8 ±15 ±18 Efficiency @ FL (%) 79 79 79 79 80 80 81 81 81 82 82 82 79 79 79 78 79 79 705S12PW 712S12PW 715S12PW 705D12PW 712D12PW 715D12PW 705S24PW 712S24PW 715S24PW 705D24PW 712D24PW 715D24PW 705S48PW 712S48PW 715S48PW 705D48PW 712D48PW 715D48PW >> B-84